An experimental study on the effect of CO2 laser powers on melting characteristics of clear ice − part I: Horizontal irradiation

Icing phenomenon widely exists in traffic and industrial fields, and causes a lot of safety accidents. Laser deicing technology is a typical high-efficiency and non-contact deicing method. To accurately predict and control the laser-induced ice melting process, an experimental study on melting characteristics of clear ice under horizontal CO2 laser irradiation and natural convection is carried out, with the laser power varied at a range of 20 ∼ 60 W. As resulted, in the first 30 s of the melting process, the melting rate is around 1.2 mm/s at each power. After 30 s, the laser power effect on the melting rate is obviously different, and the maximum melting rate reaches 5.79 mm/s at 50 W. The higher the laser power, the more the ice melts, and the easier the path of melting ice deflects. At 20 W and 50 W, the maximum angles of melting height are 1.14° and 4.18°, respectively. The laser power effect on the maximum melting height is obvious. At 20 W and 50 W, the peaks of maximum melting height are 12.84 mm and 22.59 mm, respectively. The higher the laser power, the larger the volume melting rate of ice, but the greater the energy loss, and it directly influences the energy efficiency. The ice-melting energy efficiency decreases with the increase of laser power. For laser at 20 W and 60 W, the maximum energy efficiency are 81.5 % and 53.2 %, respectively. This study is meaningful for the optimization of laser deicing technology.