Site-specific management requires the identification of treatment areas based on homogeneous characteristics. This study aimed to determine whether soil mapping based on apparent soil electrical conductivity (ECa) is suitable for mapping soil properties of fields with topographic heterogeneity. Research was conducted on two neighbouring fields in Fejér county, Hungary, with contrasting topographic heterogeneity. To characterise the spatial variability of soil attributes, ECa was measured and supplemented by obtaining soil samples and performing soil profile analysis. The relationship between ECa and soil physical and chemical properties was analysed using correlation, principal component, and regression analyses. The research revealed that the quality and strength of the relationship between ECa and soil remarkably differed in the two studied fields. In homogeneous topographic conditions, ECa was weakly correlated with elevation as determined by soil physical texture and nutrient content in a strong (R2 = 0.72) linear model. On the other hand, ECa was significantly determined by elevation in heterogeneous topographic conditions in a moderate (R2 = 0.47) linear model. Consequently, ECa-based soil mapping can only be used to characterise the soil, thus delineating management zones under homogeneous topographic conditions.

Although herbicides are essential for global agriculture and controlling weeds, they impact soil microbial communities and CO2 emissions. However, the effects of herbicides, tillage systems, and nitrogen fertilisation on CO2 emissions under different environmental conditions are poorly understood. This review explores how various agricultural practices and inputs affect CO2 emissions and addresses the impact of pest-management strategies, tillage systems, and nitrogen fertiliser usage on CO2 emissions using multiple databases. Key findings indicate that both increased and decreased tendencies in greenhouse gas (GHG) emissions were observed, depending on the herbicide type, dose, soil properties, and application methods. Several studies reported a positive correlation between CO2 emissions and increased agricultural production. Combining herbicides with other methods effectively controls emissions with minimal chemical inputs. Conservation practices like no-tillage were more effective than conventional tillage in mitigating carbon emissions. Integrated pest management, conservation tillage, and nitrogen fertiliser rate optimisation were shown to reduce herbicide use and soil greenhouse gas emissions. Fertilisers are similarly important; depending on the dosage, they may support yield or harm the soil. Fertiliser benefits are contingent on appropriate management practices for specific soil and field conditions. This review highlights the significance of adaptable management strategies that consider local environmental conditions and can guide future studies and inform policies to promote sustainable agriculture practices worldwide.

This work aims to compare and statistically analyze Normalized Difference Vegetation Index (NDVI) values provided by GreenSeeker handheld crop sensor measurements and calculate NDVI values derived from the MicaSense RedEdge-MX Dual Camera, to predict in-season winter wheat (Triticum aestivum L.) yield, improving a yield prediction model with cumulative growing degree days (CGDD) and days from sowing (DFS) data. The study area was located in Mosonmagyaróvár, Hungary. A small-scale field trial in winter wheat was constructed as a randomized block design including Environmental: N-135.3, P2O5-77.5, K2O-0; Balance: N-135.1, P2O5-91, K2O-0; Genezis: N-135, P2O5-75, K2O-45; and Control: N, P, K 0 kg/ha. The crop growth was monitored every second week between April and June 2022 and 2023, respectively. NDVI measurements recorded by GreenSeeker were taken at three pre-defined GPS points for each plot; NDVI values based on the MicaSense camera Red and NIR bands were calculated for the same points. Results showed a significant difference (p ≤ 0.05) between the Control and treated areas by GreenSeeker measurements and Micasense-based calculated NDVI values throughout the growing season, except for the heading stage. At the heading stage, significant differences could be measured by GreenSeeker. However, remotely sensed images did not show significant differences between the treated and Control parcels. Nevertheless, both sensors were found suitable for yield prediction, and 226 DAS was the most appropriate date for predicting winter wheat’s yield in treated plots based on NDVI values and meteorological data.

Understanding the roles of natural drivers in greenhouse gas (GHG) emissions of arable fields is crucial for adequate agricultural management. This study investigated the combined effect of two tillage treatments (NT - no-tillage; CT - tillage with mouldboard ploughing) and environmental (air pressure, air temperature) and soil factors (total organic carbon, gravimetric water content and soil penetration resistance) on soil carbon dioxide (CO2) emissions in maize in 2020 and 2021. The soil tubes required for the laboratory measurement were derived from three different altitudes of the two differently cultivated fields from Fejér county, Hungary. The typical soil type was Chernozem in both fields. At the time of soil sampling, soil penetration resistance was measured with a 06.15SA Penetrologger in 10 repetitions. To preserve the moisture content of the soil columns during the investigation, moisture replenishment was performed equal to the degree of weekly theoretical evapotranspiration. Emissions measurements of soil columns were performed by close chamber technique for five weeks from sampling, 15 times, in 3 repetitions in laboratory conditions. The data were evaluated by two-way ANOVA, followed by the Tukey HSD multiple comparison test and two-tailed Student’s T-test at a significance level of p<0.05. The combined effect of environmental factors on soil carbon dioxide emissions was investigated using stepwise multiple linear regression. It has been proved that the observed difference between soil penetration resistance and soil carbon dioxide emissions was significant between CT and NT cultivation at different stages of the growing season. The analysis of the interaction of the experimental factors revealed that the combined effect of soil penetration resistance, total organic carbon and moisture content in tillage system (adjusted R2=0.92 at a significance level of p=0.05) in 2020, while the combined effect of moisture content and air temperature in the no-tillage system (adjusted R2=0.79 at a significance level of p=0.085) has the most significant effect on soil CO2 emissions in 2020. In 2021, the air temperature for the tillage system (adjusted R2=0.74 at a significance level of p=0.05) and the combined effect of air temperature and pressure for no-tillage systems (adjusted R2=0.69 at a significance level of p=0.1) played an important role in soil CO2 emissions. These observations highlight that different soil and environmental factors of different tillage significantly impact the soil carbon dioxide emissions in different years.

Abstract Agriculture faces several challenges to use the available resources in a more environmentally sustainable manner. One of the most significant is to develop sustainable water management. The modern Internet of Things (IoT) techniques with real-time data collection and visualisation can play an important role in monitoring the readily available moisture in the soil. An automated Arduino-based low-cost capacitive soil moisture sensor has been calibrated and developed for data acquisition. A sensor- and soil-specific calibration was performed for the soil moisture sensors (SKU:SEN0193 - DFROBOT, Shanghai, China). A Repeatability and Reproducibility study was conducted by range of mean methods on clay loam, sandy loam and silt loam soil textures. The calibration process was based on the data provided by the capacitive sensors and the continuously and parallelly measured soil moisture content by the thermogravimetric method. It can be stated that the response of the sensors to changes in soil moisture differs from each other, which was also greatly influenced by different soil textures. Therefore, the calibration according to soil texture was required to ensure adequate measurement accuracy. After the calibration, it was found that a polynomial calibration function (R2 ≥ 0.89) was the most appropriate way for modelling the behaviour of the sensors at different soil textures.