In this work we show the influence of material preparation technology on the thermoluminescent properties of single crystalline films (SCFs) of Ce3+-doped Lu2SiO5 (LSO) and Y2SiO5 (YSO) orthosilicates. LSO:Ce and YSO:Ce SCFs were grown by the liquid phase epitaxy method from two different melt-solutions based on PbO-B2O3 and Bi2O3 fluxes. Absorption, cathodoluminescence, and thermoluminescent properties of LSO:Ce and YSO:Ce SCFs grown from the two previously mentioned types of fluxes were compared, and results of spectrally resolved thermoluminescence measurements and thermoluminescent glow curves of SCFs recorded in different spectral ranges were presented. We have found that the observed differences in thermoluminescent properties of the SCFs under study can be caused by the domination of Ce4+ and Pb2+ emission centers in LSO:Ce and YSO:Ce SCFs grown using PbO-B2O3 flux, and Ce3+ and Bi3+ emission centers in the SCFs grown from Bi2O3 flux.

We report in this work the creation of new heavy and efficient Tb3Al3O12:Ce (TbAG:Ce) single crystalline film (SCF) scintillators, grown by LPE method from PbO-B2O3 based flux onto Y3Al5O12 (YAG) and Gd3Ga2.5Al2.5O12 (GAGG) substrates, for different optoelectronic applications. The luminescent and scintillation properties of the TbAG:Ce SCF screens, grown onto different types of substrates, are studied and compared with the properties of the Lu(3)Al3O(12):Ce (LuAG:Ce) and YAG:Ce SCF counterparts. TbAG:Ce SCFs show very high scintillation light yield (LY) under alpha-particles excitation, which overcomes by 30% the LY of high-quality LuAG:Ce SCF samples. In comparison with YAG:Ce and LuAG:Ce SCFs, TbAG:Ce SCF screens show also significantly lower afterglow (up to 10(-4) level at X-ray burst duration of 0.1 s), which is comparable with the afterglow level of the best samples of LSO:Ce, Tb SCFs typically being Used now for microimaging. Together with a high light output of X-ray excited luininescence, such eXtremely low afterglow of TbAG:Ce SCF is a very good reason for future development of scintillating screens based on the mentioned garnet. We also introduce the possibility to create new types of "film-substrate" hybrid scintillators using the LPE method for simultaneous registration of different components of ionizing radiation and microimaging based on the TbAG:Ce SCF and GAGG:Ce Substrates. (C) 2016 Elsevier B.V. All rights reserved.

The growth of single crystalline films (SCFs) with excellent scintillation properties based on the Tb1.5Gd1.5Al5−yGayO12:Ce mixed garnet at y = 2–3.85 by Liquid Phase Epitaxy (LPE) method onto Gd3Al2.5Ga2.5O12 (GAGG) substrates from BaO based flux is reported in this work. We have found that the best scintillation properties are shown by Tb1.5Gd1.5Al3Ga2O12:Ce SCFs. These SCFs possess the highest light yield (LY) ever obtained in our group for LPE grown garnet SCF scintillators exceeding by at least 10% the LY of previously reported Lu1.5Gd1.5Al2.75Ga2.25O12:Ce and Gd3Al2–2.75 Ga3–2.25O12:Ce SCF scintillators, grown from BaO based flux. Under α-particles excitation, the Tb1.5Gd1.5 Al3Ga2O12:Ce SCF show LY comparable with that of high-quality Gd3Al2.5Ga2.5O12:Ce single crystal (SC) scintillator with the LY above 10,000 photons/MeV but faster (at least by 2 times) scintillation decay times t1/e and t1/20 of 230 and 730 ns, respectively. The LY of Tb1.5Gd1.5Al2.5Ga2.5O12:Ce SCFs, grown from PbO flux, is comparable with the LY of their counterparts grown from BaO flux, but these SCFs possess slightly slower scintillation response with decay times t1/e and t1/20 of 330 and 990 ns, respectively. Taking into account that the SCFs of the Tb1.5Gd1.5Al3–2.25Ga2–2.75O12:Ce garnet can also be grown onto Ce3+ doped GAGG substrates, the LPE method can also be used for the creation of the hybrid film-substrate scintillators for simultaneous registration of the different components of ionization fluxes.

The growth of single crystalline films (SCFs) with excellent scintillation properties based on the Tb1.5Gd1.5Al5−yGayO12:Ce mixed garnet at y = 2–3.85 by Liquid Phase Epitaxy (LPE) method onto Gd3Al2.5Ga2.5O12 (GAGG) substrates from BaO based flux is reported in this work. We have found that the best scintillation properties are shown by Tb1.5Gd1.5Al3Ga2O12:Ce SCFs. These SCFs possess the highest light yield (LY) ever obtained in our group for LPE grown garnet SCF scintillators exceeding by at least 10% the LY of previously reported Lu1.5Gd1.5Al2.75Ga2.25O12:Ce and Gd3Al2–2.75 Ga3–2.25O12:Ce SCF scintillators, grown from BaO based flux. Under α-particles excitation, the Tb1.5Gd1.5 Al3Ga2O12:Ce SCF show LY comparable with that of high-quality Gd3Al2.5Ga2.5O12:Ce single crystal (SC) scintillator with the LY above 10,000 photons/MeV but faster (at least by 2 times) scintillation decay times t1/e and t1/20 of 230 and 730 ns, respectively. The LY of Tb1.5Gd1.5Al2.5Ga2.5O12:Ce SCFs, grown from PbO flux, is comparable with the LY of their counterparts grown from BaO flux, but these SCFs possess slightly slower scintillation response with decay times t1/e and t1/20 of 330 and 990 ns, respectively. Taking into account that the SCFs of the Tb1.5Gd1.5Al3–2.25Ga2–2.75O12:Ce garnet can also be grown onto Ce3+ doped GAGG substrates, the LPE method can also be used for the creation of the hybrid film-substrate scintillators for simultaneous registration of the different components of ionization fluxes.