
The dielectric relaxation and optical properties of the chlorobenzene-iodobenzene-n-hexane ternary system were investigated in the microwave region (lambda = 0.75-6.32 cm) over the temperature range from -40 to +30 degrees C using dielectric spectroscopy combined with Density Functional Theory (DFT) calculations. The influence of temperature and composition on dielectric relaxation behavior was analyzed. It was established that increasing iodobenzene content enhances relaxation time and dielectric strength due to stronger dipole-dipole interactions and higher molecular polarizability, whereas the addition of n-hexane weakens intermolecular interactions and reduces relaxation times. The relaxation processes exhibit thermally activated non-Debye behavior. DFT calculations provided microscopic insight into the dielectric and optical response through analysis of the dielectric function, polarizability, refractive index, optical conductivity, and electric susceptibility. The results indicate that iodine-induced polarizability and n-hexane-mediated dielectric screening govern the relaxation behavior and optical response of the ternary system. These findings contribute to the understanding of dielectric relaxation in multicomponent aromatic liquid systems and may be relevant for the design of dielectric and microwave materials.
Ru-modified TiO2 photocatalysts with different Ru loadings (0.05, 0.1, and 0.2 mol%) were synthesized and investigated for the selective photocatalytic reduction of 4-nitrophenol (4-NP) to 4-aminophenol (4-AP) under UV irradiation. The materials were characterized by X-ray diffraction (XRD), Raman and Fourier-transform infrared (FT-IR) spectroscopy, scanning electron microscopy (SEM), N2 physisorption, UV-Vis diffuse reflectance spectroscopy, photoluminescence (PL), and photoelectrochemical measurements. Ru incorporation preserved the anatase structure, while significantly affecting the textural, surface, optical, and charge-carrier properties of TiO2. The effect of Ru loading was particularly evident in the charge-carrier dynamics and photocatalytic behaviour. The 0.05 mol% Ru-TiO2 sample exhibited the highest photocurrent response and the fastest 4-NP conversion kinetics, whereas the 0.1 mol% Ru-TiO2 photocatalyst showed the highest selectivity toward 4-AP. The latter also exhibited the highest specific surface area (160 m2 g-1), the smallest crystallite size, enhanced surface hydroxylation, and the lowest band-gap energy. These results indicate that maximizing charge transport alone is insufficient to achieve the highest selectivity and that an appropriate balance between chargecarrier dynamics and surface properties is required. Under optimized operating conditions (0.1 mol% Ru-TiO2, catalyst loading of 1.5 g L-1, initial 4-NP concentration of 0.072 mM, and Na2SO3 concentration of 3.97 mM), complete 4-NP conversion and a 4-AP yield of approximately 95% were achieved after 180 min of UV irradiation. The optimized photocatalyst maintained high conversion and 4-AP yield over three consecutive recycling cycles. Post-reaction XRF analysis showed no appreciable change in the Ru content, while XRD confirmed preservation of the crystalline structure, supporting the compositional, structural, and operational stability of the photocatalyst under the investigated conditions. Overall, the results demonstrate that Ru loading plays a key role in controlling the interplay between chargecarrier dynamics and surface properties of TiO2, thereby determining the activity and selectivity of the photocatalytic reduction of 4-NP to 4-AP.
Solar-driven water treatment has attracted increasing attention as energy transition and environmental remediation continue to advance. In this study, a series of La3+-doped Bi3NbO7 photocatalysts were prepared by a one-step hydrothermal method, and their visible-light activity was evaluated using tetracycline hydrochloride (TC) as the target pollutant. La3+ incorporation altered the crystal growth, morphology, and electronic structure of Bi3NbO7. The original agglomerated polyhedral particles were converted into interwoven two-dimensional nanosheets, together with local lattice distortion, increased oxygen-vacancy content, and changes in the band structure. Among these, 9%La-BNO exhibited the best photocatalytic activity, achieving a TC removal rate of 95.7% within 90 min, with a degradation rate 4.58 times that of pure Bi3NbO7. Further analysis combining LC-MS, molecular electrostatic potential, and Fukui function theoretical calculations identified the potential reaction sites for TC and inferred its degradation pathway. This study elucidates the mechanism by which La3+induced synergistic restructuring of morphology, lattice, and electronic structure enhances the photocatalytic performance of Bi3NbO7.
Residual aniline in water is highly toxic and poses a threat to the aquatic environment. Given that vacuum ultraviolet (VUV) can decompose water to generate reactive oxygen species in situ, VUV/H2O2 and VUV/ozone (O3) have excellent oxidation properties and the advantage of no residual oxidants. Herein, the degradation of aniline by VUV/H2O2 and VUV/O3 was comprehensively compared for the first time. VUV/H2O2 (89.23% at 30 min) and VUV/O3 (93.49% at 8 min) exhibited higher aniline degradation efficiency and rate constants than their sub-processes, showing a synergistic effect. Effects of oxidant (H2O2 or O3) dose and solution pH on aniline removal during VUV/H2O2 and VUV/O3, as well as the mechanisms, were elucidated. Besides, based on quenching experiments, fluorescence indicator, and molecular probe, hydroxyl radical (center dot OH) was identified as playing the main role in VUV/H2O2 for aniline removal, with a contribution of 77.65%, and the degradation of aniline in VUV/O3 mainly relied on the oxidation effect of center dot OH (50.15%) and the role of O3 direct oxidation. Steady-state concentrations of center dot OH in VUV/H2O2 and VUV/O3 were 1.87 & times; 10-12 and 4.44 & times; 10- 13 M, respectively. Moreover, possible degradation pathways of aniline were proposed via theoretical calculations and product detection, including hydroxylation, nitration, hydroxyamination (in VUV/H2O2), and O3 addition (in VUV/O3). Furthermore, combining results of the influences of coexisting substances, energy consumption, and performance in actual waters, compared to VUV/H2O2, VUV/O3 was more efficient in aniline removal and energy-saving. Thus, VUV/O3 was recommended to degrade aniline.
Singlet oxygen (1O2) is a key reactive oxygen species in photooxidation, photocatalysis, antimicrobial photo-inactivation, environmental remediation, and photodynamic therapy. Here, we investigate the power-and delay-dependent regulation of methylene-blue-sensitized 1O2 generation using a 589 nm excitation pulse and a delayed 765 nm secondary pulse. Fluorescence depletion (FD) and ABDA assays show that we can regulate singlet oxygen generation by 40% with secondary-pulse power and by 38% with pulse delay. These results identify competing optical pathways for time-delayed dual-wavelength control of photosensitized 1O2 production.