The aim of this paper is to evaluate how lubricant selection affects gearbox efficiency and overall energy production by analysing real data from wind farms, monitored and controlled by a Supervisory Control and Data Acquisition (SCADA system). The turbines analysed worked with two or more oil types for the same amount of hours, which allowed to establish relations between the active power curves and wind velocity; oil temperature inside gearboxes and wind velocity; and oil temperature inside gearboxes and active power production. The results of this study evidenced a direct relation between oil characteristics and energy efficiency i.e. gearboxes working with mineral oil perform better then gearboxes working with synthetic oils. Those differences can be significant in terms of active power production. Also, it was observed oil degradation as function of temperature increase, with changes on viscosity, which reveals that temperature behaviour along the active power curve is strongly related to oil’ characteristics.

This paper presents the results of a pilot experiment with an existing tidal energy converter (TEC), Evopod 1 kW floatable prototype, in a real test case scenario (Faro Channel, Ria Formosa, Portugal). A baseline marine geophysical, hydrodynamic and ecological study based on the experience collected on the test site is presented. The collected data was used to validate a hydro-morphodynamic model, allowing the selection of the installation area based on both operational and environmental constraints. Operational results related to the description of power generation capacity, energy capture area and proportion of energy flux are presented and discussed, including the failures occurring during the experimental setup. The data is now available to the scientific community and to TEC industry developers, enhancing the operational knowledge of TEC technology concerning efficiency, environmental effects, and interactions (i.e. device/environment). The results can be used by developers on the licensing process, on overcoming the commercial deployment barriers, on offering extra assurance and confidence to investors, who traditionally have seen environmental concerns as a barrier, and on providing the foundations whereupon similar deployment areas can be considered around the world for marine tidal energy extraction.

The challenge for floating offshore wind structures is to reduce costs. The industry needs a wind turbine support solution that can be fabricated and deployed from existing shipyards and port facilities, while investors need accurate estimations and forecasts of wind resources and quantified information on the inherent variability in wind power generation. This paper merges hindcast model data with observed in situ data to characterize the wind resource potential off the SW coast of Portugal. The validation procedure adopted allows an estimation of the coefficient used for power-law extrapolation of the wind measurements and a reduction in the uncertainty of the power density calculations. Different types of turbine model are compared and site metocean characteristics are examined as a basis for choosing between existing wind floatable solutions. The calculations using four different wind turbine models indicate a preferable installed capacity of 3-4 MW for a hub height of 90-120 m (i.e., representing the best capacity factor and load hours). There is a consistent difference in power density of about 20% from a location 5 nautical miles (NM) offshore to one 10 NM offshore, which represents an increment of 20% -25% in energy production depending on the particular wind turbine capacity factor. (C) 2017 Elsevier Ltd. All rights reserved.