Digital additive manufacturing (AM) is emerging as a promising technology for next-generation RF systems. AM processes that combine multiple materials in a single build and can produce volumetric designs are especially interesting for 3D structural electronics. This paper reports on 3D AM fabricated components for a 2.45 GHz RF front end, specifically a circularly-polarized dipole antenna, a miniaturized capacitive-loaded open-loop resonator filter and a switched-line phase shifter. The printing process integrates fused deposition of thermoplastic substrates with micro-dispensing for deposition of conductive traces. These initial results demonstrate the strong potential for fully-printed RF front ends for light weight, low cost, conformal and readily customized applications.

This paper reports on the design, fabrication and characterization of a 3-D printed RF front end for a 2.45 GHz phased array unit cell. The printed unit cell, which includes a circularly-polarized dipole antenna, a miniaturized capacitive-loaded open-loop resonator filter and a 4-bit phase shifter, is fabricated using a direct digital manufacturing (DDM) approach that integrates fused deposition of thermoplastic substrates with micro-dispensing for deposition of conductive traces. The individual components are combined in a passive phased array antenna unit cell comprised of seven stacked substrate layers with seven conductor layers. The measured return loss of the unit cell is > 12 dB across the 2.45 GHz ISM band and the measured gain is -11 dBi including all components. Experimental and simulation-based characterization is performed to investigate electrical properties of as-printed materials, in particular the inhomogeneity of printed thick-film conductors and substrate surface roughness. The results demonstrate the strong potential for fully-printed RF front ends for light weight, low cost, conformal and readily customized applications.