We report a new ICF scheme whereby a capsule is imploded to near ignition conditions and subsequently flooded with hot electrons generated from a short-pulse laser plasma interaction so as to heat the whole assembly by a few hundred eV. The cold dense shell pressure is increased by a larger factor than that of the hot spot at the capsule core, so that further heating and compression of the hot spot occurs. We suggest it may be possible to drive the capsule to ignition by the pressure augmentation supplied by this extra deposition of energy.

We have performed measurements of the radiation and the hot electron temperature in sub-millimetre size hohlraums driven by a high intensity short-pulse laser. The results indicate that radiation temperatures ∼80 eV can be obtained with ∼20 J of laser energy delivered on target. Radiation-hydrodynamics simulations indicate an absorption into thermal X-rays of ≲1–2%, with peak temperatures similar to those measured experimentally.

Experiments have been conducted using laser-driven cylindrical hohlraums whose walls are machined from Ta2O5 foams of 100 mg/cc and 4 g/cc densities. Measurements of the radiation temperature demonstrate that the lower density walls produce higher radiation temperatures than the high density walls. This is the first experimental demonstration of the prediction that this would occur [M. D. Rosen and J. H. Hammer, Phys. Rev. E 72, 056403 (2005)10.1103/PhysRevE.72.056403]. For high density walls, the radiation front propagates subsonically, and part of the absorbed energy is wasted by the flow kinetic energy. For the lower wall density, the front velocity is supersonic and can devote almost all of the absorbed energy to heating the wall.

Reliable models for the transport and deposition of energy in solid targets during short-pulse laser matter interactions are vital for designing and interpreting material properties experiments, and of clear relevance to the fast igniter. We conduct hybrid plasma simulations using LSP, considering relatively modest intensities to facilitate comparisons with radiation hydrodynamic models. The relative effects of thermal wave heating, direct collisional heating by fast electrons and Ohmic heating are discussed. Target heating depends strongly on the form of the hot electron distribution produced by the absorption of the incident laser pulse at the vacuum-matter interface. Where the hot electron population is assumed to be a discrete beam, we find good agreement with our models. For the case of a thermalised hot electron population, target heating by hot electrons is reduced. Under these conditions, the interplay between fast-electron and thermal wave heating is unclear, which has implications for target heating experiments.

A first set of shock propagation, laser-plasma interaction, hohlraum energetics and hydrodynamic experiments have been performed using the first 4 beams of the National Ignition Facility (NIF), in support of indirect drive Inertial Confinement Fusion (ICF) and High Energy Density Physics.

The National Ignition Facility (NIF), currently under construction at Lawrence Livermore National Laboratory (LLNL) comprises four clusters of 48 laser beams in a symmetric geometry. Each cluster is itself capable of producing potentially useful conditions for hohlraum interaction experiments. The three dimensional nature of the laser illumination geometry in each cluster presents a challenge when modelled with a 2D hydrocode. Recent experiments have been fielded on the OMEGA laser facility to investigate the validity of using such codes in modelling the plasma filling of targets in similar geometries to a NIF cluster. The extent to which plasma filling within hohlraum type targets is a significant issue can potentially be addressed by the observation of laser plasma instabilities, such as Raman backscatter. This can be a significant energy loss mechanism for targets that have electron densities up to quarter critical. Linear Raman gain theory has been applied to the output from AWE's 2D lagrangian radiation hydrodynamics code, NYM, to produce qualitative and quantitative comparisons with these experiments. This provides a basis for judging the fidelity of the approach.

Time-resolved x-ray spectra from solid targets irradiated by the VULCAN Petawatt laser focused to 1020Wcm−2 show that material at solid density is heated to temperatures above 500 eV to a depth of about 15 μm and for a duration of more than 30 ps. Modeling with the implicit hybrid plasma code LSP shows that the heating is sensitive to the laser prepulse through resistive inhibition of the laser accelerated electrons in the blow off layer.

A series of experiments conducted on the HELEN laser system [M. J. Norman, Appl. Opt.4120023497], into thermal x-ray generation from hohlraum targets using 527 nm (2omega) wavelength laser light, has shown that it is possible to exceed radiation temperatures previously thought limited by high levels of superthermal or hot electron production or stimulated backscatter. This Letter questions whether the assumptions traditionally applied to hohlraum design with respect to hot plasma filling and the use of 2omega light are too conservative.

The first hohlraum experiments on the National Ignition Facility (NIF) using the initial four laser beams tested radiation temperature limits imposed by plasma filling. For a variety of hohlraum sizes and pulse lengths, the measured x-ray flux shows signatures of filling that coincide with hard x-ray emission from plasma streaming out of the hohlraum. These observations agree with hydrodynamic simulations and with an analytical model that includes hydrodynamic and coronal radiative losses. The modeling predicts radiation temperature limits with full NIF (1.8 MJ), greater, and of longer duration than required for ignition hohlraums.

