
The unique baking properties of wheat have contributed to the large variety of food products made of wheat. Wheat products are immensely popular, which is reflected in their ubiquitous consumption. Concerning wheat quality, a main challenge for intense growing strategies is to adapt wheat plants of unaltered yield and baking quality to decreased nitrogen input, which will limit unwanted nitrogen leaching into drinking water and safe resources. A probably more important challenge for wheat adaptation will be caused by global climate change. For a relative small percentage of the human population wheat grain proteins can cause a number of serious diseases including coeliac disease. Susceptible persons often have to completely avoid wheat, as well as rye and barley products. Methods for detection of gluten protein are well advanced, increasing safety for patients. Wheat breeding using traditional breeding and modern genome editing approaches are seen to be necessary to develop new wheat cultivars for adaptation to new environmental conditions caused by climate change, reduced nitrogen input and increased production efficiency, as well as reduction of disease potential. Wheat grain protein analytical methods are important, e.g. for determination of quality parameters and for decision making in breeding programmes. Aspects of protein extraction, proteomic analysis and database coverage of wheat protein sequences are discussed.
Pelargonium acetosum L’Her. is a wild species from South Africa with decorative bluish foliage. Only few reports describe crossings between P. acetosum and P. peltatum L’Her. (or P. ×peltatum). Therefore, information about hybridization barriers is limited. In this study, two different genotypes of Pelargonium acetosum (AC1 and AC2) were crossed with the diploid P. ×peltatum ‘Tornado Fuchsia’ (PTF). Embryos and F1 hybrids from the combination AC1 × PTF were hampered by chlorophyll deficiencies. Embryos and seeds of the combination AC2 × PTF were underdeveloped. The reciprocal combination PTF × AC1 did not show any fruit set. The combination PTF × AC2 resulted in low numbers of seeds, which were normally developed. Hybrids from seeds were only obtained from the combinations AC1 × PTF and PTF × AC2. Embryo rescue of the combinations AC1 × PTF and AC2 × PTF resulted in few but viable hybrids. Flowers of all hybrids had shrivelled anthers and proved to be sterile. The occurrence of most hybridization barriers varied strongly between the different combinations and depended on both the genotype and the direction of cross-breeding. The bluish leaf colour did not appear among the F1. To overcome hybrid sterility a polyploidization is suggested.
The aim of this study was to evaluate nutrient contents and heavy metals of the leaves and berries of vine cultivar ‘Regent’ grafted on different rootstocks (‘Couderc 161-49’, ‘Sori’, ‘Kober 125AA’, ‘Borner’ and ‘Kober 5BB’) in comparison to control (‘Regent’ root; own-rooted vines). Leaf and berry samples were collected in three consecutive years (2013-2015) at the research station of West Pomeranian University of Technology Szczecin in Poland. In the experiment, Ca, Cu, Fe, K, Mg, Mn, N, P and Zn were analysed among mineral nutrients, whereas Cd and Pb were analysed among heavy metals. A substantial influence of tested rootstocks on analysed element contents in leaves and berries has been proven. All tested rootstocks enabled a higher concentration of Ca and Mg in leaves in comparison to ‘Regent’ root. The greatest concentrations of Ca, K and N were found in leaves and berries under ‘Sori’ rootstock. As the only rootstock, ‘Couderc 161-49’ was characterised by a higher level of iron in samples in relation to own-rooted vines. The ‘Borner’ rootstock was the most effective in inhibition of heavy metals uptake.