Experimental Study on Improving the Fire Performance of the Concrete Beams with Fe-SMA

The conventional approach to satisfying the fire resistance requirements in designing reinforced concrete (RC) structures is to ensure enough concrete cover depth for the steel reinforcements. The objective is to prevent the temperature of steel reinforcements from rising too quickly. However, excessive concrete cover depth may increase the risk of concrete spalling during a fire and lead to a larger crack width. Fire is a natural heat source that can activate the shape memory effect of iron-based shape memory alloys (Fe-SMA) to generate recovery stress. This study proposes a new active approach for improving the fire performance of RC structures based on the FeSMA. The main objective is to investigate the feasibility of improving the fire performance of RC structures through the recovery stress generated by Fe-SMA under fire. The fire test of nine Fe-SMA RC beams was conducted. The temperature profile in the furnace was similar to ISO834, and the maximum temperature exceeded 800 degrees C. The flexural behavior of the concrete beams reinforced with Fe-SMA during and after the fire was tested. The experimental results demonstrate that the Fe-SMA has great potential in improving the fire performance of RC structures. The mid-span deflection of the Fe-SMA RC beams under fire is significantly lower than the conventional RC beams. The fire resistance of Fe-SMA RC beams increases from 97 min to 133 min at load level 0.3 and from 69 min to 103 min at load level 0.5. The residual deformation of Fe-SMA RC beams reduces from 46.3 mm to 27.6 mm at load level 0.3 and from 34.7 mm to 19.8 mm at load level 0.5. In addition, after 1 h of fire exposure, the Fe-SMA can develop permanent prestress after the beam cools to room temperature, improving the mechanical properties after fire. The residual bearing capacity and residual stiffness of the Fe-SMA RC beams are 21% and 86%-121% higher than the conventional RC beams, respectively. The prestress generated by Fe-SMA after 1 h of fire exposure was estimated using the equivalent section method.