Seismic Anisotropy of Granitic Rocks from a Fracture Stimulation Well at Utah Forge Using Ultrasonic Measurements

For effective fracture stimulation in Enhanced Geothermal Systems (EGS), characterization of subsurface rock elastic properties is essential. Because seismic anisotropy significantly influences hydraulic fracturing, locating and characterizing microseismic events, and forecasting stress trajectories, our research undertakes laboratory experiments to study seismic anisotropy parameters of core samples from the Utah FORGE EGS site. We evaluated two rock samples from well 58-32, at two depths of 2074.16 m (6,805 feet) and 2268.01 m (7,441 feet), respectively. We analyze the mineralogy and classify the shallower rock as syenogranite, and the deeper rock as orthogneiss and monzonite. We cut cylindrical plugs from these two core samples, imaged them by computed tomography (CT) X-ray imaging, and measured their seismic anisotropy using ultrasonic waves at 1 MHz and under varying confining pressures (5-50 MPa) in ambient temperature conditions. With the assumption of the transversely isotropic (TI) medium, we measured three P-wave velocities and two S-wave velocities along different propagation directions to compute the Thomsen anisotropy parameters. Our results showed that the measured seismic velocities of each rock sample increase with increasing effective pressures, a behavior likely caused by closure of microcracks identified in our CT images. We also find that the measured anisotropies are higher at lower effective pressures. The maximum measured anisotropies for P-waves and S-waves are similar to 23% and similar to 20%, respectively. Therefore, we expect in the field operation that anisotropy should increase with increasing pore pressure caused by injection, which could be valuable in future EGS reservoir management and monitoring.