
A BSTRACT Background and Objective: Green synthesis of nanoparticles has emerged as a sustainable alternative to conventional methods, minimizing the use of toxic chemicals. This study aimed to synthesize iron oxide nanoparticles (IONPs) using Andrographis paniculata and Glycyrrhiza glabra extracts, followed by functionalization with andrographolide (AG) and glycyrrhizin (GL), and to evaluate their antimicrobial, antioxidant, anti-inflammatory, and cytotoxic properties. Materials and Methods: IONPs were synthesized via a green-mediated approach using aqueous plant extracts and ferric chloride and further functionalized to obtain AG-IONP, GL-IONP, and AGGL-IONP. All in vitro experiments were conducted in triplicate, and results were expressed as mean ± standard deviation. Characterization was performed using ultraviolet (UV)-visible (UV-Vis) spectroscopy, X-ray diffraction (XRD), Fourier-transform infrared (FTIR), and high-resolution scanning electron microscopy (HR-SEM). Antimicrobial activity was assessed by agar well diffusion and time-kill kinetics, antioxidant activity by 2,2-diphenyl-1-picrylhydrazyl (DPPH) assay, anti-inflammatory potential by membrane stabilization and bovine serum albumin (BSA) assays, and cytotoxicity by brine shrimp lethality assay. Statistical analysis was performed using one-way analysis of variance (ANOVA) followed by Bonferroni-corrected pairwise t -tests; P < 0.05 was considered statistically significant. Results: UV-Vis analysis demonstrated a characteristic absorption peak at ~ 435 nm, confirming nanoparticle formation. XRD confirmed γ-Fe 2 O 3 (maghemite) as the dominant crystalline phase in all formulations, with phase composition unchanged across coating groups. FTIR confirmed Fe–O bonds and phytochemical functionalization, while HR-SEM revealed nanoscale particles. IONPs and AG-IONPs demonstrated notable antimicrobial activity against Pseudomonas aeruginosa (14.09 ± 0.40 mm at 100 µg/mL). The DPPH assay revealed strong concentration-dependent antioxidant activity, with IONPs (90.19% ±1.21%) and GL-IONPs (89.52% ±3.42%) at 50 µg/mL. All formulations exhibited significant anti-inflammatory activity. One-way ANOVA demonstrated significant differences among formulations in DPPH ( F = 12.23, P < 0.001) and BSA ( F = 15.22, P < 0.001) assays. Cytotoxicity studies indicated good biocompatibility. Conclusion: Green-synthesized IONP nanoparticles functionalized with AG and GL exhibit enhanced multifunctional biological activity. Statistical analysis validated the significance of interformulation differences, supporting their potential as a suitable agent for biomedical applications.
A BSTRACT Aims: To compare and evaluate the pulp volume of permanent molars involving endo-perio lesions (EPLs) versus healthy molars (without EPLs) in patients with type 2 diabetes mellitus (T2DM). Objectives: (1) To determine the pulp volume of teeth with EPL and diabetes mellitus (DM). (2) To determine the pulp volume of healthy molars and DM. (3) To compare and evaluate pulp volume in healthy teeth and teeth with EPLs in DM patients. (4) To evaluate the pulp volume of the tooth in all types of EPLs. (5) To compare and evaluate pulp volume of teeth in >50 years and <50 years of DM patients. Subjects and Methods: Thirty-two patients diagnosed with EPL in any one molar and contralateral healthy molar in the same patient with T2DM were included in the study and were divided into two groups: Group 1 (32) – EPL and Group 2 (32) without EPL. The pulp volume was checked, and cone-beam computed tomography scans were taken for all teeth. DICOM files were evaluated to analyze the pulp volume with the help of ITK-Snap software by an experienced radiologist. Statistical Analysis Used: Data were analyzed using the Statistical Package for the Social Sciences software version 20.0. An independent samples t -test was carried out to compare the pulp volume. Results: A statistically significant difference was present in the pulp volume of healthy and diseased teeth. The pulp volume was much higher in the control group. Conclusions: Within the limitations of the study, it can be concluded that pulp volume is reduced in patients with EPLs and T2DM.
