We report on a high-resolution spectroscopic survey of 6Li40K molecules near the 2S + 4P dissociation threshold and produce a fully empirical representation for the B1Π potential by connecting available short- and long-range data. The purpose is to identify a suitable intermediate state for a coherent Raman transfer to the absolute ground state, and the creation of a molecular gas with dipolar interactions. Starting from weakly bound ultracold Feshbach molecules, the transition frequencies to twenty-six vibrational states are determined. Our data are combined with long-range measurements [Ridinger et al., EPL, 2011, 96, 33001], and near-dissociation expansions for the spin-orbit coupled potentials are fitted to extract the van der Waals C6 dispersion coefficients. A suitable vibrational level is identified by resolving its Zeeman structure and by comparing the experimentally attained g-factor to our theoretical prediction. Using mass-scaling of the short-range data for the B1Π [Pashov et al., Chem. Phys. Lett., 1998, 292, 615620] and an updated value for its depth, we model the short- and the long-range data simultaneously and produce a Rydberg-Klein-Rees curve covering the entire range.

We optically excite 85Rb atoms in a heated vapor cell to a low-lying Rydberg state 10D5/2 and observe directional terahertz (THz) beams at 3.3 THz and 7.8 THz. These THz fields are generated by amplified spontaneous emission from the 10D5/2 state to the 11P3/2 and 8F7/2 states, respectively. In addition, we observe ultraviolet (UV) light produced by four-wave mixing of optical pump lasers and the 3.3 THz field. We characterize the generated THz power over the detuning and power of pump lasers, and identify experimental conditions favoring THz and UV generation, respectively. Our scheme paves a new pathway towards generating high-power narrowband THz radiation.

Starting from weakly bound Feshbach molecules, we demonstrate a two-photon pathway to the dipolar ground state of bi-alkali molecules that involves only singlet-to-singlet optical transitions. This pathway eliminates the search for a suitable intermediate state with sufficient singlet-triplet mixing and the exploration of its hyperfine structure, as is typical for pathways starting from triplet dominated Feshbach molecules. By selecting a Feshbach state with a stretched singlet hyperfine component and controlling the polarization of the excitation laser, we assure coupling to only a single hyperfine component of the $\textrm{A}^{1}\Sigma^{+}$ excited potential, even if the hyperfine structure is not resolved. Similarly, we address a stretched hyperfine component of the $\textrm{X}^{1}\Sigma^{+}$ rovibrational ground state, and therefore an ideal three level system is established. We demonstrate this pathway with ${}^{6}\textrm{Li}{}^{40}\textrm{K}$ molecules. By exploring deeply bound states of the $\textrm{A}^{1}\Sigma^{+}$ potential, we are able to obtain large and balanced Rabi frequencies for both transitions. This method can be applied to other molecular species.

We present spectroscopic measurements of the long range states of the 6 Li 40 K molecule near its Li(4 2 S1/2) + K(4 2 P3/2) asymptote which in combination with existing data in the short range lead to the full characterization of the B 1 Π potential with high spectroscopic resolution.This survey was conducted in the context of identifying a suitable pathway for the efficient two-photon transfer to the absolute ro-vibronic ground state of 6 Li 40 K heteronuclear dimers.

We demonstrate microwave-to-optical conversion using six-wave mixing in cold Rb-87 atoms where the microwave field couples to two Rydberg states and propagates collinearly with the converted optical field. Our experiment is performed with a free-space microwave field, and we achieve a conversion efficiency of about 5% for the microwave photons entering the conversion medium. In addition, we theoretically investigate all-resonant six-wave mixing and outline a realistic experimental scheme for reaching an efficiency close to 70%.

We use two continuous-wave (CW) laser beams of 780 nm and 515 nm to optically drive $^{85}$Rb atoms in a heated vapor cell to a low-lying Rydberg state 10D$_{5/2}$. We observe a collimated ultraviolet (UV) beam at 311 nm, corresponding to the transition frequency from the 11P$_{3/2}$ state to the 5S$_{1/2}$ state. This indicates the presence of a coherent four-wave mixing process, built up by two input laser fields as well as a terahertz (THz) radiation of 3.28 THz that is generated by amplified spontaneous emission between the 10D$_{5/2}$ and the 11P$_{3/2}$ states. We characterize the 311 nm UV light generation and its dependence on various physical parameters. This scheme could open up a new possibility for generating narrow-band THz waves as well as deep UV radiation.

We report on a transfer-lock laser frequency stabilization that utilizes a frequency comb (FC) and a radio frequency counter referenced to a GPS frequency standard to compensate for the frequency drifts of two lasers, which are locked to a single passive Fabry-Perot resonator (FPR). The method requires only one optical phase lock with the FC and allows transfer locking of lasers at wavelengths beyond the usable range of the FC. To attain a large frequency tuning range for the lasers, we implement optical serrodyning. We further demonstrate an efficient scheme to suppress residual amplitude modulation, thereby improving the stability of the Pound-Drever-Hall lock used in this case. The absolute frequency stability was found to be better than 2 x 10(-13) on timescales up to 300 s. Hence, together with the frequency stability on short timescales provided by the FPR, this scheme facilitates coherent Raman spectroscopy as needed for an example for the production of ultracold dipolar heteronuclear molecules. (C) 2016 Optical Society of America

