ASTEP 400, the main instrument of the ASTEP (Antarctica Search for Transiting ExoPlanets) programme, is a 40 cm telescope, designed to withstand the harsh conditions in Antarctica, achieving a photometric accuracy of a fraction of millimagnitude on hourly time-scales for planet-hosting southern bright (R = 12 mag) stars. We review the performances of this instrument, describe its operating conditions, and present results from the analysis of observations obtained during its first three years (2010-2012) of operation, before its repatriation in 2014. During this time, we observed a total of 22 stellar fields (1A degrees x 1A degrees field of view). Each field, in which we measured stars up to magnitude R = 18 mag, was observed continuously during =7 to =30 d. More than 200 000 frames were recorded and 310 000 stars processed, using an implementation of the optimal image subtraction photometry algorithm. We found 43 planetary transit candidates. 20 of these candidates were observed using spectroscopic follow-ups including four targets classified as good planet candidates. Our results demonstrate that accurate near-continuous photometric observations are achievable from the Concordia station at Dome C in Antarctica, even if we were not able to reach the nominal photometric precision of the instrument. We conducted a correlation analysis between the rms noise and a large number of external parameters and found that source of the =1 mmag correlated noise is not obvious and does not depend on a single parameter. However, our analysis provided some hints and guidance to increase the photometric accuracy of the instrument. These improvements should equip any future telescope operating in Antarctica.

ASTEP (Antarctica Search for Transiting ExoPlanets) is a pilot project that aims at searching and characterizing transiting exoplanets from Dome C in Antarctica and to qualify this site for photometry in the visible. Two instruments were installed at Dome C and ran for six winters in total. The analysis of the collected data is nearly complete. We present the operation of the instruments, and the technical challenges, limitations, and possible solutions in light of the data quality. The instruments performed continuous observations during the winters. Human interventions are required mainly for regular inspection and ice dust removal. A defrosting system is efficient at preventing and removing ice on the mirrors. The PSF FWHM is 4.5 arcsec on average which is 2.5 times larger than the specification, and is highly variable; the causes are the poor ground-level seeing, the turbulent plumes generated by the heating system, and to a lower extent the imperfect optical alignment and focusing, and some astigmatism. We propose solutions for each of these aspects that would largely increase the PSF stability. The astrometric and guiding precisions are satisfactory and would deserve only minor improvements. Major issues are encountered with the camera shutter which did not close properly after two winters; we minimized this issue by heating the shutter and by developing specific image calibration algorithms. Finally, we summarize the site testing and science results obtained with ASTEP. Overall, the ASTEP experiment will serve as a basis to design and operate future optical and near-infrared telescopes in Antarctica.

The installation and operation of a telescope in Antarctica represent particular challenges, in particular the requirement to operate at extremely cold temperatures, to cope with rapid temperature fluctuations and to prevent frosting. Heating of electronic subsystems is a necessity, but solutions must be found to avoid the turbulence induced by temperature fluctuations on the optical paths. ASTEP 400 is a 40 cm Newton telescope installed at the Concordia station, Dome C since 2010 for photometric observations of fields of stars and their exoplanets. While the telescope is designed to spread star light on several pixels to maximize photometric stability, we show that it is nonetheless sensitive to the extreme variations of the seeing at the ground level (between about 0"1 and 5") and to temperature fluctuations between -30 degrees C and -80 degrees C. We analyze both day-time and night-time observations and obtain the magnitude of the seeing caused by the mirrors, dome and camera. The most important effect arises from the heating of the primary mirror which gives rise to a mirror seeing of 0".23K(-1). We propose solutions to mitigate these effects. (C) 2015 WILEY-VCH Verlag GmbH& Co. KGaA, Weinheim

Observing sites at the East-Antarctic plateau are considered to provide exceptional conditions for astronomy. The aim of this work is to assess its potential for detecting transiting extrasolar planets through a comparison and combination of photometric data from Antarctica with time series from a midlatitude site. During 2010, the two small aperture telescopes ASTEP 400 (Dome C) and BEST II (Chile) together performed an observing campaign of two target fields and the transiting planet WASP-18b. For the latter, a bright star, Dome C appears to yield an advantageous signal-to-noise ratio. For field surveys, both Dome C and Chile appear to be of comparable photometric quality. However, within two weeks, observations at Dome C yield a transit detection efficiency that typically requires a whole observing season in Chile. For the first time, data from Antarctica and Chile have been combined to extent the observational duty cycle. This approach is both feasible in practice and favorable for transit search, as it increases the detection yield by 12-18%.

