Extended abstract of a paper presented at Microscopy and Microanalysis 2011 in Nashville, Tennessee, USA, August 7–August 11, 2011.

Extract HTML view is not available for this content. However, as you have access to this content, a full PDF is available via the ‘Save PDF’ action button. Extended abstract of a paper presented at Microscopy and Microanalysis 2005 in Honolulu, Hawaii, USA, July 31--August 4, 2005

Extended abstract of a paper presented at Microscopy and Microanalysis 2005 in Honolulu, Hawaii, USA, July 31--August 4, 2005

The 2.0-angstrom structure of the cyclic adenosine monophosphate (cAMP)–dependent protein kinase (PKA) catalytic subunit bound to a deletion mutant of a regulatory subunit (RIα) defines a previously unidentified extended interface. The complex provides a molecular mechanism for inhibition of PKA and suggests how cAMP binding leads to activation. The interface defines the large lobe of the catalytic subunit as a stable scaffold where Tyr 247 in the G helix and Trp 196 in the phosphorylated activation loop serve as anchor points for binding RIα. These residues compete with cAMP for the phosphate binding cassette in RIα. In contrast to the catalytic subunit, RIα undergoes major conformational changes when the complex is compared with cAMP-bound RIα. The inhibitor sequence docks to the active site, whereas the linker, also disordered in free RIα, folds across the extended interface. The β barrel of cAMP binding domain A, which is the docking site for cAMP, remains largely intact in the complex, whereas the helical subdomain undergoes major reorganization.

There is an urgent need to replace film and CCD cameras as recording instruments for transmission electron microscopy (TEM). Film is too cumbersome to process and CCD cameras have low resolution, marginal to poor signal-to-noise ratio for single electron detection and high spatial distortion. To find a replacement device, we have tested a high sensitivity active pixel sensor (APS) array currently being developed for nuclear physics. The tests were done at 120 keV in a JEOL 1200 electron microscope. At this energy, each electron produced on average a signal-to-noise ratio about 20/1. The spatial resolution was also excellent with the full width at half maximum (FWHM) about 20 microns. Since it is very radiation tolerant and has almost no spatial distortion, the above tests showed that a high sensitivity CMOS APS array holds great promise as a direct detection device for electron microscopy.

The protein kinase family is a prime target for therapeutic agents, since unregulated protein kinase activities are linked to myriad diseases. Balanol, a fungal metabolite consisting of four rings, potently inhibits Ser/Thr protein kinases and can be modified to yield potent inhibitors that are selective-characteristics of a desirable pharmaceutical compound. Here, we characterize three balanol analogues that inhibit cyclic 3',5'-adenosine monophosphate-dependent protein kinase (PKA) more specifically and potently than calcium- and phospholipid-dependent protein kinase (PKC). Correlation of thermostability and inhibition potency suggests that better inhibitors confer enhanced protection against thermal denaturation. Crystal structures of the PKA catalytic (C) subunit complexed to each analogue show the Gly-rich loop stabilized in an "intermediate" conformation, disengaged from important phosphoryl transfer residues. An analogue that perturbs the PKA C-terminal tail has slightly weaker inhibition potency. The malleability of the PKA C subunit is illustrated by active site residues that adopt alternate rotamers depending on the ligand bound. On the basis of sequence homology to PKA, a preliminary model of the PKC active site is described. The balanol analogues serve to test the model and to highlight differences in the active site local environment of PKA and PKC. The PKA C subunit appears to tolerate balanol analogues with D-ring modifications; PKC does not. We attribute this difference in preference to the variable B helix and C-terminal tail. By understanding the details of ligand binding, more specific and potent inhibitors may be designed that differentiate among closely related AGC protein kinase family members.

In eukaryotes the primary target for cAMP, a ubiquitous second messenger, is cAMP-dependent protein kinase (PKA). Understanding how binding and release of cAMP changes the cAMP binding domains and then triggers long-range allosteric responses is an important challenge. This conformational switching requires structure solutions of cAMP binding domains in cAMP-bound and cAMP-free states. We describe for the first time a crystal structure of the cAMP binding domains of PKA type Iα regulatory subunit where site A is occupied by cGMP and site B is unoccupied. The structure reveals that the carboxyl terminus of domain B serves as a hydrophobic cap, locking the cyclic nucleotide via its adenine ring into the β-barrel. In the absence of cAMP, the “cap” is released via an extension of the C-terminal helix. This simple hinge mechanism for binding and release of cAMP also provides a mechanism for allosteric communication between sites A and B.

