This study was conducted to clarify the seasonal variation of the chemical composition of the Tunisian Sardinella aurita with a focus on the total lipid content. The chemical composition showed a large fluctuation over years in response to various factors. For the entire fish, lipid content was lower in July (2.50%), but higher in November (10.25%). It varies with seasons in inverse proportion to water content. Interestingly, it was found that red muscle have much higher lipid content than white muscle and the entire fish body. The major fatty acids in S. aurita lipids were palmitic acid, palmitoleic acid, eicosapentaenoic acid, docosahexaenoic acid and myristic acid. Palmitic acid comprised the main proportion (23.9%). The high amounts of saturated and monounsaturated fatty acids in the screened species are almost in agreement with other studies. Moreover, the percentage of omega-3 fatty acids (25%) was very similar to that in oil production commercial fish.

Maple sap, an abundant natural product especially in Canada, is rich in sucrose and thus may represent an ideal renewable feedstock for the production of a wide variety of value-added products. In the present study, maple sap or sucrose was employed as a carbon source to Alcaligenes latus for the production of poly-beta-hydroxybutyrate (PHB). In shake flasks, the biomass obtained from both the sap and sucrose were 4.4 +/- 0.5 and 2.9 +/- 0.3 g/L, and the PHB contents were 77.6 +/- 1.5 and 74.1 +/- 2.0%, respectively. Subsequent batch fermentation (10 L sap) resulted in the formation of 4.2 +/- 0.3 g/L biomass and a PHB content of 77.0 +/- 2.6%. The number average molecular weights of the PHB produced by A. latus from maple sap and pure sucrose media were 300 +/- 66 x 10(3) and 313 +/- 104 x 10(3) g/mol, respectively. Near-infrared, (1)H magnetic resonance imaging (MRI), and (13)C-MRI spectra of the microbially produced PHB completely matched those obtained with a reference material of poly[(R)-3-hydroxybutyric acid]. The polymer was found to be optically active with [alpha](25) (D) equaled to -7.87 in chloroform. The melting point (177.0 degrees C) and enthalpy of fusion (77.2 J/g) of the polymer were also in line with those reported, i.e., 177 degrees C and 81 J/g, respectively.

Inoculating legumes with commercial rhizobial inoculants is a common agriculture practice. Generally, inoculants are sold in liquid or in solid forms (mixed with carrier). The production of inoculants involves a step in which a high number of cells are produced, followed by the product formulation. This process is largely governed by the cost related to the medium used for rhizobial growth and by the availability of a carrier source (peat) for production of solid inoculant. Some industrial and agricultural by-products (e.g. cheese whey, malt sprouts) contain growth factors such as nitrogen and carbon, which can support growth of rhizobia. Other agro-industrial wastes (e.g. plant compost, filtermud, fly-ash) can be used as a carrier for rhizobial inoculant. More recently, wastewater sludge, a worldwide recyclable waste, has shown good potential for inoculant production as a growth medium and as a carrier (dehydrated sludge). Sludge usually contains nutrient elements at concentrations sufficient to sustain rhizobial growth and heavy metals are usually below the recommended level. In some cases, growth conditions can be optimized by a sludge pre-treatment or by the addition of nutrients. Inoculants produced in wastewater sludge are efficient for nodulation and nitrogen fixation with legumes as compared to standard inoculants. This new approach described in this review offers a safe environmental alternative for both waste treatment/disposal and inoculant production.

Biopolymers such as poly(hydroxyalkanoates) (PHAs) have received much attention due to their physico-chemical properties, biodegradability, and biocompatibility that make them good candidates for industrial and medical applications. Produced by some microorganisms PHAs accumulate within the cells of these organisms. The optimization of microbial processes to produce PHAs at a lower cost requires rapid and accurate techniques for quantification of the biopolymer in biomass. The present study describes a method based on solid-phase microextraction (SPME) coupled to gas chromatography (GC) for the determination of poly(3-hydroxybutyrate) (PHB) in Alcaligenes latus cells. First PHB was depolymerized by either methanolic or hydrolytic digestion into methyl 3-hydroxybutyrate (Me-3-HB) or crotonic acid (CA), respectively. The resulting analytes were then subjected to analysis by headspace SPME/GC with flame ionization detection (FID). The two depolymerization/SPME/GC-FID methods were optimized and applied to the analysis of PHB in bacterial biomass harvested from a fermentation process that uses A. latus. Results were compared with those obtained using GC-FID analysis of MeOH/CHCl3 digested samples. Excellent agreement was found between the three methods but the two SPME-based methods were environmentally friendly and easier to perform.

