The parameterization of the energy balance from a residential and commercial neighborhood of Mexico City was investigated using direct measurements of radiative and heat fluxes carried out during the MILAGRO/MCMA-2006 field campaign as a reference. The measured fluxes were used to evaluate different models of the energy balance based on parameterizations that require standard meteorological observations: ambient temperature, relative humidity, atmospheric pressure and cloudiness. It was found that these models reproduce with reasonable accuracy the diurnal features of the radiative and heat fluxes. The largest differences between modeled and observed fluxes correspond to the incoming longwave radiation, mainly due to errors in the cloudiness data. This paper contributes to the understanding of the energy partitioning in (sub)tropical urban environments, particularly in the developing world, where energy balance models have not been evaluated.

The Canopy Horizontal Array Turbulence Study (CHATS) took place in spring 2007 and is the third in the series of Horizontal Array Turbulence Study (HATS) experiments. The HATS experiments have been instrumental in testing and developing subfilterscale (SFS) models for large-eddy simulation (LES) of planetary boundary layer (PBL) turbulence. The CHATS campaign took place in a deciduous walnut orchard near Dixon, California, and was designed to examine the impacts of vegetation on SFS turbulence. Measurements were collected both prior to and following leafout to capture the impact of leaves on the turbulence, stratification, and scalar source/sink distribution. CHATS utilized crosswind arrays of fast-response instrumentation to investigate the impact of the canopy-imposed distribution of momentum extraction and scalar sources on SFS transport of momentum, energy, and three scalars. To directly test and link with PBL parameterizations of canopy-modified turbulent exchange, CHATS also included a 30-m profile tower instrumented with turbulence instrumentation, fast and slow chemical sensors, aerosol samplers, and radiation instrumentation. A highresolution scanning backscatter lidar characterized the turbulence structure above and within the canopy; a scanning Doppler lidar, mini sodar/radio acoustic sounding system (RASS), and a new helicopter-observing platform provided details of the PBL-scale flow. Ultimately, the CHATS dataset will lead to improved parameterizations of energy and scalar transport to and from vegetation, which are a critical component of global and regional land, atmosphere, and chemical models. This manuscript presents an overview of the experiment, documents the regime sampled, and highlights some preliminary key findings.

A significant fraction of Earth consists of mountainous terrain. However, the question of how to monitor the surface–atmosphere carbon exchange over complex terrain has not been fully explored. This article reports on studies by a team of investigators from U.S. universities and research institutes who carried out a multiscale and multidisciplinary field and modeling investigation of the CO2 exchange between ecosystems and the atmosphere and of CO2 transport over complex mountainous terrain in the Rocky Mountain region of Colorado. The goals of the field campaign, which included ground and airborne in situ and remote-sensing measurements, were to characterize unique features of the local CO2 exchange and to find effective methods to measure regional ecosystem–atmosphere CO2 exchange over complex terrain. The modeling effort included atmospheric and ecological numerical modeling and data assimilation to investigate regional CO2 transport and biological processes involved in ecosystem–atmosphere carbon exchange. In this report, we document our approaches, demonstrate some preliminary results, and discuss principal patterns and conclusions concerning ecosystem–atmosphere carbon exchange over complex terrain and its relation to past studies that have considered these processes over much simpler terrain.

Synthetic pheromones and other behavioral chemicals are used by land managers to prevent insect-caused tree mortality or crop failure in forest and agricultural systems. Currently, no method exists to continuously measure pheromone concentration or movement in real-time. To improve our understanding of pheromone fate and transport under different forest canopies, results from a set of surrogate pheromone (sulfur hexafluoride tracer) experimental trials were used to evaluate a simple, instantaneous, three-dimensional Lagrangian dispersion model. The model was designed to predict both instantaneous and time-averaged pheromone concentrations. Overall, the results from the model show simulated time-averaged arc maximum concentrations within a factor of two of the observed data. The model correctly matched the sharp peaks and narrow widths of the meandering plumes observed in the instantaneous data, however the magnitude of the instantaneous peaks was often under-estimated. This model and evaluation provide the basis for a tool that can be used to guide deployment of synthetic pheromones or other semiochemicals for monitoring, mass trapping, or disruption of mating or aggregation.

An atmospheric tracer dispersion study known as Joint Urban 2003 was conducted in Oklahoma City, Oklahoma, during July of 2003. As part of this field program, vertical concentration profiles were measured at approximately 1 km from the downtown ground-level tracer gas release locations. These profiles showed that the urban landscape was very effective in mixing the plume vertically. In general, the lowest concentration measured along the profile was within 50% of the highest concentration in any given 5-min measurement period. The general slope of the concentration profiles was bounded by a Gaussian distribution with Briggs's urban equations (stability classes D and E/F) for vertical dispersion. However, measured concentration maxima occurred at levels above the surface, which would not be predicted by Gaussian formulations. Variations in tracer concentration observed in the time series between different release periods were related to changes in wind direction as opposed to changes in turbulence. This was demonstrated using data from mobile analyzers that captured the width of the plume by traveling east to west along nearby streets. These mobile-van-analyzer data were also used to compute plume widths. Plume widths increased for wind directions at larger angles to the street grid, and a simple model comprising adjusted open-country dispersion coefficients and a street channeling component, were used to describe the measured widths. This dispersion dataset is a valuable asset not only for developing advanced tools for emergency-response situations in the event of a toxic release but also for refining air-quality models.

Volatile organic compounds (VOC) are a key piece in understanding photochemical air quality in urban atmospheres. In the presence of sunlight and nitrogen oxides (NOx), VOC are oxidized to carbon dioxide and water via various intermediates: radicals (e.g., hydroxyl, hydroperoxy, organic peroxy), oxygentated organics (e.g., aldehydes, acids, alcohols, nitrates, peroxides), and inorganics (e.g., carbon monoxide, ozone, hydrogen peroxide, nitric acid). A number of VOC are also identified as toxic air pollutants and may have significant direct health impacts in urban areas. Measurements of VOC are thus necessary for future control efforts to improve the standard of life of millions of people living in extremely polluted cities, such as the Mexico City Metropolitan Area (MCMA). In the MCMA in the last decade, important changes have been implemented to improve air quality. Even with these changes, the pollutant levels remain among the highest in the world.

A modeling system has been developed relying on plume diffusion theory to yield the upwind source area and emissions responsible for a measured downwind concentration. Three steps comprise this modeling strategy. Application of the MM5 meteorological model to yield a regional wind field, processing of the wind field through the Models-3/CMAQ meteorological processor (MCIP), inversion of the resulting wind field, and finally application of the CALPUFF puff dispersion model to the inverted wind field. In this manner, plume dispersion theory is applied to map the upwind pollutant source area (source-footprint) for a measured downwind concentration. This method has been applied to the Boston, MA area for a period in May of 1999 when the Urban Respiration and Trace Gas Metabolism project was conducting field studies in the south Boston area. An emission inventory was obtained from the Massachusetts Department of Environmental Quality and correlated with the inverted CALPUFF plume to yield the fractional source contribution of the downwind sources to a receptor in urban Boston, MA. The data indicate that 92% of the impacting emissions come from within a radius of 30 km and that over a 5 hour period emissions from Connecticut and Rhode Island also influenced the Boston area.