Cyclic adenosine 5'-monophosphate (cAMP) is an ancient signaling molecule, and in vertebrates, a primary target for cAMP is cAMP-dependent protein kinase (PKA). (R(p))-adenosine 3',5'-cyclic monophosphothioate ((R(p))-cAMPS) and its analogues are the only known competitive inhibitors and antagonists for cAMP activation of PKA, while (S(p))-adenosine 3',5'-cyclic monophosphothioate ((S(p))-cAMPS) functions as an agonist. The crystal structures of a Delta(1-91) deletion mutant of the RIalpha regulatory subunit of PKA bound to (R(p))-cAMPS and (S(p))-cAMPS were determined at 2.4 and 2.3 A resolution, respectively. While the structures are similar to each other and to the crystal structure of RIalpha bound to cAMP, differences in the dynamical properties of the protein when (R(p))-cAMPS is bound are apparent. The structures highlight the critical importance of the exocyclic oxygen's interaction with the invariant arginine in the phosphate binding cassette (PBC) and the importance of this interaction for the dynamical properties of the interactions that radiate out from the PBC. The conformations of the phosphate binding cassettes containing two invariant arginine residues (Arg209 on domain A, and Arg333 on domain B) are somewhat different due to the sulfur interacting with this arginine. Furthermore, the B-site ligand together with the entire domain B show significant differences in their overall dynamic properties in the crystal structure of Delta(1-91) RIalpha complexed with (R(p))-cAMPS phosphothioate analogue ((R(p))-RIalpha) compared to the cAMP- and (S(p))-cAMPS-bound type I and II regulatory subunits, based on the temperature factors. In all structures, two structural solvent molecules exist within the A-site ligand binding pocket; both mediate water-bridged interactions between the ligand and the protein. No structured waters are in the B-site pocket. Owing to the higher resolution data, the N-terminal segment (109-117) of the RIalpha subunit can also be traced. This strand forms an intermolecular antiparallel beta-sheet with the same strand in an adjacent molecule and implies that the RIalpha subunit can form a weak homodimer even in the absence of its dimerization domain.

The catalytic subunit of cAMP-dependent protein kinase has served as a paradigm for the entire kinase family. In the course of studying the structure–function relationship of the P+1 loop (Leu198–Leu205) of the kinase, we have solved the crystal structure of the Tyr204 to Ala mutant in complexes with Mg·ATP and an inhibitory peptide at 1.26 Å, with overall structure very similar to that of the wild-type protein. However, at the nucleotide binding site, ATP was found largely hydrolyzed, with the products ADP-PO4 retained in the structure. High-resolution refinement suggests that 26% of the molecules contain the intact ATP, whereas 74% have the hydrolyzed products. The observation of the substrate and product states in the same structure adds significant information to our understanding of the phosphoryl transfer process. Structural examination of the mutation site substantiates and extends the emerging concept that the hydrophobic core in the large lobe of the kinase might serve as a stable platform for anchoring key segments involved in catalysis. We propose that Tyr204 is critical for anchoring the P+1 loop to the core. Further analysis has highlighted two major connections between the P+1 loop and the catalytic loop (Arg165–Asn171). One emphasizes the hydrophobic packing of Tyr204 and Leu167 mediated through residues from the αF-helix, recently recognized as a signal integration motif, which together with the αE-helix forms the center of the hydrophobic core network. The other connection is mediated by the hydrogen bond interaction between Thr201 and Asp166, in a substrate-dependent manner. We speculate that the latter interaction may be important for the kinase to sense the presence of substrate and prepare itself for the catalytic reaction. Thus, the P+1 loop is not merely involved in substrate binding; it mediates the communication between substrate and catalytic residues.

