Post-mega-earthquake geochemical and microbiological properties in subseafloor sediments of the Japan Trench accretionary wedge were investigated using core samples from Hole C0019E, which was drilled down to 851 m below seafloor (mbsf) at a water depth of 6,890 m. Methane was abundant throughout accretionary prism sediments; however, its concentration decreased close to the plate boundary decollement. Methane isotope systematics indicated a biogenic origin. The content of mole-cular hydrogen (H2) was low throughout core samples, but markedly increased at specific depths that were close to potential faults predicted by logging-while-drilling ana-lyses. Based on isotopic systematics, H2 appeared to have been abundantly produced via a low-temperature interaction between pore water and the fresh surface of crushed rock induced by earthquakes. Subseafloor microbial cell density remained constant at approximately 105 cells mL-1. Amplicon sequences revealed that predominant members at the phylum level were common throughout the units tested, which also included members frequently found in anoxic subseafloor sediments. Metabolic potential assays using radioactive isotopes as tracers revealed homoacetogenic activity in H2-enriched core samples collected near the fault. Furthermore, homoacetogenic bacteria, including Acetobacterium carbinolicum, were isolated from similar samples. Therefore, post-earthquake subseafloor microbial communities in the Japan Trench accretionary prism appear to be episodically dominated by homoacetogenic populations and potentially function due to the earthquake-induced low-temperature generation of H2. These post-earthquake microbial communities may eventually return to the steady-state communities dominated by oligotrophic heterotrophs and hydrogenotrophic and methylotrophic methanogens that are dependent on refractory organic matter in the sediment.
Despite earning half of all science and engineering undergraduate degrees between 2007 and 2016 in the USA, women were awarded only 39% of earth science degrees in the same time period. In order to better understand why women are both choosing and staying in geology programs, we conducted a multi-case study of nine current female undergraduate geology majors at a large public university in the USA within a department that is at gender parity among its undergraduate majors. The main data source was audio-recorded critical incident interviews of each participant. Data from the interviews were analyzed through an iterative coding process using codes adapted from previous studies that focused on factors both internal and external to the department. The students said that personal interests, influence by others outside of the department, and introductory classes attracted them to the geology program, but once declared, departmental factors such as relationship with faculty caused them to stay. We also found an emphasis on female role models, especially those teaching introductory courses. We believe this study offers important insights into the ways in which factors leading to recruitment and retention play out in the lived experiences of female geology majors.
Logging data are measurements of physical properties of the formation surrounding a borehole, acquired in situ after completion of coring (wireline logging) or during drilling (Logging-While-Drilling, LWD). The range of data (resistivity, gamma radiation, velocity, density, borehole images,…) in any hole depends on the scientific objectives and operational constraints.
Logging data are measurements of physical properties of the formation surrounding a borehole, acquired in situ after completion of coring (wireline logging) or during drilling (Logging-While-Drilling, LWD). The range of data (resistivity, gamma radiation, velocity, density, borehole images,…) in any hole depends on the scientific objectives and operational constraints.
We emphasize the importance of marine silicate weathering (MSiW) reactions in anoxic sediment as fundamental in generating alkalinity and cations needed for carbonate precipitation and preservation along continental margins. We use a model that couples thermodynamics with aqueous geochemistry to show that the CO2 released during methanogenesis results in a drop in pH to 6.0; unless these protons are buffered by MSiW, carbonate minerals will dissolve. We present data from two regions: the India passive margin and the active subduction zone off Japan, where ash and/or rivers supply the reactive silicate phase, as reflected in strontium isotope data. Offshore India and Korea, alteration of continent-derived silicates results in pore water enriched in radiogenic Sr-87, with Sr-87/Sr-86 ratios as high as 0.7095 and 0.7104, respectively. Off Japan, strontium in pore water influenced by ash alteration is depleted in Sr-87, with Sr-87/Sr-86 as low as 0.7065. Carbonate minerals formed by alkalinity and cations generated through MSiW carry these strontium isotopic signals, and are typically dolomite, siderite, and Fe-rich calcite. These contrast with the aragonite and high-magnesium calcite that form during anaerobic oxidation of methane and incorporate the coeval seawater Sr-87/Sr-86 signal. We show that MSiW is necessary for authigenic carbonate formation and preservation along continental margins, which remove carbon from Earth's surface at rates previously estimated to be at least 10(12) mol yr(-1). In addition, these authigenic carbonates are of relevance to studies of the deep biosphere, fluid flow, seismogenesis, slope stability, and reservoir characteristics.
