
In general, the outgoing exhaust gasses are released to atmosphere at over temperature of the dew point of water vapor in waste gases. It is well known that recovering a portion of the waste heat enhances the efficiency of boilers and provides fuel savings. In this study, the potential of recovering waste heat emitted by the hot water boiler chimney in a central heating plant of the selected university was investigated. Energy losses were calculated for six months that the central heating system was in full-load operation. As a result of the calculation, it was determined that recovery of the waste heat can be employed as a combustion air preheater by means of a recuperator. It was stated that 53768 m 3 of natural gas savings per year (44.86 TOE/year) can be achieved with the suggested system.
This study is carried out to assess the relative efficiencies of the Anatolian high schools in Izmir /Turkey and to guide inefficient educational institutions to become efficient. Firstly, efficiency measurement is performed by data envelopment analysis (DEA) model. Instead of assigning equal weights to the input and output variables, the analysis is repeated by assigning weights with the aid of the analytic hierarchy process(AHP) model. 3 input and 3 output variables are determined in the study and 47 Anatolian High Schools are analyzed. In Izmir, this study is important since it is the first study to assess the efficiencies of Anatolian high schools with data envelopment analytic hierarchy process (DEAHP) integrated model.
Simultaneous Localization and Mapping (SLAM) problem is a very popular research area in robotic applications. EKF-SLAM and FastSLAM are widely used algorithms for SLAM problem. The greatest advantage of FastSLAM over EKF-SLAM is that it reduces the quadratic complexity of EKF-SLAM. On the other hand, increasing number of estimated landmarks naturally slows down the operation of FastSLAM. In this paper, we propose a new method called as Intelligent Data Association-SLAM (IDA-SLAM) which reduces this slowing down problem. In data association step also known as likelihood estimation, IDA-SLAM skips comparing a new landmark with all of the pre-calculated landmarks. Instead of this, it compares the newly found one with only nearby landmarks that was found previously. The simulation results indicate that the proposed algorithm significantly speeds up the operation of SLAM without a loss of state estimation accuracy. Real world experiments which have been performed in two different scenarios verify the simulation results. A runtime reduction of 43% and 52% is observed respectively for each of the test environments.
3D printed polymer composites are gaining more interest due to weight reduction and high geometrical complexity freedom especially for highly demanding applications such as aerospace and defense.Using the material-extrusion based processes, polymer matrix composite parts with complex geometries can be designed and realized to improve the mechanical properties of pure thermoplastic parts.However, in addition to porosity found at the fracture interfaces, the layered nature additive manufacturing processes may become a limitation for the direct replacement for functional applications.In this study, the results of Charpy impact testing of chopped carbon fiber reinforced nylon fabricated by fused filament fabrication (FFF) are reported.The effects of the build direction and customized density by different infill strategies on the obtained toughness are presented in comparison to the one of nylon without any reinforcement.The toughness results show a severe anisotropy in toughness and high dependence on the infill strategy.
Under repeated loads, stress-strain and strength properties of soils play an important role in solving the engineering problems.The resistance of a material is defined by the slope of the initial part of stress-strain curve.However, this value changes due to cyclic loading and decreases cycle by cycle.As a result, deformations occur on the ground and resulting structural damage.Engineering properties of soils (such as modulus and damping properties of soil, shear wave velocity, unit weight etc..) must be known to minimize the effects of earthquakes.Another important parameter is the frequency content of earthquakes which directly affects the wave propagation through the soil.In this study, the effects of frequencies, obtained from different earthquakes, on the dynamic characteristics of the soil have been investigated.A dynamic triaxial test set has been used to examine the dynamic properties of soils.The variation of dynamic properties of sand samples under the experimental conditions has been determined for regular and irregular loading types.