Journal Article High Performance Digital Imaging for Transmission Electron Microscopy Get access S Peltier, S Peltier National Center for Microscopy and Imaging Research, Dept of Neuroscience, University of California, San Diego, La Jolla, Ca 92093-0608, USA Search for other works by this author on: Oxford Academic Google Scholar JC Bouwer, JC Bouwer National Center for Microscopy and Imaging Research, Dept of Neuroscience, University of California, San Diego, La Jolla, Ca 92093-0608, USA Search for other works by this author on: Oxford Academic Google Scholar N-H Xuong, N-H Xuong Departments of Physics and Biology, University of California, San Diego, La Jolla, Ca 92093, USA Search for other works by this author on: Oxford Academic Google Scholar M H Ellisman M H Ellisman National Center for Microscopy and Imaging Research, Dept of Neuroscience, University of California, San Diego, La Jolla, Ca 92093-0608, USA Search for other works by this author on: Oxford Academic Google Scholar Microscopy and Microanalysis, Volume 9, Issue S02, 1 August 2003, Pages 1566–1567, https://doi.org/10.1017/S1431927603447831 Published: 01 August 2003

To better understand the mechanism of ligand binding and ligand-induced conformational change, the crystal structure of apoenzyme catalytic (C) subunit of adenosine-3′,5′-cyclic monophosphate (cAMP)-dependent protein kinase (PKA) was solved. The apoenzyme structure (Apo) provides a snapshot of the enzyme in the first step of the catalytic cycle, and in this unliganded form the PKA C subunit adopts an open conformation. A hydrophobic junction is formed by residues from the small and large lobes that come into close contact. This "greasy" patch may lubricate the shearing motion associated with domain rotation, and the opening and closing of the active-site cleft. Although Apo appears to be quite dynamic, many important residues for MgATP binding and phosphoryl transfer in the active site are preformed. Residues around the adenine ring of ATP and residues involved in phosphoryl transfer from the large lobe are mostly preformed, whereas residues involved in ribose binding and in the Gly-rich loop are not. Prior to ligand binding, Lys72 and the C-terminal tail, two important ATP-binding elements are also disordered. The surface created in the active site is contoured to bind ATP, but not GTP, and appears to be held in place by a stable hydrophobic core, which includes helices C, E, and F, and β strand 6. This core seems to provide a network for communicating from the active site, where nucleotide binds, to the peripheral peptide-binding F-to-G helix loop, exemplified by Phe239. Two potential lines of communication are the D helix and the F helix. The conserved Trp222-Phe238 network, which lies adjacent to the F-to-G helix loop, suggests that this network would exist in other protein kinases and may be a conserved means of communicating ATP binding from the active site to the distal peptide-binding ledge.

Protein kinases are important targets for designing therapeutic drugs. This paper illustrates a computational approach to extend the usefulness of a single protein-inhibitor structure in aiding the design of protein kinase inhibitors. Using the complex structure of the catalytic subunit of PKA (cPKA) and balanol as a guide, we have analyzed and compared the distribution of amino acid types near the protein-ligand interface for nearly 400 kinases. This analysis has identified a number of sites that are more variable in amino acid types among the kinases analyzed, and these are useful sites to consider in designing specific protein kinase inhibitors. On the other hand, we have found kinases whose protein-ligand interfaces are similar to that of the cPKA-balanol complex and balanol can be a useful lead compound for developing effective inhibitors for these kinases. Generally, this approach can help us discover new drug targets for an existing class of compounds that have already been well characterized pharmacologically. The relative significance of the charge/polarity of residues at the protein-ligand interface has been quantified by carrying out computational sensitivity analysis in which the charge/polarity of an atom or functional group was turned off/on, and the resulting effects on binding affinity have been examined. The binding affinity was estimated by using an implicit-solvent model in which the electrostatic contributions were obtained by solving the Poisson equation and the hydrophobic effects were accounted for by using surface-area dependent terms. The same sensitivity analysis approach was applied to the ligand balanol to develop a pharmacophoric model for searching new drug leads from small-molecule libraries. To help evaluate the binding affinity of designed inhibitors before they are made, we have developed a semiempirical approach to improve the predictive reliability of the implicit-solvent binding model.