• 学术搜索
  • 科研智能体
    • Research Labs
    • AI 阅读
    • AI 文库
    • 深度研究
    • 学者亮点
  • 学术资源
    • AI2000
    • 期刊/会议
    • 学者库
    • 学术API
      MCP&Skill
    • 溯源树
    • 数据集
  • 知识沉淀
    • 学术空间
订阅小程序
旧版功能
aminer vip
开通会员低至0.73元/天
一次搞定AI科研
立即登录
  • English
  • 联系方式
    Ceramurgia International

    Ceramurgia International

    JournalISSN 0390-5519

    年发文量

    研究主题

    论文(179)

    排序
    1The Preparation and Properties of Strontium Zirconate Ceramics for Channels of Open-Cycle MHD Generators
    M. Zborowska,M. Grylicki,J. Zborowski

    A two-stage procedure of preparation of dense strontium zirconate ceramics capable of being used as electrically insulating material in MHD generators is described. A small addition of TiO2 was introduced at the first stage to favour development of the properties, especially low apparent porosity, required for MHD purposes. The effect of TiO2 on sintering temperature, phase composition and microstructure of the bodies is described. Properties of the resulting ceramics i.e. porosity, cold crushing strength, microhardness as well as electrical conductivity over the temperature range of 20–2000°C were measured. The results of successful testing of these ceramics in the channel of an experimental MHD generator are presented.

    1980引用:7
    引用
    AI阅读
    加入学术空间
    2Interaction Between Creep, Oxidation and Microporosity in Reaction-Bonded Silicon Nitride
    G. Grathwohl,F. Thümmler

    Kinetic studies have been performed on primary and secondary (minimal) creep of reaction-bonded silicon nitride in 4-pt-bending tests up to 1500°C. The creep deformation depends strongly on the extent of internal oxidation. In spite of the very marked dependence of the creep rate on material and pretreatment parameters, the stress exponents (n = 1.7–1.8) and activation energies (360–390 kJ/mole) are hardly influenced, suggesting similar creep mechanism. Creep deformation is provided by relative motion and separation of grain boundaries. Oxidation and deformation lead to remarkable changes of the pore size distribution; the creep processes are accompanied by deformation of the pores. The creep rupture strain is very limited in highly creep resistant materials and vice versa. Methods for the determination of oxidation products and oxide profiles along sample cross section have been developed and the chemical changes which the material can undergo during creep are outlined.

    1980引用:15
    引用
    AI阅读
    加入学术空间
    3Young's Modulus of Silicon Nitride Hot Pressed with Ceria Additions
    G. De Portu,P. Vincenzini

    Possible relationships between Young's modulus at room temperature of (1–20) wt% CeO2-fluxed HPSN and some microstructural features such as amount of the intergranular phase, porosity, α/β ratio and crystallographic β texture have been investigated. The dependence of Young's modulus on amount of integranular phase expressed in terms of the Cohen-Ishai model resulted in the relation: E = 98.0 [1 + VN(1.45 − VN13)] GN/m2. A quadratic relationship, E = 290.0 (1 — AP + BP2), proved the most adequate to account for the effect of porosity on Young's modulus over the 0–36% porosity range. αβ ratio and β texture did not seem to have an appreciable effect.

    1980引用:7
    引用
    AI阅读
    加入学术空间
    4High-pressure Sintering of Silicon Nitride
    M. Shibata, N. Kinomura, M. Koizumi
    1980引用:1
    引用
    AI阅读
    加入学术空间
    5Kinetics of the Thermal Decomposition of Kyanite
    H. Schneider,A. Majdič

    The kinetics of the solid state high-temperature transformation of kyanite (Al2SiO5Al2O3·SiO2) powders (≤40 μm) to 3:2-mullite (3Al2O3·2SiO2) and silica (SiO2 were investigated by means of quantitative X-ray diffraction techniques. The transformation interval was found to lie between about 1150 and 1350°C. The reaction law best fitting the kinetic data is: 1-α = kta. The transformation is believed to be reconstructive, with decomposition of the kyanite structure, solid-state atom diffusion, and (epitactic) rearrangement of mullite and cristobalite. Cristobalite represents part of the ⪡free⪢ silica, the rest being present as a glassy phase. Addition of Fe2O3 and TiO2 to the starting material exerts a marked decrease of the transformation temperature, with TiO2 having a somewhat stronger influence than Fe2O3. The reason may be an oxide-catalyzed reaction; the decomposition begins at nuclei formed at the surfaces of the kyanite particles, which are coated with thin layers of hematite and rutile respectively.

    1980引用:14
    引用
    AI阅读
    加入学术空间
    立即登录,查看全部 179 篇论文

    高被引作者

    作者引用发文
    Krzysztof Haberko1814
    Subhash Singhal1561
    D. P. H. Hasselman1194
    J.G.J. Peelen1102
    K. de Groot891
    Bv Rejda891
    William David Kingery884
    J. D. Hong791
    M.H. Hon791
    Robert Davis791

    高产作者

    作者引用发文
    P. Vincenzini629
    Roman Pampuch475
    D. P. H. Hasselman1194
    Yoko Suyama594
    William David Kingery884
    Krzysztof Haberko1814
    Alida Bellosi354
    GN BABINI283
    Giorgio Sloccari353
    AF HENRIKSEN563

    相关期刊

    China's Refractories
    Ceramic Engineering and Science Proceedings
    International Journal of High Technology Ceramics
    Journal of the Ceramic Association, Japan