Logging data are measurements of physical properties of the formation surrounding a borehole, acquired in situ after completion of coring (wireline logging) or during drilling (Logging-While-Drilling, LWD). The range of data (resistivity, gamma radiation, velocity, density, borehole images,…) in any hole depends on the scientific objectives and operational constraints.
We emphasize the importance of marine silicate weathering (MSiW) reactions in anoxic sediment as fundamental in generating alkalinity and cations needed for carbonate precipitation and preservation along continental margins. We use a model that couples thermodynamics with aqueous geochemistry to show that the CO2 released during methanogenesis results in a drop in pH to 6.0; unless these protons are buffered by MSiW, carbonate minerals will dissolve. We present data from two regions: the India passive margin and the active subduction zone off Japan, where ash and/or rivers supply the reactive silicate phase, as reflected in strontium isotope data. Offshore India and Korea, alteration of continent-derived silicates results in pore water enriched in radiogenic Sr-87, with Sr-87/Sr-86 ratios as high as 0.7095 and 0.7104, respectively. Off Japan, strontium in pore water influenced by ash alteration is depleted in Sr-87, with Sr-87/Sr-86 as low as 0.7065. Carbonate minerals formed by alkalinity and cations generated through MSiW carry these strontium isotopic signals, and are typically dolomite, siderite, and Fe-rich calcite. These contrast with the aragonite and high-magnesium calcite that form during anaerobic oxidation of methane and incorporate the coeval seawater Sr-87/Sr-86 signal. We show that MSiW is necessary for authigenic carbonate formation and preservation along continental margins, which remove carbon from Earth's surface at rates previously estimated to be at least 10(12) mol yr(-1). In addition, these authigenic carbonates are of relevance to studies of the deep biosphere, fluid flow, seismogenesis, slope stability, and reservoir characteristics.
Earthquakes occur by overcoming fault friction; therefore, quantifying fault resistance is central to earthquake physics. Values for both static and dynamic friction are required, and the latter is especially difficult to determine on natural faults. However, large earthquakes provide signals that can determine friction in situ. The Japan Trench Fast Drilling Project (JFAST), an Integrated Ocean Discovery Program expedition, determined stresses by collecting data directly from the fault 1–2 years after the 2011 Mw 9.1 Tohoku earthquake. Geological, rheological, and geophysical data record stress before, during, and after the earthquake. Together, the observations imply that the shear strength during the earthquake was substantially below that predicted by the traditional Byerlee's law. Locally the stress drop appears near total, and stress reversal is plausible. Most solutions to the energy balance require off-fault deformation to account for dissipation during rupture. These observations make extreme coseismic weakening the preferred model for fault behavior. ▪ Determining the friction during an earthquake is required to understand when and where earthquakes occur. ▪ Drilling into the Tohoku fault showed that friction during the earthquake was low. ▪ Dynamic friction during the earthquake was lower than static friction. ▪ Complete stress drop is possible, and stress reversal is plausible.
The western margin of Myanmar is the northern extension the active Sunda (India-Eurasia) subduction zone. Coastal regions and offshore islands have remarkable exposures of chaotic rock terranes along wave-cut terraces that allow characteristics of tectonic, sedimentary and diapiric melanges to be recognized. Tectonic shear zones (tectonic melanges) contain fragments of Cretaceous ophiolites (chrome-spinet-beating peridotites and radiolarian cherts) that are in contact with thrust packets of Eocene turbidite units (broken formations). The turbidites contain shale-rich beds that have been sheared during soft-sediment deformation (sedimentary broken formations) and arc sandwiched between undeformed thick sandy beds. These arc mass transport deposits (MTDs) that most likely formed during deposition of the initial detritus of the Himalayan orogenic zone, probably trench slope basins on the accretionary prism. The ophiolitic and turbiditic thrust slices have been exhumed and arc currently being intruded by active mud volcanoes that bring fragments of units up from depth to the surface, forming diapiric melanges. These diapiric melange bodies contain only small fragments (<50 cm) that arc randomly oriented and do not exhibit shear fabrics. Because the region lacks superimposed deformation characteristic of most orogenic belts, the origins of all three rock bodies can easily be distinguished. (C) 2019 International Association for Gondwana Research. Published by Elsevier B.V. All tights reserved.
