View Video Presentation: https://doi.org/10.2514/6.2021-2195.vid Computational results are presented for a 15%-scale, full-span, generic low-boom concept aircraft model simulated as installed in the NASA Langley Research Center 14- by 22-Foot Subsonic Tunnel and in free-air conditions. The simulations were conducted with the lattice Boltzmann solver PowerFLOW® to capture the time-accurate characteristics of the flow. The aerodynamic behavior of the aircraft was investigated with various combinations of flap and landing gear deployments. To replicate the flow speed used during tests of the model, a Mach number of approximately 0.20 was chosen while varying the angle of attack through a limited range. Analyses were performed on local flow quantities, global forces, as well as flow distributions between configurations. Aerodynamic quantities were shown to be sensitive to mesh resolution levels, especially with flap and landing gear systems retracted. When comparing wind tunnel to free-air simulations, the aerodynamic quantities sampled were found to be in good agreement, suggesting that tunnel blockage and model support effects did not adversely impact the aerodynamic behavior of the model during the wind tunnel test. The results of this study improve our understanding of the highly complex, vortical flow generated by configurations with swept, low aspect-ratio wings at speeds encountered during landing operations.

Wind tunnel test data were used to validate the predicted aerodynamic behavior of a 15%-scale version of a generic, low-boom aircraft. The test was conducted in the NASA Langley 14- by 22-Foot Subsonic Tunnel to determine the low-speed aerodynamic characteristics of the model. Measured steady surface pressures and global forces were used to validate predicted aerodynamic results obtained from high-fidelity simulations of the model as installed in the tunnel. Very good agreement between predicted and measured aerodynamic trends was demonstrated, providing the impetus to proceed with companion airframe noise simulations that were conducted in a free-air setting. Computed near-field flow variables acquired on a permeable data surface were used to generate synthetic pressure records for two 800-element phased microphone arrays positioned overhead and to the side of the model. The array data were beamformed to generate noise source localization maps for the clean model and several landing configurations. Primary and secondary airframe sources were identified and their relative strengths were determined. Far-field integrated noise spectra for the full aircraft, as well as individual components, were obtained from the source maps via integration of tailored regions. The analysis showed that noise produced by the landing gear was the dominant contributor to the far-field acoustic signature of the model, followed by flap noise. The effects of permeable data surface end caps, spatial resolution, array orientation, angle of attack, component interaction, velocity scaling, and numerical precision on synthetic far-field spectra were also evaluated.