Two asymmetrically structured model compounds for the hydrogen-generating [Fe-Fe]-hydrogenase active site were investigated to determine the ultrafast photodynamics, structural intermediates, and photoproducts compared to more common symmetric di-iron species. The bidentate-ligand-containing compounds studied were Fe2(μ-S2C3H6)(CO)4(bipy), 1, and Fe2(μ-S2C3H6)(CO)4(phen), 2, in dilute room temperature acetonitrile solution and low-temperature 2Me-THF matrix isolation using static FTIR difference and time-resolved infrared spectroscopic methods (TRIR). Ultraviolet-visible spectra were also compared to time-dependent density functional theory (TD-DFT) to ascertain the orbital origins of long wavelength electronic absorption features. The spectroscopic evidence supports the conclusions that only a propyl-bridge flip occurs in low-temperature matrix, while early time CO ejection leads to the formation of solvated isomeric species on the 25 ps time scale in room temperature solution.

Ultrafast lasers have become increasingly important as research tools in laboratories and commercial enterprises suggesting laser safety, personal protection, and awareness become ever more important. Laser safety eyewear are typically rated by their optical densities (OD) over various spectral ranges, but these measurements are usually made using low power, large beam size, and continuous beam conditions. These measurement scenarios are vastly different than the high power, small beam size, and pulsed laser beam conditions where ultrafast lasers have extremely high peak powers and broad spectra due to the short pulse durations. Many solid-state lasers are also tunable over a broad wavelength range, further complicating the selection of adequate laser safety eyewear. Eighteen laser eyewear filter samples were tested under real-world conditions using a Ti:Sapphire regenerative amplifier with output pulses centered at 800 nm running from 2 Hz to 1 kHz repetition rate. The typical maximum peak laser irradiance employed was ca. 3 TW/cm2 (800 nm wavelength, 450 μJ/pulse with 80 fs full width at half maximum pulse duration) or less when damage occurred, depending on the sample. While many samples maintained their integrity under these test conditions, many plastic samples showed signs of failure which reduced their OD, in some cases transmitting 4–5 orders of magnitude higher than expected. In general, glass filters performed significantly better than plastic filters, exhibiting less physical damage to the substrate and less absorber degradation.

Ultrafast laser systems are becoming more widespread throughout the research and industrial communities yet eye protection for these high power, bright pulsed sources still require scrupulous characterization and testing before use. Femtosecond lasers, with pulses naturally possessing broad-bandwidth and high average power with variable repetition rate, can exhibit spectral side-bands and subtly changing center wavelengths, which may unknowingly affect eyewear safety protection. Pulse spectral characterization and power diagnostics are presented for a 80 MHz, Ti+3:Sapphire, ≈ 800 nm, ≈40 femtosecond oscillator system. Power and spectral transmission for 22 test samples are measured to determine whether they fall within manufacturer specifications.