.
Forest wind damage models are typically based on the assumption that windstorm damage results from the interaction between horizontal wind forces and forest stand properties. In complex terrain, mountain waves caused by stably stratified air flowing over mountains can generate standing waves and severe downslope windstorms on the leeward side. Using the windstorm of 19 November 2021 in a mountain valley in southeastern Norway as a case study, we tested two hypotheses:1. Forest stand properties do not significantly contribute to explaining forest damage during a mountain wave event.2. Meteorological variables related to atmospheric stratification, turbulence, and non-horizontal airflow significantly contribute to explaining forest damage during a mountain wave event.To test these hypotheses, we combined forest damage observations with a high-resolution numerical weather prediction model and Random Forest modeling. We used SHapley Additive exPlanations (SHAP) values to quantify the contributions of individual model features. Incorporating forest stand variables did not significantly improve predictive performance, whereas potential temperature gradient, vertical airflow velocity, and wind gust speed, capturing turbulence, did. SHAP analysis showed that although wind gust speed helped explain damage, its influence was secondary to that of potential temperature gradient, which had the strongest explanatory power. The model demonstrated good discriminative power between damage and no damage in the test set. Our findings underscore the limitations of conventional models reliant on horizontal wind speed, highlighting the need for high-resolution numerical weather prediction models that resolve three-dimensional flow in complex terrain, especially during mountain wave events.
Air-sea exchange processes have been identified as essential for both short- and long-term atmospheric and ocean forecasts. The two phases of the fluid layer covering our planet interact across a vast range of scales that we need to explore to achieve a better understanding of the exchange processes. While satellites provide a distributed large-scale view of the sea surface situation, highly detailed measurements, e.g., from oceanographic towers, are necessarily local. The required intermediate solution (i.e., data that are both accurate and distributed) can be provided by swarms of miniature surface buoys. As size, weight, and cost are reduced, these can be deployed in large numbers to investigate specific processes that are at present only crudely parameterized in our models as a result of scarcity of good measurements. Perhaps the most crucial process is white-capping in stormy conditions, where air-sea exchanges are enhanced by one or two orders of magnitude. Other applications include wave-current interactions, wave-ice interactions, and plunging breakers in the coastal zone. Following a dedicated workshop, we summarize here the main findings and possibilities derived from the different approaches, and summarize the state of the art for a selection of miniature buoys. We list the solutions presented at the workshop, as well as other similar buoys, with their main characteristics and range of application. We describe the various possibilities of practical use and the scientific and engineering problems to be solved. Looking to the future, we also point out where the present technological improvements are leading to.
The susceptibility of cloud droplet number to cloud condensation nuclei number is one of the major factors controlling the highly uncertain change in the amount of solar radiation reflected by clouds when aerosol emissions are perturbed (the radiative forcing due to aerosol-cloud interactions). We investigate this susceptibility in low-level stratiform clouds using long-term (3-10-yr) in situ observations of aerosols and clouds at three high-latitude locations. The in situ observations show higher susceptibility for low-level stratiform clouds than values reported for satellite data. We estimate -1.16 W m-2 for the aerosol indirect radiative forcing on the basis of our observations, which is at the higher end of satellite-derived forcing estimates and the uncertainty range of the most recent Intergovernmental Panel on Climate Change report. We evaluate four Earth system models against the observations and find large inter-model variability in the susceptibility. Our results demonstrate that, even if the susceptibility in some of the models is relatively close to observations, the underlying physics in the models is unrealistic when compared with observations. We show that the inter-model variability is driven by differences in sub-grid-scale updraught velocities and aerosol size distributions, raising a need to improve these aspects in models.
The development of large wind turbines and airborne wind energy (AWE) systems requires reliable wind speed datasets at heights above the atmospheric surface layer. Traditional measurement approaches relying on met masts (meteorological masts) fall short of addressing these needs. In this study, we validate three different model-based datasets, namely the 3 km Norwegian Hindcast archive (NORA3), the New European Wind Atlas (NEWA), and ECMWF Reanalysis v5 (ERA5), using Doppler wind lidar data from several locations in Norway and the North Sea. The validation focuses on altitudes from 100 to 500 m above ground, covering the operational range of large wind turbines and AWE systems. Our findings indicate that ERA5 and NORA3 perform similarly well in offshore locations in terms of bias, correlation coefficient, root-mean-square error, and Earth mover's distance. The choice of an appropriate wind speed database depends on the topography, altitude and error metrics of interest. However, NORA3 outperforms the other two models in two coastal sites and one complex-terrain site. In most cases, the agreement between the models and lidar measurements increases with height.
Many countries are actively developing a National Framework for Climate Services (NFCS), driven by a need for better coordination of climate services to support decision making, mandatory climate adaptation and financial reporting, and the assessment of the quality of climate services including their underlying data. A group of five European countries (UK, Ireland, Belgium, Switzerland and Norway) has formed an informal peer-group to support, challenge, and share learning throughout the process of developing and evolving their NFCSs. This perspective article gathers these experiences to distil common themes and challenges as well as to identify unique characteristics and benefits of each country’s experience on their NFCS implementation. While this article focuses on the experiences and practical learning within Europe, the benefit of establishing an NFCS is global, and many of the challenges and learnings presented here will be relevant anywhere in the world.It is the experience of this group that peer support has accelerated and enhanced the NFCS implementation process, as well as provided a forum for exchange on how to maintain and evolve an operational NFCS. Based on this experience, we propose an additional step as part of the WMO’s ‘Step-by-step Guidelines for Establishing a National Framework for Climate Services’ (WMO, 2018) to support countries to maintain and evolve their operational frameworks. Additionally, we recommend regional or global peer support on this framework development process should be sought, encouraged and facilitated.