A series of underdense laser plasma interaction experiments performed on the Helen laser [M. J. Norman et al., Appl. Opt. 41, 3497 (2002)] at the Atomic Weapons Establishment (AWE), U.K., using 2ω light have uncovered a strong dependence of laser backscatter and hot electron production on plasma composition. Using low-Z materials, we find a behavior familiar from previous 3ω work, the interchange of stimulated Raman scattering for Brillouin scattering as we change from gases that have high ion wave damping (e.g., C5H12) to gases with low ion wave damping (e.g., CO2). However, as Z is increased, we find that Brillouin scattering drops while Raman scattering remains low. For gases with Z greater than 18, it is possible to have long scalelength, underdense plasmas with both low Brillouin and Raman backscatter losses. Complementary measurements of hot electron production show efficient production of hot electrons in C5H12 plasmas approaching 0.25ncr, but changing the plasma composition can greatly suppress the hot electron production, even near 0.25ncr. Additional experiments indicate that by adding small amounts of high Z dopant, significant changes to the backscatter and hot electron production in C5H12 targets may be produced.

Recent experiments at the HELEN laser at AWE have focused on investigations into the performance of a series of scaled NOVA halfraum targets. These were varied from scale 1 to scale 0.1, and used a single beam at 0.53 μm to irradiate the target. The aim of these experiments was to investigate performance limitations for higher temperature small hohlraums. Target diagnostics included time-resolved X-ray power measurements, full aperture measurements of stimulated Raman and Brillouin backscatter, and time-integrated soft and hard X-ray spectrographs. Analyses of the results from this campaign are presented with particular emphasis on the conditions present in the smallest scale targets, including comparison with calculated performance.

Measurements of equation of state (EOS) points on the principal Hugoniots of Cu, Au, Pb and the plastics Parylene-C and brominated CH at multimegabar pressures have been made using the 1 TW HELEN laser at AWE. The aim was 1% accuracy in shock velocity measurement (3%–4% in pressure) in order to compare with data from gas-gun and nuclear underground test experiments and the theoretical EOS’s based on, or supported by, these data. Experiments comprised a hohlraum heated by two 500 J, 0.53 μm wavelength, 1 ns Gaussian laser pulses generating an x-ray flux which drove a shock into a target consisting of a base, with steps of a known EOS material and of the material of unknown EOS. Shock breakout from base and steps was detected by monitoring light emission from the target with optical streak cameras and shock velocities were derived from the transit times across the known-height steps.

It is shown that regions of enhanced pressure have been produced in targets with indirect radiation drive in planar and cylindrically convergent geometry through the interaction between the flows caused by target inhomogeneities and the main target drive. Design calculations for National Ignition Facility (NIF) [J. A. Paisner et al., Laser Focus World 30, 75 (1994)] targets with beryllium ablators formed by bonded hemi-shells [D. C. Wilson et al., Bull. Am. Phys. Soc. 43, 1667 (1998)] indicate that related behavior produces a seed perturbation in the ablator which can in some cases lead to the suppression of ignition. From simulation and analysis of the NIF problem in the planar geometry analog, a scaling for the perturbation, which should be useful for validation of the behavior with lower energy drive and smaller-scale geometries, is derived.

The use of copper-doped beryllium ablators on National Ignition Facility [J. A. Paisner et al., Laser Focus World 30, 75 (1994)] targets, in place of plastic, can require the bonding together of hemispheres with a joint of differing composition. Indirect drive experiments have been conducted on the Nova laser [J. L. Emmet, W. F. Krupke, and J. B. Trenholme, Sov. J. Quantum Electron. 13, 1 (1983)], and the resulting shock structuring compared with code simulations. It is concluded that one of the available codes, the RAGE code [R. M. Baltrusaitis et al., Phys. Fluids 8, 2471 (1996)] provides useful insight into the effect of joints. This code is then employed to obtain a physical picture of the shock front nonuniformity in terms of a secondary rarefaction and an oblique shock interacting with the main shock that propagates in the absence of the joint. A simple analysis reinforces this picture.

The Rayleigh–Taylor instability is an important limitation in inertial confinement fusion capsule designs. Significant work both theoretically and experimentally has been done to demonstrate the stabilizing effects of material flow through the unstable region. The experimental verification has been done predominantly in planar geometry. Convergent geometry introduces effects not present in planar geometry such as shell thickening and accelerationless growth of modal amplitudes (e.g., Bell–Plesset growth). Amplitude thresholds for the nonlinear regime are reduced, since the wavelength λ of a mode m decreases with convergence λ∼R/m, where R is the radius. Convergent effects have been investigated using an imploding cylinder driven by x-ray ablation on the NOVA laser [J. L. Emmet, W. F. Krupke, and J. B. Trenholme, Sov. J. Quantum Electron. 13, 1 (1983)]. By doping sections of the cylinder with opaque materials, in conjunction with x-ray backlighting, the growth and feedthrough of the perturbations from the ablation front to the inner surface of the cylinder for various initial modes and amplitudes from early time through stagnation was measured. Mode coupling of illumination asymmetries with material perturbations is observed, as well as phase reversal of the perturbations from near the ablation front to the inner surface of the cylinder. Perturbation growth is observed due to convergence and compressibility alone, without the effects of acceleration, and scales as ∼1/ρR, where ρ is the mass density. Imaging is performed with an x-ray pinhole camera coupled to a gated microchannel plate detector.