
Firefighter injures caused by burns and thermal stress occupies around 5%-10% of the total injuries annually. Glove is the thinnest/weakest components among the firefighter turnout gear, which can put firefighters, are at risk of severe wrist and hand burns during fire calls. Burns can occur quickly and enhancing the thermal protective performance of firefighters' gloves will prevent these burns. One-dimensional (1D) heat transfer modeling and simulations were performed through the COMSOL Multiphysics software to investigate the improvement of thermal protective performance when integrating a Phase Change Material (PCM) layer into a conventional structural firefighting glove. Parametric studies were conducted to explore the effects of PCM thermal properties, layer thickness, and location in glove structure on hand protection. It was found that a PCM with a higher density, specific heat, and latent heat of fusion had a larger heat capacity and thermal inertia, resulting in better thermal protective performance. The optimum melting point of PCM was found to be in the range of 80°C-140°C. A PCM layer with a thickness of 0.5 mm-1.0 mm showed sufficient thermal protection. The location of the PCM layer should be close to the inner glove surface for high-heat situations. Overall, modeling suggests that the addition of a PCM layer could significantly enhance the thermal protective performance of firefighters' gloves, with results showing increased time (2-4 times as long) for skin to reach second-degree burn temperature when compared to the conventional glove without PCM.
Aim/Background: In the studies conducted with laboratory animals, using wood shavings as cage nesting material may have an impact on study results. However, there is not sufficient information on the effects on lungs due to using wood shavings. We have aimed to radiologically and histopathologically examine possible lung pathologies, which can be seen on laboratory animals in which wooden shavings are used as filling materials. Method: In this study, 20 male Sprague Dawley rats have been divided into two groups and put into the cages one by one with and without filling materials. At the beginning and end of the four-week monitoring process, their lung radiographies have been taken. Additionally, their lung tissues have been histopathologically examined at the end of the study, and ion chromatography and gas chromatography mass spectrometry analyses were performed. Results: Pneumonia-like findings were detected in the lungs of animals in cages where wooden shavings are used, and diagnosis has been confirmed histopathologically. Chlorate has been detected both in lungs of animals for which pathology has formerly been detected and in wooden shavings used; 2,2'-methylenebis[6-(1,1-dimethylethyl)-4-methyl has also been detected in wood shavings and pathological lungs. Conclusions: Detected chemicals may contribute to the lung pathology, which is seen on animals in which wooden shavings are used as filling material. It was concluded that avoiding wooden shavings as filling material in the experimental studies conducted with laboratory animals is going to be more reasonable in terms of reliability of results and health of animals.
Aims School-based research involves a multi-level process to ensure recruitment of an adequate and reliable sample. The aim of this study is to present the experience of school recruitment of the DEMOCOPHES study in Cyprus. Moreover, methods and strategies to improve recruitment rates are described. Methods The target population of the DEMOCOPHES study was children aged 6-11 years old and their mothers. Cyprus was required to recruit 60 children and their mothers. Random selection of the schools was followed. The information material was provided to the teacher of the selected classes who subsequently distributed it to the children. Personal follow-up contact via telephone call was made with the parents living in the rural areas only. Results Twenty one percent eligibility and consent rate for participation was reached. In schools where parents were followed-up by telephone calls, the response rate was significantly higher compared to those not followed-up by reminders (58% vs 42%, p< 0.05). Conclusions Despite the limitations of applicability and representativity, school-based recruitment has been shown to be a feasible and reliable strategy. It is an attractive approach of enrolling young populations into epidemiological studies. Follow-up reminders via telephone calls significantly increased the response rate.
Aim: To quantify risks associated with exposure to dental amalgam mercury resulting from aerosolization during and following dental fillings removal procedures performed by dental professional over a lifetime of professional practice. Methods: A computational fluid dynamics model was generated using particle size, density, and compositional data obtained from in-vitro aerosolization experiments simulating the environment and breathing conditions of a dental professional performing a dental amalgam restoration removal procedure. Analysis was carried out using scanning electron microscopy and inductively coupled plasma optical emission spectrometry. Data was collected in 2018-2019. Results: Experiments reveal that approximately 58% of mercury contained within the amalgam material is vaporized during removal procedures, and that aerosolized particles, ranging in size from 0.85 to 570 microns, may remain in suspension for nearly two minutes in the area surrounding the working surface. For dental professionals performing on average 9 such restorations per week, the estimated chronic daily intake (CDI) of mercury is 49 micrograms/kilogram-day, which exceed by more than 20 times the CDI recommended by the World Health Organization. Data analysis was performed in 2019. Conclusion: Because the CDI exceed recommended safe exposure limits, dental professionals should wear respiratory and personal protective equipment to protect them from exposure to both mercury vapour and mercury-containing particulates for at least two minutes following removal procedures.
Improper pesticide use in Agriculture in rural areas portends huge health hazard to humans and other biological life forms. This present study was aimed at screening four vegetables randomly sampled from selected farmlands in Wudil, Kano State of Nigeria for pesticide residues and their derivatives with intention of determining possible contamination from pesticides residues. The extraction was carried out by standard procedures and the identification and quantification of pesticide residues were carried out by GC-MS analysis. The result revealed chlorpyrifos (an organophosphorus) as the only known active pesticide residue detected in all four vegetables. The mean levels detected were 1.42, 1.69, 1.86 and 2.10mg/kg of sample for spinach, carrot, cabbage and garden egg, respectively. The levels of chlorpyrifos detected in all four vegetables were significantly higher (p