
Livestock manure management is a major source of NH3 and greenhouse gas emissions, representing a critical environmental challenge for intensive animal production systems. Although slurry acidification is a well-established technique for reducing gaseous emissions, most studies have focused on one-time applications targeting pH values between 5.0 and 6.0. In contrast, the effectiveness and acid requirements of continuous acidification at low pH throughout storage have not been comprehensively evaluated. The aim of this work is to evaluate the effectiveness of a continuous acidification strategy -maintaining a target pH of 5.0- combined with solid-liquid separation, and to assess its effects on slurry physicochemical composition, gaseous emissions, and acid consumption. A controlled experiment was conducted with raw and separated slurry samples where sulphuric acid was applied with weekly adjustments to maintain the target pH. Gaseous emissions were quantified using open dynamic (NH3 and CO2) and closed static chamber (CH4) techniques. Results demonstrated that the adopted approach achieved a near-complete abatement of NH3 emissions (97%–100%) and full suppression of CH4 emissions. CO2 emissions were significantly reduced by 36%–80% depending on slurry type and experimental week. Furthermore, the treatment enhanced nitrogen retention, preventing a 40%–44% loss of total ammoniacal nitrogen and total Kjeldahl nitrogen observed in the non-acidified slurry, while organic matter degradation was inhibited. These findings identify continuous low-pH acidification as a promising approach that warrants further investigation in both controlled environments and real-farm conditions to fully assess its effectiveness and evaluate its technical and economic feasibility.
Appropriate backwashing rates are essential to maintain sand media filter performance, as they enable the effective removal of retained impurities without compromising the integrity of the filter bed. This study evaluated the relationship between backwashing rate, bed expansion, and solids removal efficiency in a pressurised sand filter prototype, aiming to identify an optimal operational backwashing range and assess the applicability of the conventional 25% bed expansion criterion. Experimental results indicated that maximum solids removal occurs before the bed reaches 25% expansion, and that rates above 160 m3 m−2 h−1 result in substantial loss of filter material. A backwashing rate range of 52.90-88.17 m3 m−2 h−1 was identified as the optimal operational range, considering solids removal efficiency, filter bed expansion, and water consumption. Within this range, solids removal efficiency reached approximately 99.8% at 88.17 m3 m−2 h−1, with negligible additional improvements at higher backwashing rates. The comparison between the commercial filter and the sand filter prototype demonstrated similar behaviour up to 140 m3 m−2 h−1, indicating that the values obtained with the prototype can be extrapolated to applications in commercial filters. These findings offer the opportunity to establish more accurate guidelines for determining backwashing rates in sand media filters. While the results are most representative of the tested prototype and sand media characteristics, the proposed methodology provides a basis for future studies involving different filter media and filter configurations to further refine and generalise these findings.