This paper represents a low cost printed Vivaldi antenna at 3–10 GHz bandwidth for Radio telescope Feed system. The idea of this design is to minimize the number of telescope receivers for Square Kilometre Array (SKA) [1]. A minimized tapered slot antenna with a balun feed for receiver systems is proposed. The Vivaldi antenna is design on a relatively low dielectric constant substrate which operates at Ultra-Wideband (UWB). A typical tapered slot antenna is a combination of a wideband balun and a radiator with different tapering shapes such as linear, constant width, exponential and dual exponential. Two feeding configurations are used such as coplanar waveguide (CPW) to slot line transition and microstrip line to slotline transition [2–5]. The antenna modeling is analyzed using two different electromagnetic simulators such as HFSS and CST Microwave Studio. The results are shown that the antenna operates over a wide bandwidth extending from 3.1 to 10.6 GHz with a maximum gain of 7.3 dBi. Stable radiation patterns are observed across the operational bandwidth, with cross-polarization levels below −20 dB. The realized antenna structure occupies a volume of 45 × 45 × 0.5 mm 3 , and possesses the essential time domain fidelity needed for UWB Radio telescope Feed system applications. A prototype Vivaldi antenna is constructed and measured for validation. The Voltage Standing Wave Ratio (VSWR) of the proposed antenna is verified against the simulated data results, the measured and simulated results are found to be in good agreement. In particular, a good impedance bandwidth matching and stable directional radiation patterns were achieved across the operating frequency range. The combination of design aims and outcomes described in the paper indicates that the proposed antenna can be a suitable candidate for portable RF systems, or possible sensor element in an UWB antenna array application.

A loop feed meander-line Antenna (LFMLA) RFID tag on a relatively low dielectric constant substrate operates on the European UHF band 865-868 MHz is presented. The tag modeling is analyzed using two different electromagnetic simulator HFSS and CST. A prototype tag antenna is constructed and measured for validation. The input impedance of the proposed antenna is verified against the simulated data results, the measured and simulated results are found to be in good agreement. The compact size tag antenna shows excellent impedance matching to the typical input impedance of a RFID integrated circuit chip and a significant improvement in reading range up to 5 meters.