The dynamics of an optically trapped particle are often determined by measuring intensity shifts of the back-scattered light from the particle using position sensitive detectors. We present a technique which measures the phase of the back-scattered light using balanced detection in an external Mach-Zehnder interferometer scheme where we separate out and beat the scattered light from the particle and that from the top surface of our trapping chamber. The technique has improved axial motion resolution over intensity-based detection, and can also be used to measure lateral motion of the trapped particle. In addition, we are able to track the Brownian motion of trapped 1.1 and 3 μm diameter particles from the phase jitter and show that, similar to intensity-based measurements, phase measurements can also be used to simultaneously determine displacements of the trapped particle as well as the spring constant of the trap. For lateral displacements, we have matched our experimental results with a simulation of the overall phase contour of the back-scattered light by using plane wave decomposition in conjunction with Mie scattering theory. The position resolution is limited by path drifts of the interferometer which we have presently reduced to demonstrate the capability of sub-nm displacement resolution in the axial direction for 1.1 μm diameter particles by locking the interferometer to a frequency stabilized diode laser.

A photonic force microscope comprises of an optically trapped micro-probe and a position detection system to track the motion of the probe. Signal collection for motion detection is often carried out using the backscattered light off the probe-however, this mode has problems of low S/N due to the small backscattering cross sections of the micro-probes typically used. The position sensors often used in these cases are quadrant photodetectors. To ensure maximum sensitivity of such detectors, it would help if the detector size matched with the detection beam radius after the condenser lens (which for backscattered detection would be the trapping objective itself). To suit this condition, we have used a miniature displacement sensor whose dimensions makes it ideal to work with 1:1 images of micrometer-sized trapped probes in the backscattering detection mode. The detector is based on the quadrant photo-integrated chip in the optical pick-up head of a compact disc player. Using this detector, we measured absolute displacements of an optically trapped 1.1 μm probe with a resolution of ∼10 nm for a bandwidth of 10 Hz at 95% significance without any sample or laser stabilization. We characterized our optical trap for different sized probes by measuring the power spectrum for each probe to 1% accuracy, and found that for 1.1 μm diameter probes, the noise in our position measurement matched the thermal resolution limit for averaging times up to 10 ms. We also achieved a linear response range of around 385 nm with cross talk between axes ≃4% for 1.1 μm diameter probes. The detector has extremely high bandwidth (few MHz) and low optical power threshold-other factors that can lead to its widespread use in photonic force microscopy.

Microparticle self assembly under the influence of optical forces produced by higher-order optical beams or by projection of a hologram into the trapping volume is well known. In this paper, we report the spontaneous formation of a ring of identical microspheres (each with diameter 1.1 mu m) in conventional single-beam optical tweezers with a usual TEM00 Gaussian beam coupled into a sample chamber having a standing wave geometry with a cover slip and glass slide. The effects of different experimental parameters on the ring formation are studied extensively. The experimental observations are backed by theoretical simulations based on a plane wave decomposition of the forward-and backward-propagating Gaussian beams. The ring patterns are shown to be caused due to geometrical aberrations produced by focusing the Gaussian beam using a high-numerical-aperture microscope objective into stratified media. It is found that the thickness of the stratified media and the standing wave geometry itself play a critical role in the formation of stable ring structures. These structures could be used in the study of optical binding, as well as of biological interactions between cells in an optical trap.

Back-focal plane interferometry is typically used to determine displacements of a trapped bead which lead to trapping force measurements in optical tweezers. In most cases, intensity shifts of the back-scattered interference pattern due to displacements of the bead are measured by a position sensitive detector placed in the microscope back-focal plane. However, in intensity-based measurements, the axial displacement resolution is typically worse than the lateral resolution since for axial displacements, the inherent resolution of the position detector cannot be used. In this paper, we demonstrate that measurement of the phase of the back-scattered light yields high axial displacement resolution, and can also be used for lateral displacement measurement. In our experiments, we separate out the back-scattered light from the trapped bead and reflected light from the top surface of the sample chamber by a confocal arrangement consisting of a spatial filter used in combination with two apertures. We proceed to beat the two separated components in a Mach-Zehnder interferometer where we employ balanced detection to improve our fringe contrast, and thus the sensitivity of the phase measurement. For lateral displacement sensing, we match experimental results to within 10% with a theoretical simulation determining the shift of the overall phase contour of the back-scattered light due to a given lateral displacement by using plane wave decomposition in conjunction with Mie scattering theory. Our technique is also able to track the Brownian motion of trapped beads from the phase jitter so that, similar to intensity-based measurements, we can use it to determine the spring constant of the trap, and thus the trapping force. The sensitivity of our technique is limited by path drifts of the external interferometer which we have currently stabilized by locking it to a frequency stabilized diode laser to obtain displacement measurement resolution similar to 200 pm.

We report magnetic trapping of Yb in the excited P-3(2) state. This state, with a lifetime of 15 s, could play an important role in studies ranging from optical clocks and quantum computation to the search for a permanent electric dipole moment. Yb atoms are first cooled and trapped in the ground state in a 399-nm magneto-optic trap. The cold atoms are then pumped into the excited state by driving the S-1(0) -> P-3(1) -> S-3(1) transition. Atoms in the P-3(2) state are magnetically trapped in a spherical quadrupole field with an axial gradient of 110 G/cm. We trap up to 10(6) atoms with a lifetime of 1.5 s.