Information about diagenetic processes and temperatures during burial of sediments entering the subduction zone is important for understanding changes in physical properties and seismic behavior during deformation. The geochemistry of authigenic carbonates from accretionary prisms can serve as proxies for conditions during carbonate cementation and resultant lithification. We report results from the Nankai accretionary prism recovered from Integrated Ocean Drilling Program (IODP) sites C0011 and C0012 and we document continued cementation of deep sediment sections prior to subduction. Elemental and isotope data provide evidence for complex mixing of different isotopic reservoirs in pore waters contributing to carbonate chemical signatures. Carbon stable isotope values exhibit a broad range (δ13CV-PDB=+0.1‰ to −22.5‰) that corresponds to different stages of cement formation during burial. Carbonate formation temperatures from carbonate-clumped isotope geochemistry range from 16°C to 63°C at Site C0011 and 8.7°C to 68°C at Site C0012. The correspondence between the clumped-isotope temperatures and extrapolations of measured in situ temperatures indicate the carbonate is continuing to form at present. Calculated water isotopic compositions are in some cases enriched in 18O relative to measured interstitial waters suggesting a component of inherited seawater or input from clay-bound water. Low oxygen isotope values and the observed Ba/Ca ratios are also consistent with carbonate cementation at depth. Strontium isotopes of interstitial waters (87Sr/86Sr of 0.7059–0.7069) and carbonates (87Sr/86Sr of 0.70715–0.70891) support formation of carbonates from a mixture of strontium reservoirs including current interstitial waters and relic seawater contemporaneous with deposition. Collectively our data reflect mixed sources of dissolved inorganic carbon and cations that include authigenic phases driven by organic carbon and volcanic alteration reactions. Physical properties of input sediments continue to undergo modification by carbonate cementation at present. Due to ongoing recrystallization, temperatures from carbonate-clumped isotopes reflect the modern geothermal gradient and may serve as useful measures of geothermal gradients in other siliciclastic basins where carbonate cementation occurs. We conclude that clumped-isotope signatures in authigenic carbonates from accretionary prisms are important proxies for the timing and conditions of cementation in active margins. Our results highlight the importance of using multi-proxy approaches to elucidate the history of carbonate cementation, particularly to establish carbonate precipitation at depth and its potential impact on the physical and mechanical properties of the sediment prior to subduction.
Water properties change with confinement within nanofilms trapped between natural charged clay particles. We investigated nanofilm characteristics through high-stress laboratory compression tests in combination with analyses of expelled pore fluids. We utilized sediments obtained from deep drilling of the Nankai subduction zone at Site C0002 of the Integrated Ocean Drilling Program (IODP). We show that below 1-2 km, there should be widespread ultrafiltration of migrating fluids. Experiments to >similar to 100MPanormal compression collapse pores below a few ion monofilm thicknesses. A reduction towards a single condensing/dehydrating ion monofilm occurs as stresses rise > 100-200MPa and clay separations are reduced to < 10-20 angstrom. Thus, porosity in high mineral surface area systems only consists of double and single monofilms at depths below a few km leaving little room for either bulk water or the deep biosphere. The resulting semipermeable properties result in variable segregation of ions and charged isotopes and water during active flow. The ultrafiltration and ion dehydration processes are coupled in that both require the partial immobilization of ions between the charged clay surfaces. The general effect is to increase salinities in residual pore fluids at depth and freshen fluids expelled during consolidation. Cessation of nanofilm collapse to a near constant similar to 17 angstrom below 2 km depth at Nankai supports the contention for the onset of substantial geopressuring on the deeper seismogenic fault. The properties of monofilm water, thus, have considerable implications for the deep water properties of subduction zones generating major tremor and Mw 8+ earthquakes. Indeed, the combined effects of advective flow, ultrafiltration, diffusion, and diagenesis could provide a unifying explanation for the origins of overpressuring and pore water geochemical signals observed in many natural systems. (C) 2017 Elsevier B. V. All rights reserved.