A seeming contradiction in the prediction of the spatially correlated trapping center/luminescent center model applied to LiF:Mg,Ti has been the linear/supralinear behavior of the dose response of glow peak 5a. In the TC/LC model, the localised electron-hole recombination, giving rise to glow peak 5a, is expected to result in an extended region of linear dose response. Deconvolution of the glow curves based on first order kinetic peak shapes results, however, in a dose response of peak 5a, which closely resembles the linear/supralinear dose response of peak 5. It is demonstrated herein that when general-order kinetics peak shapes are used for peak 5a, the analysis can result in a linear dose response of glow peak 5a up to dose levels as high as 30 Gy, well beyond the 1-Gy onset of supralinearity of peak 5. The extended linearity suggests a resolution of the contradiction.

Sand spots, attached to a copper ball surface by means of polyvinyl acetate adhesive and distributed over the surface with areal density that ranges between one spot per 1.18 cm(2) (for low-density spots) and one spot per 0.51 cm(2) (for high-density spots), serve as a temporary heat transfer enhancer during the quenching in liquid nitrogen. Highest heat flux densities, achieved during quenching, lie in the range 10.8 to 20.2 W/cm(2), depending on the sand layer structure. Application of the temporary enhancer increases an amount of heat, evacuated by highly effective nucleate and transition boiling, by factor of 4.5 as compared with the bare sample. The process of sand layer preparation, data acquisition peculiarities, relationship between heat exchange efficiency and the spots areal density, along with sand grit size are discussed in this paper.