
Brass rods (mainly C36000, C38500, and C37700) are used in a great variety of applications, from machine component/hydraulic part manufacturing to architecture and fine arts. The chemical composition of these alloys is carefully designed to enhance machinability and/or hot formability (for free machining and hot stamping operations, respectively). This article reviews the principal defects that lead to in-process and in-service failures of brass rods and related components. The review is focused on defects caused by selected metalforming processes for the production of brass rods (extrusion and cold drawing) and on the role of these defects in failures during component processing and use.
A premix feeder line on a land-based gas turbine was found to be leaking, and the source of the leakage was traced back to a crack in a pipe-to-fitting weld. The weld joined a coupling made from the X6CrNiMoTi17-12-2 austenitic stainless steel to a type 316L austenitic stainless steel reducer. A root-cause assessment was conducted to determine the cause of the crack. Evidence of fatigue and corrosive attack was found. Various factors that influence the susceptibility to corrosion and cracking, such as heat tints, geometry of the weld, and surface finish of the component, are discussed. Recommendations are made for corrective actions and failure prevention.
Two titanium alloy wing attachment bolts from a commercial jetliner failed during the course of a routine service operation. Failure of the bolts occurred during the re-torque process as the wing was being reattached. Metallurgical failure analysis indicated that the fracture mechanism was ductile overload and that the mechanical properties of the bolts were consistent with exemplar bolts that had been supplied. After eliminating other sources of excessive load application, the most probable cause of failure was ascribed to variances between the frictional characteristics of the bolt at the time of re-torque and at the time of initial torque application several years earlier.
It is well known that corrosion can weaken structures over time, but because corrosion rates can differ significantly from location to location, it is difficult to predict the amount of weakening that can occur for a particular structure used outdoors in a given location. Over the years, salt fog testing has been used to help predict how a structure might degrade over time resulting from exposure. The most common tests are based upon MIL-STD 810 “Environmental Engineering Considerations and Laboratory Tests,” and ASTM B117 “Standard Practice for Operating Salt Spray (Fog) Apparatus.” Although these standards give guidelines on conducting accelerated tests, they provide no insight as to the real world exposure level corresponding to a test condition, i.e. an acceleration factor.