Controlling Splat Boundary Network Evolution Towards the Development of Strong and Ductile Cold Sprayed Refractory Metals: The Role of Powder Characteristics

Feedstock powder characteristics such as composition (specific alloying elements and concentrations and impurity levels), microstructure, thickness/composition of surface oxide layers, and particle size distribution play a crucial role in determining the overall mechanical properties of cold sprayed deposits. Herein, we report on two deposits consolidated via cold spray processing from differently-sourced batches of nominally identical elemental refractory powders under identical spraying conditions, which exhibit bending strength and ductility values that differ by more than a factor of two – and with the weakest sample displaying negligible effective ductility. Through chemical, microstructural and micromechanical characterization of both the feedstock powders and cold sprayed deposits, we consider the possible influences of feedstock characteristics on the mechanical performance of cold spray consolidated deposits. It is shown that while differences in interstitial oxygen and hydrogen content may result in differences in the intrinsic yield characteristics of the feedstock material, both feedstocks maintain the ductile behavior required to induce good metallurgical bonding upon impact of optimally sized powder particles. We conclude that the deposits formed from the two feedstock powders are indistinguishable and exhibit high ductility when characterized locally within the relatively undeformed bulk of a single particle or splat. However, the two sprayed deposits show extremely low ductility or brittle behavior when loaded in tension across intersplat boundary domains comprising material that has undergone extensive deformation. In addition, one feedstock incorporates a broader particle size distribution, with a long tail of larger-than-optimal particles. These larger particles are accelerated below the critical impact velocity, resulting in observed imperfect metallurgical bonding at splat interfaces and higher porosity at such intersplat boundaries. This result, combined with the overall differences in the morphology of the intersplat boundary network between the two deposits, explains the difference in macroscopic mechanical behavior. We conclude that accurate control of the powder feedstock particle size distribution is essential for optimizing the mechanical integrity of cold sprayed refractory elements and alloys.