Development of a High Ductility DP Steel Using a Segregation Neutralization Approach: Benchmarked Against a Commercial Dual Phase Steel

Commercial dual-phase steels are typically synonymous with a banded distribution of martensite in their microstructures, which can degrade ductility and increase the anisotropy of mechanical properties. The concept of neutralizing the effect of Mn segregation is employed to change the distribution of martensite to a non-banded distribution. To this end, the ratio of austenite and ferrite stabilizer elements has been changed in the composition of dual-phase steel. Microstructural analysis has been carried out on both hot-rolled (ferrite + pearlite) and heat-treated (ferrite + martensite) microstructures by optical microscope and EBSD, respectively. The microstructural examinations have confirmed the non-banded distribution of second phase and more equiaxed ferrite grains in the segregated neutralized grade microstructures compared to a commercially benchmarked dual-phase steel. Tensile properties of two grades have also been assessed in hot-rolled and heat-treated conditions in RD, TD, and 45 deg tensile directions. In the case of heat-treated condition, total elongation in RD direction has been improved from 20.9 pct in benchmark dual-phase steel to 25.4 pct in segregated neutralized dual-phase steel. Tensile anisotropy results showed a significant difference in tensile strength by tensile direction in benchmark dual-phase steel in both hot-rolled ( 85 MPa) and heat-treated conditions ( 48 MPa), while the corresponding differences for the segregated neutralized grades were 14 and 15 MPa, respectively.