A BSTRACT Background: Implant placement in the anterior maxilla often requires angulation compromises, which may increase peri-implant stress. Platform switching and angulated abutments have been suggested to modify stress transfer. Aim: The aim of this study was to evaluate the effects of platform switching and abutment angulation on peri-implant stress in anterior maxillary implants using finite element analysis. Methodology: Four three-dimensional finite element models representing platform-matched and platform-switched implants with straight and 15° angulated abutments were created. Oblique static loads were applied directly to the abutment at 131° to the implant long axis, and peri-implant von Mises stresses were evaluated at the crestal, mid-third, and apical regions of the surrounding bone. Platform-switched implants showed approximately 30% lower crestal stress compared to platform-matched implants, while angulated abutments produced a notable reduction in crestal stress in platform-matched models. Results: Platform-switched implants demonstrated an overall reduction in crestal stress of approximately 30% compared to platform-matched implants, with the maximum reduction of approximately 48% observed at 200 N. In platform-matched models, angulated abutments reduced crestal stress, whereas abutment angulation had minimal effect in platform-switched models. Conclusion: Platform switching effectively reduces peri-implant stress in the anterior maxilla. When platform matching is unavoidable, angulated abutments may help mitigate crestal stress.
A BSTRACT The combination of bilateral agenesis of the maxillary lateral incisors (BAMLI) and a palatally displaced canine (PDC) is rare and presents complex treatment challenges. This case report describes the interdisciplinary orthodontic management of a patient with BAMLI, persistent primary teeth, and PDC, which included canine substitution and selective primary tooth retention. A 29-year-old female presented with esthetic concerns related to retained primary teeth and displacement of the maxillary canine. Comprehensive orthodontic treatment using the MBT system was performed, including modified bracket prescription maneuvers, progressive archwire sequencing, strategic extraction of selected primary teeth, and alignment of the palatally displaced maxillary canine. After orthodontic finishing, a direct composite veneer was placed to enhance anterior esthetics. After 26 months, the maxillary arch achieved symmetrical anterior alignment, successful integration of the canine into the lateral incisor position, and improved gingival contour. Occlusal interdigitation was stable, soft tissues were harmonious, and the patient reported high satisfaction with esthetic and functional outcomes. Canine substitution combined with selective primary tooth retention represents a minimally invasive and predictable treatment modality for BAMLI. This case highlights the importance of torque control, anchorage planning, and interdisciplinary collaboration in optimizing esthetic and functional outcomes.
A BSTRACT Objective: This study aimed to formulate and evaluate an eco-friendly chewable toothpaste incorporating rice husk ash (RHA) and to assess its in vitro physicochemical, anti-inflammatory, antioxidant, antimicrobial, and biocompatibility properties. Materials and Methods: Chewable toothpaste tablets were formulated using 1% (w/w) silica-rich RHA along with green tea extract, curcumin, Vitamin E, zinc citrate, xylitol, sorbitol, peppermint oil, sodium fluoride, and agar–agar. Fourier-transform infrared (FTIR) spectroscopy was used to confirm chemical interactions and component integration. Anti-inflammatory activity was evaluated using the bovine serum albumin denaturation assay, whereas antioxidant potential was assessed using the 2,2-diphenyl-1-picrylhydrazyl free radical scavenging assay. Antimicrobial activity against Escherichia coli , Staphylococcus aureus , and Streptococcus mutans was evaluated using the agar well diffusion method. In vitro release was assessed in phosphate-buffered saline (pH 7.4) over 12 h. Enamel abrasiveness was analyzed using stylus profilometry, and biocompatibility was assessed using the 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide assay on human gingival fibroblasts. All experiments were performed in triplicate. Data were analyzed statistically, and significance was set at P < 0.05. Results: FTIR confirmed successful incorporation of silica and bioactive compounds. The formulation showed strong anti-inflammatory activity (62.1% ±1.6%) and antioxidant activity (48.2% ±1.4%). Inhibition zones were observed against E. coli and S. aureus , while S. mutans was resistant. Sustained release, reduced enamel abrasiveness, and cell viability above 90% were observed. Conclusion: The RHA-enriched chewable toothpaste demonstrated effective therapeutic activity, low abrasiveness, and excellent biocompatibility, supporting its potential as a sustainable dentifrice.