In the present study, we used microwave energy instead of conventional heating to transform poly-3-hydroxybutyrate (PHB) into methyl 3-hydroxybutyrate (Me-3HB) in acidified methanol (H2SO4, 10%, v/v) mixture in less than 4 min at 10% microwave power. The microwave assisted method was then applied to analyze PHB produced by Alcaligenes latus. The PHB content in the biomass determined using microwave heating was comparable to the amount found by conventional heating. Moreover, the new esterification method was at least 50 times faster than the conventional method, affording a significant saving of time and energy.

Bacillus thuringiensis (Bt) production using wastewater sludge as a raw material was studied in bench scale fermentor at different sludge solids concentration. The highest cell and spore concentrations and entomotoxicity were observed at a suspended solids concentration of 20–25g/l. Maximal protease activity also increased with solids concentration, however, it decreased after attaining a peak at about 36h. Maximal protease activity (2.3–2.8IU/ml) obtained at 25 and 20g/l sludge suspended solids concentration was 1.75 and 1.5 times that of the maximal activity obtained at 15g/l. Irrespective of the sludge suspended solids concentration, protease activity (until its peak) showed an exponential relationship with total cell count and a linear relationship with entomoxicity potency. An exponential correlation was also established between spore concentration and entomotoxicity. The correlations tested using a regression model were highly significant.

A new bacterial strain, isolated from groundwater contaminated with explosives, was characterized as a pink-pigmented facultative methylotroph, affiliated to the genus Methylobacterium. The bacterial isolate designated as strain GW2 was found capable of producing the homopolymer poly-3-hydroxybutyrate (PHB) from various carbon sources such as methanol, ethanol, and succinate. Methanol acted as the best substrate for the production of PHB reaching 40 % w/w dry biomass. PHB accumulation was observed to be a growth-associated process, so that there was no need for two-step fermentation. Optimal growth occurred at 0.5 % (v/v) methanol concentration, and growth was strongly inhibited at \(a\) concentration above 2 % (v/v). Methylobacterium sp. strain GW2 was also able to accumulate the copolyester poly-3-hydroxybutyrate-poly-3-hydroxyvalerate (PHB/HV) when valeric acid was supplied as an auxiliary carbon source to methanol. After 66 h, a copolymer content of 30 % (w/w) was achieved with a PHB to PHV ratio of 1:2. Biopolymers produced by strain GW2 had an average molecular weight ranging from 229,350 to 233,050 Da for homopolymer PHB and from 362,430 to 411,300 Da for the copolymer PHB/HV.

Starch industry wastewater (SWW), slaughterhouse wastewater (SHWW) and secondary sludges from three different wastewater treatment plants (Jonquière—JQS, Communauté Urbaine de Québec—CUQS and Black lake—BLS) were used as raw materials for the production of Bacillus thuringiensis (Bt) based biopesticides in a pilot scale fermentor (100 L working volume). The slaughterhouse wastewater exhibited the lowest Bt growth and entomotoxcity (Tx) potential (measured against spruce budworm) due to low availability of carbon, nitrogen and other nutrients. Performance variation (growth, sporulation, proteolytic activity and Tx potential) within the three types of sludges was directly related to the availability of nitrogen and carbohydrates, which could change with sludge origin and methods employed for its generation. The Tx potential of Bt obtained in different secondary sludges (JQS: 12 × 109 SBU/L; CUQS: 13 × 109 SBU/L and BLS: 16 × 109 SBU/L) and SWW (18 × 109 SBU/L) was higher than the soybean based synthetic medium (10 × 109 SBU/L). The maximum protease activity was obtained in CUQ secondary sludge (4.1 IU/mL) due to its high complex protein concentration. Nevertheless, high carbohydrate concentration in SWW repressed enzyme production. The secondary sludges and SWW were found to be suitable raw materials for high potency Bt biopesticide production.

