Twenty-five new 40Ar/39Ar ages from volcanic rocks and veins in the western San Juan Mountains clarify relationships between volcanism and mineralization in this classic area. Five calc-alkaline ash-flow sheets erupted from caldera sources (Ute Ridge, Blue Mesa, Dillon Mesa, Sapinero Mesa, and Crystal Lake Tuffs) from 28.6 to 27.6 Ma. This is a much more restricted time interval than previously thought and indicates that the underlying batholith rose and evolved very rapidly beneath the western San Juan Mountains. The new ages and geologic relations constrain the timing of joint resurgence of the Uncompahgre and San Juan calderas to between 28.2 and 27.6 Ma. The collapse of the Silverton caldera produced a set of strong ring fractures that intersected with graben faults on the earlier resurgent dome to produce the complex set of structures that localized the mid-Miocene epithermal gold veins. Later calc-alkaline monzonitic to quartz monzontic plutons solidified at 26.5-26.0 Ma as the underlying batholith rose through its volcanic cover. A new age from lavas near Uncompahgre Peak supports earlier interpretations that these lavas were fed by nearby 26 Ma monzonite intrusions. Nearly all of these intrusions are associated with subeconomic Mo and Cu mineralization and associated alteration, and new ages of 26.40 and 25.29 Ma from the Ute-Ulay and Lilly veins in the Lake City region show that some of the most important silver and base-metal veins were temporally and possibly genetically connected to these plutons. In addition, the Golden Fleece telluride vein cuts all of the post-Uncompahgre caldera volcanics in the area and is probably temporally related to this cycle, though its age of 27.5 ? 0.3 Ma was determined by less precise U/Pb methods. The 22.9 Ma Lake City caldera collapsed within the older Uncompahgre caldera structure but is petrologically unrelated to the older calc-alkaline activity. The distinctive suite of high-silica rhyolite tuff and alkaline resurgent intrusions indicates that it is closely related to the early stages of bimodal high-silica rhyolite-alkali basalt volcanism that accompanied the onset of extensional tectonism in the region. Both 40Ar/39Ar ages and paleomagnetic data confirm that the entire caldera sequence formed in less than 330,000 years. Only weak quartz vein mineralization is present in the center of the caldera, and it appears to be related to leaching of metals from the intracaldera tuffs above the resurgent intrusion. Massive alunitization and weak Mo and Cu mineralization along the eastern ring fracture are associated with calc-alkaline lavas and stocks related to late stages of the caldera cycle. These calc-alkaline stocks also appear to be genetically and temporally linked to a radial pattern of barite-precious metal veins on the northeastern margin of the Lake City caldera.

Most of the geothermal resource of Utah is in the eastern part of the Basin and Range physiographic province and the adjacent transition zone with the Middle Rocky Mountains and Colorado Plateau physiographic provinces. The high-temperature part of this resource is in an area of about 25,000 km2 in the southwestern part of the state. At least seven hydrothermal systems with reservoir temperatures ranging from 97°C to more than 250°C have been identified in this area. Hot water and steam from two of these high-temperature systems, Roosevelt Hot Springs and Cove Fort - Sulphurdale, are being used to generate electricity, and another system, Newcastle, has been developed for space heating. From Precambrian through Jurassic time a thick sequence of sedimentary rocks was deposited over the region, and these rocks form the cores of most of the ranges. Some of these rocks have been metamorphosed. Most of the exposed pre-Tertiary rocks are in overthrust sheets of the Cretaceous Sevier orogenic belt. The rocks underlying these overthrust sheets are only occasionally exposed. Cenozoic volcanic and intrusive rocks are abundant in the southern part of the area and in a north-trending zone in the northern part, Calderas and other volcanic structures are associated with Cenozoic igneous rocks. The basin and range structures that produced the present topography developed in Neogene time. Cenozoic sedimentary rocks, locally over 1,000 m thick, underlie most of the valleys. Evidence of young volcanic activity includes rhyolites as young as 400,000 years, basalt flows less than 1,000 years old, and possibly the arching of 15,000 year old Lake Bonneville shorelines. With the exception of Newcastle, all of the known high-temperature systems are reflected at the surface. Some of the geothermal systems appear to involve primarily hydrothermal convection along normal fault zones in areas of relatively high thermal gradients associated with high regional heatflow. Other systems appear to be related to local heat sources associated with recent igneous activity. Reservoir rocks include all of the major rock types of the region. The geothermal systems have been extensively explored by a variety of surface and subsurface techniques. Much of the information on these geothermal systems was obtained through programs supported by federal and state government agencies and is thus available to the public. Important information on some of the systems obtained by industry is also available to the public.

