
Scots pine (Pinus sylvestris L.) is an economically important conifer; however, its in vitro application is limited by rapid callus browning and loss of morphogenic potential. This study aimed to overcome these limitations by optimizing the basal medium, plant growth regulators, and antioxidant and organic supplementation. Seeds were germinated on half-strength Murashige and Skoog (½ MS) medium supplemented with 50 mg·L−1 gibberellic acid (GA3). Callus formation was initiated from cotyledons and hypocotyls of 3-week-old seedlings. Gamborg (B5) medium was unsuitable, causing rapid browning and necrosis. The most effective medium for prolonged proliferation (up to four weeks without subculturing) consisted of ½ MS supplemented with 3 mg·L−1 2,4-dichlorophenoxyacetic acid (2,4-D), 0.8 mg·L−1 6-benzylaminopurine (BAP), 500 mg·L−1 casein hydrolysate, 500 mg·L−1 L-glutamine, 200 mg·L−1 ascorbic acid, 5 mg·L−1 sodium diethyldithiocarbamate (Na-DDC), and 20 g·L−1 sucrose. This medium extended callus viability to four weeks, markedly reduced browning, and induced morphogenesis. Upon transfer to shoot-inducing medium (½ MS supplemented with 3 mg·L−1 BAP, 0.1 mg·L−1 α-naphthaleneacetic acid (NAA), and the same additives), 57.8 ± 1.4% of calli with green foci produced shoots. These results provide a basis for prolonged callus cultivation and shoot organogenesis in Scots pine. Rooting and acclimatization were not evaluated and remain to be optimized.
Interpreting plant-growth responses across diverse light-emitting diode (LED) experiments requires attention to differences in species, lighting conditions, measurements, and experimental design. This study combines a descriptive comparison of six public LED-growth resources with an explainable Light Gradient Boosting Machine (LightGBM 4.6.0) case study. The resources cover sweet pepper, lettuce, soybean, Arabidopsis, European yew, and ornamental plants; regression modeling and SHapley Additive exPlanations (SHAP 0.50.0) analysis were conducted only on sweet pepper. Of 144 original observations, 71 complete records were retained for dry-biomass prediction. On the original held-out test set, LightGBM Model A outperformed ridge regression (R2 = 0.755 versus 0.460; RMSE = 0.136 versus 0.216 g; MAE = 0.104 versus 0.185 g). However, leave-one-temporal-replicate-out cross-validation favored ridge regression (mean R2 = 0.600 ± 0.191) over LightGBM (0.078 ± 0.248). Excluding instrument gain and additional harvest-related predictors reduced LightGBM R2 to 0.111. SHAP ranked chlorophyll-fluorimeter gain and LED treatment highest in Model A, whereas LED treatment and initial plant height led Model B. The resource comparison identifies challenges in comparing lighting treatments and growth measurements, while the case study demonstrates sensitivity to predictor availability and validation design. Together, these findings clarify the requirements for applying explainable LightGBM to diverse LED experiments without establishing cross-species predictive generalizability or causal lighting effects.
Seed priming with nanoparticles has emerged as a promising strategy to enhance seed performance under abiotic stress; however, phytotoxic effects remain poorly understood. This study evaluated the effects of zinc oxide (ZnO) nanopriming on the physical and physiological quality of tomato seeds (Solanum lycopersicum L.) exposed to water deficit (−0.3 MPa) and thermal stress (25 and 35 °C). Seeds were subjected to three treatments: non-primed control, osmopriming with polyethylene glycol (PEG), and PEG combined with ZnO nanoparticles. Water deficit reduced germination from 81% to 13% at 25 °C and from 68% to 4% at 35 °C, regardless of priming treatments. PEG-treated seeds exhibited greater seedling development, with root length reaching 14.1 mm, whereas ZnO-treated seeds showed reduced root growth (6.4 mm) and lower vigor indices. X-ray image analysis revealed higher internal tissue integrity in primed seeds, with more than double the density observed in the control. Conversely, nanopriming with ZnO at the tested concentration induced phytotoxic effects, compromising seedling growth and failing to mitigate water and thermal stress. Overall, osmopriming with PEG proved effective in enhancing seed vigor and stress tolerance, whereas ZnO nanopriming impaired physiological performance under the evaluated conditions.
Soil salinity is a major abiotic stress that adversely affects plant growth, root development, water relations and photosynthetic performance. Beneficial rhizobia may contribute to improved plant growth and physiological functioning under saline conditions. Here, we evaluated the morphological and physiological responses of soybean (Glycine max L. Merr.) inoculated with Bradyrhizobium japonicum under saline soil conditions. Ten soybean genotypes, comprising five local breeding lines (BK-104, BK-85, Gen-2, Gen-15 and K4230) and five international varieties (Chukurova, Slavia, Fortuna, Kanada and Opus), were grown in saline soil collected from the Surkhandaryo Region of Uzbekistan. Seeds were inoculated with B. japonicum and cultivated in pots with five replicates. Forty-five days after sowing, root morphological traits and physiological characteristics were assessed. Root traits and physiological parameters, including photosynthetic pigments, water relations and gas exchange, were assessed. Significant genotype-dependent variation was observed across morphological and physiological traits (p < 0.05). Inoculated Chukurova showed a high root surface area (6.06 cm2) and root projected area (1.93 cm2), whereas Gen-2 exhibited the greatest total root length (51.64 cm). K4230 and Gen-2 showed comparatively high plant growth and biomass responses. Physiological traits also varied substantially among genotypes, indicating differential responses to saline conditions. These findings demonstrate phenotypic variation among soybean genotypes under salinity.
White onion (Allium fistulosum L.) is a major source of income for smallholders in the Ecuadorian Andes, where fungal root and foliar diseases reduce yield and commercial quality and are controlled mainly with single-site fungicides. We evaluated the in vitro sensitivity of four fungal isolates (Fusarium sp. SFCBDMR.01, Penicillium sp. SFCBDMR.24, Alternaria sp. SFCBDMF.04, and Ulocladium sp. SFCBDMR.13) obtained from symptomatic white onion in Santa Fe de Galán, Ecuador, and pathogenic on this host (Koch’s postulates), to the demethylation inhibitors (DMIs) tebuconazole and mefentrifluconazole, the quinone outside inhibitors (QoIs) pyraclostrobin and azoxystrobin, and the methyl benzimidazole carbamates (MBCs) thiophanate-methyl and thiabendazole, incorporated into potato dextrose agar at 0–500 µg mL−1. Sensitivity was quantified as the mycelial growth rate and the median effective concentration (EC50), estimated using a three-parameter log-logistic model. Tebuconazole was highly active against Fusarium sp. (EC50 = 0.24 µg mL−1) and Penicillium sp. (EC50 < 0.1 µg mL−1) and moderately active against Alternaria sp. (7.41 µg mL−1); mefentrifluconazole was highly active against Alternaria sp. and Ulocladium sp., and thiabendazole against Ulocladium sp. (EC50 < 0.1 µg mL−1). The QoIs and thiophanate-methyl did not halve the mycelial growth of most isolates (EC50 > 500 µg mL−1), except Alternaria sp. with pyraclostrobin (36.0 µg mL−1) and Penicillium sp. with azoxystrobin, which showed a concentration-independent inhibition plateau of 61–64%. Responses were specific to each isolate–active ingredient combination, even within a FRAC group. Because one isolate per genus was tested and no baseline population was available, these values describe phenotypic sensitivity rather than resistance. They are, to our knowledge, the first fungicide sensitivity reference values for fungi associated with white onion in Ecuador and provide a basis for selecting active ingredients and for future resistance monitoring in this crop.