Gasochromic windows can change their transmittance over a wide range. This change is caused by a thin layer of tungsten oxide (WO3), covered by a very thin layer of platinum. Exposing this coating to diluted hydrogen gas leads to reduction of the WO3, resulting in colouring. This process can be reversed by introducing diluted oxygen.The hydrogen and oxygen are produced by an electrolyser. Only small amounts of gas are needed for the switching process. The coatings are produced by sputtering. Water is needed in the WO3 films to allow rapid transport of the hydrogen. However, this water should not escape when the system is operated at higher temperatures, which can exceed 60 degreesC. By adjusting the conditions of the sputtering process appropriately, a large amount of water can be incorporated in the films, which remains even up to temperatures above 100 degreesC.The best transmittance values obtained for a coated double-glazed unit with a moderate film thickness (560 nm) and hydrogen concentrations below the combustion limit are 76% and 77% for solar and visual transmittance, respectively, in the bleached state and 5% and 6% for solar and visual transmittance, respectively, in the coloured state. Darker states can be obtained by applying thicker films of tungsten oxide without reducing the transmittance in the bleached state.Gasochromic coatings can also be deposited easily on plastic substrates and-because their coating structure is so simple-combined with prismatic micro structures, which allow light to be redirected. In addition, the gasochromic systems technology can be used with metal hydride systems. (C) 2004 Elsevier B.V. All rights reserved.

A cosmid library of enterohemorrhagic Escherichia coli (EHEC) O157:H7 strain EDL 933 was constructed and clones carrying the stx2 gene were identified by colony blot hybridization with a stx2B specific probe. Nucleotide sequencing upstream of the stx2A gene revealed high sequence identities of 89.5% to the ileX tRNA gene found in E. coli. The ileX gene was located 260 bp from the translational start codon of stx2A. PCR analysis with primers specific for this analyzed region showed that in 11 Stx2-producing EHEC strains from patients with hemolytic uremic syndrome, all PCR-positive strains carried the ileX tRNA gene. However, PCR analysis of the respective region in 11 Stx1-producing EHEC strains detected no ileX genes. Although the role of ileX in Stx2-producing EHEC strains is not clear, its function in regard to the use of rare codons and as an integration site is discussed.

In this study, we determined the nucleotide sequence of the p gene contained within a 5-kb EcoRI restriction fragment cloned from Shiga-like toxin II (SLT-II)-converting phage 933W of Escherichia coli O157:H7 strain EDL933. The p gene was 702 bp long and had 95.3% sequence similarity to the p gene of phage lambda. Multiple hybridization patterns were obtained when genomic DNA fragments were hybridized with both p and slt-I, slt-II, or slt-IIc sequences. All O157 isolates also possessed an analog of lambda gene p which was not linked with either slt-I or slt-II. Restriction fragment length polymorphism comparisons of clinical O157 isolates and derivates undergoing genotype turnover during infection were made, and loss of large DNA fragments that hybridized with slt-II and p sequences was observed. To further analyze the DNA region containing the p and slt genes, we amplified fragments by using a PCR with one primer complementary to p and the other complementary to either the slt-I or the slt-II gene. PCR analysis with enterohemorrhagic E. coli O157 and non-O157 strains yielded PCR products that varied in size between 5.1 and 7.8 kb. These results suggest that even within O157 isolates, the genomes of SLT-converting phages differ. The methods described here may assist in further investigation of SLT-encoding phages and their role in the epidemiology of infection with enterohemorrhagic E. coli.

We examined 30 children with classical hemolytic-uremic syndrome (HUS) for the presence of enterohemorrhagic Escherichia coli (EHEC) strains in stool samples and determined the specific immune response to O157 lipopolysaccharide in acute-phase serum samples from these patients. EHEC O157 strains were isolated from stool samples of 18 (60%) of the patients, and non-O157 EHEC strains were isolated from 5 (17%) of the patients. For O157 strain isolation from stools, we introduced a selective enrichment step using O157-specific antibodies attached to paramagnetic particles (immunomagnetic separation [IMS] method). This procedure allowed the detection of O157 strains at 10(2) CFU/g of stool in the presence of 10(7) coliform background flora organisms. By using IMS followed by plating on sorbitol MacConkey (SMAC) agar and cefixime-tellurite SMAC (CT-SMAC) agar, O157 strains were detected in 18 samples, whereas colony hybridization detected a subset of 12 positive samples and direct culture on CT-SMAC or SMAC agar detected only 7. Three of the 18 O157-positive stools were negative by cytotoxicity assay performed with stool filtrates and by direct PCR with DNA extracted from stools. The IMS technique allowed the isolation of O157 strains from 18 of 20 patients with serological evidence for O157 infection. Apart from the increase in sensitivity in O157 detection compared with that of direct culture, the IMS technique also has the advantage of being less labor-intensive and less time-consuming than the molecular methods. IMS can therefore be considered an efficient method for wide-spread use in the detection of O157 strains in clinical microbiology laboratories. However, because a significant number of HUS cases were attributable to non-O157 EHEC serogroups, the use of additional methods besides IMS in the bacteriological diagnosis of HUS is necessary.

Among the Enterobacteriaceae, Proteus vulgaris is exceptional in the inducible production of a 29-kDa beta-lactamase (cefuroximase) with an unusually high activity towards the beta-lactamase-stable oximino-cephalosporins (e.g. cefuroxime and cefotaxime). Sequencing of the corresponding gene, cumA, showed that the derived CumA beta-lactamase belonged to the molecular class A. The structural gene was under the direct control of gene cumR, which was transcribed backwards and whose initiation codon was 165 bp away from that of the beta-lactamase gene. This resembled the arrangement of structural and regulator genes ampC and ampR of the 39-kDa molecular-class-C beta-lactamase AmpC present in many enterobacteria. Moreover, cloned genes ampD and ampG for negative modulation and signal transduction of AmpC beta-lactamase induction, respectively, were also able to restore constitutively CumA overproducing and non-inducible P. vulgaris mutants to the inducible, wild-type phenotype. The results indicate that controls of the induction phenomena are equivalent for the CumA and AmpC beta-lactamase. Very different structural genes can thus be under the control of identical systems.

The mobilizable plasmid pMD101 (ampR, ampC) was constructed by inserting cloned ampC, the structural gene for the chromosomal AmpC beta-lactamase of Citrobacter freundii, and the closely linked ampR encoding the transcriptional regulator essential for enzyme induction, into the broad host-range plasmid pKT231. Plasmid pMD101 was transconjugated into Proteus mirabilis VI and its isogenic, cell-wall-less protoplast L-form LVI. AmpC beta-lactamase was expressed constitutively from cloned ampR and ampC in bacteria and in some L-form protoplasts. However, induction of the enzyme by beta-lactam antibiotics occurred only in bacterial cells and not in the cell-wall- and peptidoglycan-deficient L-form. In agreement with current models, induction of AmpC beta-lactamase is thought to be initiated by an induction signal arising from the metabolic disturbance of cell-wall peptidoglycan.