AbstractThe M 6.2 Elmore Desert Ranch earthquake of 24 November 1987 was associated spatially and probably temporally with left-lateral surface rupture on many northeast-trending faults in and near the Superstition Hills in western Imperial Valley. Three curving discontinuous principal zones of rupture among these breaks extended northeastward from near the Superstition Hills fault zone as far as 9 km; the maximum observed surface slip, 12.5 cm, was on the northern of the three, the Elmore Ranch fault, at a point near the epicenter. Twelve hours after the Elmore Ranch earthquake, the M 6.6 Superstition Hills earthquake occurred near the northwest end of the right-lateral Superstition Hills fault zone. Surface rupture associated with the second event occurred along three strands of the zone, here named North and South strands of the Superstition Hills fault and the Wienert fault, for 27 km southeastward from the epicenter. In contrast to the left-lateral faulting, which remained unchanged throughout the period of investigation, the right-lateral movement on the Superstition hills fault zone continued to increase with time, a behavior that was similar to other recent historical surface ruptures on northwest-trending faults in the Imperial Valley region.We measured displacements over 339 days at as many as 296 sites along the Superstition Hills fault zone, and repeated measurements at 49 sites provided sufficient data to fit with a simple power law. Data for each of the 49 sites were used to compute longitudinal displacement profiles for 1 day and to estimate the final displacement that measured slips will approach asymptotically several years after the earthquakes. The maximum right-lateral slip at 1 day was about 50 cm near the south-central part of the North strand of Superstition Hills fault, and the predicted maximum final displacement is probably about 112 cm at Imler Road near the center of the South strand of the Superstition Hills fault. The overall distributions of right-lateral displacement at 1 day and the estimated final slip are nearly symmetrical about the midpoint of the surface rupture. The average estimated final right-lateral slip for the Superstition Hills fault zone is about 54 cm. The average left-lateral slip for the conjugate faults trending northeastward is about 23 cm.The southernmost ruptured member of the Superstition Hills fault zone, newly named the Wienert fault, extends the known length of the zone by about 4 km. The southern half of this fault, south of New River, expressed only vertical displacement on a sinuous trace. The maximum vertical slip by the end of the observation period there was about 25 cm, but its growth had not ceased. Photolineaments southeast of the end of new surface rupture suggest continuation of the Superstition Hills fault zone in farmland toward Mexico.

The Joe Lott Tuff Member of the Mount Belknap Volcanics is the largest rhyolitic ash-flow tuff sheet in the Marysvale volcanic field. It was erupted 19 m.y. ago, shortly after the changeover from intermediate-composition calc-alkalic volcanism to bimodal basalt-rhyolite volcanism. Eruption of the tuff resulted in the formation of the Mount Belknap Caldera whose pyroclastic intracaldera stratigraphy parallels that in the outflow facies. The Joe Loft Tuff Member is a composite ash-flow sheet that changes laterally from a simple cooling unit near the source to four distinct cooling units toward the distal end. The lowest of these units is the largest and most widespread; it is 64 m thick and contains a basal vitrophyre. Eruption of the lower unit led to the initial collapse of the caldera. The lower unit is followed upward by a 43 m middle unit, a 26 m pink-colored unit which is separated by a prominent air- fall layer, and a 31 m upper unit. The Joe Loft Tuff Member is an alkali rhyolite with 75.85-77.31 wt. % silica and 8.06-9.32 wt. % K2O+Na2O; the agpaitic index (Na2O+ K2O/Al2O3) is .77-.98. The tuff contains about I% phenocrysts of quartz, sanidine, oligoclase, augite, apatite, zircon, sphene, biotite, and oxidized Fe-Ti oxides. The basal vitrophyre contains accessory allanite, chevkinite, and magnesiohastingsite. The main cooling units are chemically and mineralogically zoned indicating that the magma chamber restratified prior to each major eruption. Within each of the two thickest cooling units, the mineralogy changes systematically upwards; the Or content and relative volume of sanidine decreases and An content of plagioclase increases. The basal vitrophyre of the lower unit has a bulk composition that lies in the thermal trough near the minima of Or-Ab-Q at 1 kb PH2O. Microprobe analyses of feldspar and chemical modeling on experimental systems indicate that pre-eruption temperatures were near 750?C and that the temperature increased during the eruption of the cooling units. The chemical gradients in the apatite and whole-rock data in the Joe Loft Tuff Member and the consistent mineral assemblages throughout the ash-flow cannot be explained by crystal settling. The fractionation of the Joe Lott Tuff Member appears to closer fit the model of convection-driven thermogravitational diffusion.