In this investigation, ammonium hydroxide and acetic acid were used as pH control agents during Bacillus thuringiensis (Bt) fermentation in a pilot scale fermentor (150-l) employing two secondary wastewater sludges from two different wastewater treatment plants (CUQS and JQS) and semi-synthetic soybean meal medium as raw materials. Regardless of the cultivation medium, a substantial increase in total cell count, spore count, protease activity and entomotoxicity was achieved when the pH of the culture was controlled using NH4OH/CH3COOH. At harvest, total cell count increased by almost 17%, 33% and 25%; protease activity was enhanced by 12%, 33% and 53% and maximal spore count augmented by almost 28%, 48% and 33% in CUQS, JQS and soybean medium, respectively. Entomotoxicity potency was improved by 22%, 21% and 14% in CUQS, JQS and soybean medium, respectively compared to results obtained with NaOH/H2SO4 as pH control agents. A higher entomotoxicity was also observed using sludge compared to the soybean medium. This improvement of the Bt process performance was a consequence of the addition of rapidly utilizable carbon and nitrogen source through pH control, which stimulated endotoxin production in the crystal and enhanced sporulation.

Wastewater sludge is a complex raw material for fermentation and requires pre-treatment in order to transform less biodegradable compounds into more easily degradable ones. In this study, sludge was treated by thermo-alkaline and oxidative pre-treatment methods and subjected to Bacillus thuringiensis fermentation in bench scale fermentors under controlled conditions. Thermo-alkaline treatment was found to be an effective process in order to enhance the entomotoxicity tested against spruce budworm. The total cell and spore counts were improved by 40 and 46%, respectively as compared to that using the untreated sludge. The final entomotoxicity potency increased from 12.3 × 109 SBU/l of the raw sludge to 16.6 × 109 SBU/l of the thermo-alkaline pre-treated sludge. The improvement of the process performance was attributed to a better oxygen transfer due to decrease in media viscosity and an improvement of nutrient availability due to the sludge solubilization and biodegradability.

Dans un contexte international où, pour plusieurs, la gestion publique en matière de services urbains a montréses limites, la Société Nationale d'Exploitation et de Distribution des Eaux (SONEDE) de la Tunisie fait figure d'exception par les bonnes performances qu'elle affiche. Le ≪modèle≫ tunisien bénéficie cependant de facteurs socio-économiques favorables et de règles institutionnelles équitables respectant la capacité de payer de la population et orientant ses services vers les clientèles en exploitant un système de péréquation entre les régions et une tarification fortement progressive. Dans un pays caractérisé par un faible capital hydrique, la SONEDE doit toutefois s'adapter aux nouvelles problématiques de l'offre et la demande afin de garantir la fiabilité et la continuité de l'Alimentation en Eau Potable (AEP) de toutes les régions tunisiennes et répondre aux exigences de plus en plus grandes en matière de qualité de service. L'entreprise doit en effet repenser sa politique d'investissement, de production, de distribution et de tarification de l'eau potable et proposer des solutions orientées davantage vers la gestion de la demande et l'augmentation de l'offre, solutions intégrant les capacités accrues du secteur privé. Les défis de l'avenir se posent en effet en termes d'économie d'eau et de recours croissant aux ressources en eau non-conventionnelles. L'entreprise publique considère maintenant que la sous-traitance est un moyen d'améliorer les prestations de service tout en allégeant ses frais de structures.

Studies were conducted on the production of Bacillus thuringiensis (Bt)-based biopesticides to ascertain the performance of the process in shake flasks, and in two geometrically similar fermentors (15 and 150 l) utilizing wastewater sludge as a raw material. The results showed that it was possible to achieve better oxygen transfer in the larger capacity fermentor. Viable cell counts increased by 38-55% in the bioreactor compared to shake flasks. As for spore counts, an increase of 25% was observed when changing from shake flask to fermentor experiments. Spore counts were unchanged in bench (15 l) and pilot scale (5.3-5.5 e(+08) cfu/ml; 150 l). An improvement of 30% in the entomotoxicity potential was obtained at pilot scale. Protease activity increased by two to four times at bench and pilot scale, respectively, compared to the maximum activity obtained in shake flasks. The maximum protease activity (4.1 IU/ml) was obtained in pilot scale due to better oxygen transfer. The Bt fermentation process using sludge as raw material was successfully scaled up and resulted in high productivity for toxin protein yield and a high protease activity.