The ITER Ion Cyclotron Range of Frequencies (ICRF) antenna's capacity to couple power to plasma is determined by the plasma Scrape-Off Layer (SOL) profile, shaping of the front strap array, layout of the Port Plug (PP) and detailed design of its RF components. The first two factors are taken into account by the Torino Polytechnic Ion Cyclotron Antenna (TOPICA) calculated strap array Scattering/Impedance 24-port (S24×24−/Z24×24−) matrices, while this paper deals with the optimisation of the PP layout and components. The RF modeling techniques are explained and used to maximise the coupled power under a set of constraints on RF quantities inside the PP. The total PP RF surface conductive and volumetric dielectric losses are calculated. The resulting S-parameters at the rear RF PP flanges are evaluated as input for the design of the pre-match, decoupling and matching network outside the PP. A discussion of the effect of errors on the PP excitation on the coupled power is also included.

The CYCLE consortium has been designing the ITER ICRF antenna since March 2010, supported by an F4E grant. Following a brief introduction to the consortium, this paper: describes the present status and layout of the design; highlights the key mechanical engineering features; shows the expected impact of cooling and radiation issues on the design and outlines the need for future R&D to support the design process. A key design requirement is the need for the mechanical design and analysis to be consistent with all requirements following from the RF physics and antenna layout optimisation. As such, this paper complements that of Durodie et al [1].