
In this study, a highly sensitive and selective immunoassay based on three-dimensional MnO2@Pt nanozyme for the broad-spectrum detection of multiple fluoroquinolones (FQs) residue was designed. The assay utilises the in-situ reduction of platinum nanoparticles (PtNPs) onto three-dimensional MnO2 nanoflowers (MnO2 NFs), which act as a robust scaffold due to their large specific surface area and abundant spatial sites. This hierarchical nanostructure not only enhances the deposition efficiency of PtNPs but also substantially amplifies the colorimetric signal, enabling precise quantification of FQs. Using norfloxacin (NOR) as a model analyte, the assay exhibits a broad linear detection range (0.035–64.0 μg L−1) and achieves an exceptionally low limit of detection (LOD) of 0.016 μg L−1. The reliability of assay is confirmed by comparing NOR recovery rates in animal-derived food samples with those obtained via HPLC, demonstrating good consistency. Notably, this approach offers significant advantages over conventional ELISA including an LOD 13 times lower than that of the ELISA using HRP (LOD = 0.21 μg L−1). These results highlight the potential of PtNPs@MnO2 NFs-based immunoassay strategy platforms as rapid, cost-effective, and ultra-sensitive tools for monitoring FQs residues in food safety applications.
The focus of this work was the characterisation of an impurity sometimes found in batches of the hydroxyxanthene colour additives D&C Red No. 27 (R27) and D&C Red No. 28 (R28, phloxine B). Countercurrent chromatography (CCC) was used to separate and concentrate the impurity (named here pHXCA) to similar to 48% from a dye sample that contained similar to 0.74% pHXCA. Pure pHXCA was obtained by collecting analytical HPLC-separated fractions from multiple injections of the CCC-concentrated sample. Various NMR and mass spectral techniques were used to determine the structure of pHXCA. In particular, the presence of a 35/37Cl isotope shift in the 13C NMR spectrum pointed to the location of the C-Cl bond specific to pHXCA and facilitated identification of its structure as 1-carboxy-7-bromo-6-hydroxy-2,3,4,5-tetrachloroxanthone. Significantly, that structure was different from the one erroneously reported by other researchers. A rapid screening of 18 dye batches (R27, n = 13; R28, n = 5) representing nine manufacturers, revealed that 12 batches contained pHXCA, with levels that ranged from 0.0009 to 0.182%. A side reaction during the manufacture of R27/28 in which a bromine atom is replaced with a chlorine atom in a closely related contaminant is suggested as the potential basis of pHXCA formation.
Perchlorate and chlorate are environmental contaminants that competitively inhibit thyroidal iodide uptake, posing health risks particularly for vulnerable populations. This study developed an isotope dilution UPLC-MS/MS method to determine perchlorate and chlorate levels in 346 samples (vegetables, fruits, eggs, and drinking water) collected from Shenzhen. Probabilistic dietary exposure assessment was conducted across 11 age-gender groups using Monte Carlo simulation (10,000 iterations) with local consumption data (n = 853). Perchlorate was detected in 94% of samples (mean = 16.1 mu g/kg), with leafy vegetables (78.5 mu g/kg) and eggs (32.0 mu g/kg) showing the highest mean levels; chlorate was detected in 45% of samples, whilst drinking water had a 100% detection rate and the highest concentrations (mean = 53.5 mu g/L). Males aged 4-14 years had the highest 95th percentile perchlorate estimated daily intake (EDI) (1.19 mu g/kg bw/day), with 4.0% exceeding the EFSA tolerable daily intake (TDI). For chlorate, the highest 95th percentile EDI was observed in the 0-3 years old group (14.8 mu g/kg bw/day), with 55.2% exceeding the TDI under the lower bound scenario. Sensitivity analysis identified perchlorate concentration in leafy vegetables and drinking water intake as the key drivers of perchlorate and chlorate exposure, respectively. These findings indicate widespread contamination and notable health risks for children, supporting the need for regulatory measures to reduce chlorate in drinking water and monitor perchlorate in leafy vegetables and eggs.
In recent years, the United States Food and Drug Administration (US FDA) has documented several instances where more abundant, and lower priced, jumbo squid (Dosidicus gigas) has been substituted for octopus (family Octopodidae) in a variety of products (e.g. frozen, canned) resulting in the products being misbranded and/or adulterated. FDA typically utilises a short (approx. 655 base pair) fragment of the cytochrome c oxidase subunit 1 (COI) mitochondrial gene (a.k.a. DNA barcoding) for the identification of seafood products. However, this method is not applicable for the identification of canned products due to DNA fragmentation that occurs during the retort process. Described herein is a modified DNA barcoding method using standard DNA marine invertebrate barcoding primers in combination with degenerate forward and reverse internal primers to create two smaller (313-316 base pair) fragments. The fragments are sequenced separately then assembled to form a nearly full-length DNA barcode fragment. Using this method, 11 of the 12 canned jumbo squid and octopus products tested, in a variety of forms (i.e. in hot sauce, in garlic sauce, smoked, etc.), were successfully identified. This method is fit for the purpose of ad hoc regulatory identification of canned squid and octopus products to confirm product labelling or to be used as a screening tool to prevent species substitution, economic adulteration, and fraud.