Context. As evidenced by recent survey results, the majority of asteroids are slow rotators (spin periods longer than 12 h), but lack spin and shape models because of selection bias. This bias is skewing our overall understanding of the spins, shapes, and sizes of asteroids, as well as of their other properties. Also, diameter determinations for large (>60 km) and medium-sized asteroids (between 30 and 60 km) often vary by over 30% for multiple reasons.Aims. Our long-term project is focused on a few tens of slow rotators with periods of up to 60 h. We aim to obtain their full light curves and reconstruct their spins and shapes. We also precisely scale the models, typically with an accuracy of a few percent.Methods. We used wide sets of dense light curves for spin and shape reconstructions via light-curve inversion. Precisely scaling them with thermal data was not possible here because of poor infrared datasets: large bodies tend to saturate in WISE mission detectors. Therefore, we recently also launched a special campaign among stellar occultation observers, both in order to scale these models and to verify the shape solutions, often allowing us to break the mirror pole ambiguity.Results. The presented scheme resulted in shape models for 16 slow rotators, most of them for the first time. Fitting them to chords from stellar occultation timings resolved previous inconsistencies in size determinations. For around half of the targets, this fitting also allowed us to identify a clearly preferred pole solution from the pair of two mirror pole solutions, thus removing the ambiguity inherent to light-curve inversion. We also address the influence of the uncertainty of the shape models on the derived diameters.Conclusions. Overall, our project has already provided reliable models for around 50 slow rotators. Such well-determined and scaled asteroid shapes will, for example, constitute a solid basis for precise density determinations when coupled with mass information. Spin and shape models in general continue to fill the gaps caused by various biases.
We predicted, observed, and analyzed the multichord stellar occultation of the Second Gaia Data Release (Gaia DR2) source 3449076721168026624 (m$_v$ = 14.1 mag) by the plutino object 2003 VS$_2$ (hereafter, VS$_2$) on 2019 October 22. We also carried out photometric observations to derive the rotational light curve amplitude and rotational phase of VS$_2$ during the stellar occultation. Combining the results and assuming a triaxial shape, we derived the 3D shape of VS$_2$. Out of the 39 observatories involved in the observational campaign, 12 sites reported a positive detection; this makes it one of the best observed stellar occultations by a TNO so far. We obtained a rotational light curve amplitude of ${\Delta}$m = 0.264 $\pm$ 0.017 mag, a mean area-equivalent diameter of D$_{A_{eq}}$ = 545 $\pm$ 13 km, and a geometric albedo of 0.134 $\pm$ 0.010. The best triaxial shape obtained for VS$_2$ has semiaxes a = 339 $\pm$ 5 km, b = 235 $\pm$ 6 km, and c = 226 $\pm$ 8 km. The derived aspect angle is ${\theta}$ = 59${\deg} \pm$ 2${\deg}$ or its supplementary ${\theta}$ = 121${\deg} \pm$ 2${\deg}$, depending on the north-pole position. The spherical-volume equivalent diameter is D$_{V_{eq}}$ = 524 $\pm$ 7 km. If we consider large albedo patches on its surface, the semi-major axis of the ellipsoid could be ~10 km smaller. These results are compatible with the previous ones determined from the single-chord 2013 and four-chord 2014 stellar occultations and with the effective diameter and albedo derived from Herschel and Spitzer data. They provide evidence that VS$_2$'s 3D shape is not compatible with a homogeneous triaxial body in hydrostatic equilibrium, but it might be a differentiated body and/or might be sustaining some stress. No secondary features related to rings or material orbiting around VS$_2$ were detected.
Context. A stellar occultation by Neptune’s main satellite, Triton, was observed on 5 October 2017 from Europe, North Africa, and the USA. We derived 90 light curves from this event, 42 of which yielded a central flash detection. Aims. We aimed at constraining Triton’s atmospheric structure and the seasonal variations of its atmospheric pressure since the Voyager 2 epoch (1989). We also derived the shape of the lower atmosphere from central flash analysis. Methods. We used Abel inversions and direct ray-tracing code to provide the density, pressure, and temperature profiles in the altitude range ~8 km to ~190 km, corresponding to pressure levels from 9 µbar down to a few nanobars. Results. (i) A pressure of 1.18 ± 0.03 µbar is found at a reference radius of 1400 km (47 km altitude). (ii) A new analysis of the Voyager 2 radio science occultation shows that this is consistent with an extrapolation of pressure down to the surface pressure obtained in 1989. (iii) A survey of occultations obtained between 1989 and 2017 suggests that an enhancement in surface pressure as reported during the 1990s might be real, but debatable, due to very few high S/N light curves and data accessible for reanalysis. The volatile transport model analysed supports a moderate increase in surface pressure, with a maximum value around 2005-2015 no higher than 23 µbar. The pressures observed in 1995-1997 and 2017 appear mutually inconsistent with the volatile transport model presented here. (iv) The central flash structure does not show evidence of an atmospheric distortion. We find an upper limit of 0.0011 for the apparent oblateness of the atmosphere near the 8 km altitude.