The ASTEP (Antarctica Search for Transiting ExoPlanets) program was originally aimed at probing the quality of the Dome C, Antarctica for the discovery and characterization of exoplanets by photometry. In the first year of operation of the 40 cm ASTEP 400 telescope (austral winter 2010), we targeted the known transiting planet WASP-19b in order to try to detect its secondary transits in the visible. This is made possible by the excellent sub-millimagnitude precision of the binned data. The WASP-19 system was observed during 24 nights in May 2010. The photometric variability level due to starspots is about 1.8% (peak-to-peak), in line with the SuperWASP data from 2007 (1.4%) and larger than in 2008 (0.07%). We find a rotation period of WASP-19 of 10.7 +/- 0.5 days, in agreement with the SuperWASP determination of 10.5 +/- 0.2 days. Theoretical models show that this can only be explained if tidal dissipation in the star is weak, i.e. the tidal dissipation factor Q'star > 3.10^7. Separately, we find evidence for a secondary eclipse of depth 390 +/- 190 ppm with a 2.0 sigma significance, a phase consistent with a circular orbit and a 3% false positive probability. Given the wavelength range of the observations (420 to 950 nm), the secondary transit depth translates into a day side brightness temperature of 2690(-220/+150) K, in line with measurements in the z' and K bands. The day side emission observed in the visible could be due either to thermal emission of an extremely hot day side with very little redistribution of heat to the night side, or to direct reflection of stellar light with a maximum geometrical albedo Ag=0.27 +/- 0.13. We also report a low-frequency oscillation well in phase at the planet orbital period, but with a lower-limit amplitude that could not be attributed to the planet phase alone, and possibly contaminated with residual lightcurve trends.

The ASTEP project aims at detecting and characterizing transiting planets from Dome C, Antarctica, and qualifying this site for photometry in the visible. The first phase of the project, ASTEP South, is a fixed 10 cm diameter instrument pointing continuously towards the celestial South pole. Observations were made almost continuously during 4 winters, from 2008 to 2011. The point-to-point RMS of 1-day photometric lightcurves can be explained by a combination of expected statistical noises, dominated by the photon noise up to magnitude 14. This RMS is large, from 2.5 mmag at R=8 to 6 the small size of ASTEP South and the short exposure time (30 s). Statistical noises should be considerably reduced using the large amount of collected data. A 9.9-day period eclipsing binary is detected, with a magnitude R=9.85. The 2-season lightcurve folded in phase and binned into 1000 points has a RMS of 1.09 mmag, for an expected photon noise of 0.29 mmag. The use of the 4 seasons of data with a better detrending algorithm should yield a sub-millimagnitude precision for this folded lightcurve. Radial velocity follow-up observations are conducted and reveal a F-M binary system. The detection of this 9.9-day period system with a small instrument such as ASTEP South and the precision of the folded lightcurve show the quality of Dome C for continuous photometric observations, and its potential for the detection of planets with orbital period longer than those usually detected from the ground.

The ASTEP program is dedicated to exo-planet transit search from the Concordia Station located at Dome C, Antarctica. It comprises two instruments: a fixed 10cm refractor pointed toward the celestial South Pole, and a 400mm Newton telescope with a 1x1 degree field of view. This work focuses on the latter instrument. It has been installed in November 2009, and has been observing since then during the two polar winters 2010 and 2011. After presenting the main science observing programs, we review the telescope installation, performance, and describe its operating conditions as well as the data reduction and handling strategy. The resulting lightcurves are generally very stable and of excellent quality, as shown by continuous observations of WASP-19 that we present here.

Abstract ASTEP (Antarctic Search for Transiting Exo Planets) is a research program funded mainly by French ANR grants and by the French Polar Institute (IPEV), dedicated to the photometric study of exoplanetary transits from Antarctica. The preliminary “pathfinder” instrument ASTEP–South is described in another communication (Crouzet et al., these proceedings), and we focus in this presentation on the main instrument of the ASTEP program: “ASTEP–400”, a 40 cm robotized and thermally-controlled photometric telescope operated from the French-Italian Concordia station (Dome C, Antarctica). ASTEP–400 has been installed at Concordia during the 2009-2010 summer campaign. Since, the telescope has been operated in nominal conditions during 2010 and 2011 winters, and the 2012 winterover is presently in progress. Data from the first two winter campaigns are available and processed. We give a description of the ASTEP–400 telescope from the mechanical, optical and thermal point of view. Control and software issues are also addressed. We end with a discussion of some astronomical results obtained with ASTEP–400.

An abstract is not available for this content so a preview has been provided. As you have access to this content, a full PDF is available via the ‘Save PDF’ action button.