Micellar solubilization is an important concept in the delivery of poorly water-soluble drugs. The rational selection of the type and the amount of surfactant to be incorporated in a formulation require comprehensive solubility studies. These studies are time and material demanding, both of which are scarce, especially during late discovery and early development stages. We hypothesized that, if the solubilization mechanism or molecular interaction is similar, the solubilization capacity ratio (a newly defined parameter) is dictated by micellar structures, independent of drugs. We tested this hypothesis by performing solubility studies using 8 commonly used nonionic surfactants and 17 insoluble compounds with diverse characteristics. The results show a striking constant solubilization capacity ratio among the 8 nonionic surfactants, which allow us to develop predictive solubility models for both single and mixed surfactant systems. The vast majority of the predicted solubility values, using our developed models, fall within 2-fold of the experimentally determined values with high correlation coefficients. As expected, systems involving ionic surfactant sodium dodecyl sulfate, used as a negative control, do not follow this trend. Deviations from the model, observed in this study or envisioned, were discussed. In conclusion, we have established predictive models that are capable of predicting solubility in a wide range of nonionic micellar solutions with only 1 experimental measurement. The application of such a model will significantly reduce resource and greatly enhance drug product development efficiency.

Many enabling formulations give rise to supersaturated solutions wherein the solute possesses higher thermodynamic activity gradients than the solute in a saturated solution. Since flux across a membrane is driven by solute activity rather than concentration, understanding how solute thermodynamic activity varies with solution composition, particularly in the presence of solubilizing additives, is important in the context of passive absorption.

Amorphous solid dispersions (ASDs) give rise to supersaturated solutions (solution concentration greater than equilibrium crystalline solubility). We have recently found that supersaturating dosage forms can exhibit the phenomenon of liquid-liquid phase separation (LLPS). Thus, the high supersaturation generated by dissolving ASDs can lead to a two-phase system wherein one phase is an initially nanodimensioned and drug-rich phase and the other is a drug-lean continuous aqueous phase. Herein, the membrane transport of supersaturated solutions, at concentrations above and below the LLPS concentration has been evaluated using a side-by-side diffusion cell. Measurements of solution concentration with time in the receiver cell yield the flux, which reflects the solute thermodynamic activity in the donor cell. As the nominal concentration of solute in the donor cell increases, a linear increase in flux was observed up to the concentration where LLPS occurred. Thereafter, the flux remained essentially constant. Both nifedipine and felodipine solutions exhibit such behavior as long as crystallization is absent. This suggests that there is an upper limit in passive membrane transport that is dictated by the LLPS concentration. These results have several important implications for drug delivery, especially for poorly soluble compounds requiring enabling formulation technologies.