A detailed characterization of the trapped-proton-induced radiation environment on board Columbus and the International Space Station (ISS) has been carried out using the Geant4 Monte Carlo particle transport toolkit. Dose and dose equivalent rates, as well as penetrating particle spectra are presented. These results are based on detailed Geant4 geometry models of Columbus and ISS, comprising a total of about 1000 geometry volumes. Simulated trapped-proton dose rates are found to be strongly dependent on ISS altitude. Dose rates for different locations inside the Columbus cabin are presented, as well as for different models of the incident trapped-proton flux. Dose rates resulting from incident anisotropic trapped protons are found to be lower than, or equal to, those of omnidirectional models. The anisotropy induced by the asymmetric shielding distribution of Columbus/ISS is also studied. The simulated trapped-proton dose (equivalent) rates, averaged over different locations inside Columbus, are 120 muGy/d (154 muSv/d) and 79 muGy/d (102 muSv/d) for solar minimum and maximum conditions according to AP8 incident proton spectra and an ISS orbit of 380 km. The solar maximum dose rates are found to be of the same order as measurements in other modules in the present ISS.
The influence of geometry model approximations on Geant4 Monte Carlo simulation results of the radiation environment on-board the Columbus module of the International Space Station (ISS) has been investigated. Three geometry models of Columbus with different levels of detail and a geometry model of ISS have been developed. These geometries have been used for Geant4 simulations of the radiation environment inside Columbus induced by trapped protons and Galactic Cosmic Ray protons. Simulated dose rates and particle spectra on-board Columbus for each of the three Columbus models, with or without the ISS geometry model included, are presented and compared.From comparisons of simulated dose rates and particle spectra for the three different geometry models it was found that the most detailed geometry model (750 volumes) produced results similar to a much less detailed model (23 volumes). The most detailed geometry model was concluded to be a sufficiently detailed approximation of the physical Columbus for the purpose of proton induced space radiation studies. The simulated dose rates are compatible with measurements on-board the ISS. The simulation results also show that an increase in shielding thickness decreases the simulated dose rate induced by trapped protons. For Galactic Cosmic Ray protons the dose rate remains unchanged or is slightly increased.
A characterization of the Galactic cosmic ray (GCR) induced radiation environment on-board Columbus and the International Space Station (ISS) has been carried out using the Geant4 Monte Carlo particle transport toolkit and detailed geometry models of Columbus and ISS. Dose and dose equivalent rates, as well as penetrating particle spectra are presented. Simulation results indicate that the major part of the dose rates due to GCR protons are associated with secondary particles produced in the hull of ISS. Neutrons contribute about 15% of the GCR proton dose equivalent rate and mesons about 10%. More than 40% of the simulated GCR proton dose and dose equivalent rates are due to protons in the energy range above 10 GeV. Protons in the energy range above 50 GeV contribute only 5% to the dose rates. The total simulated dose and dose equivalent rates at solar maximum are 63 muGy/d and 123 muSv/d, respectively. The dose equivalent rate underestimates measurements made during the 2001 solar maximum. The discrepancy can be attributed to deficiencies in hadronic ion-nuclei interaction models for heavy ions and to the lack of such models above 10 GeV/N in Geant4.
The Dose Estimation by Simulation of the ISS Radiation Environment (DESIRE) project aims to accurately calculate radiation fluxes and doses to astronauts inside the European Columbus module of the International Space Station using Geant4. Since Geant4 has not been previously used for this type of application it needs to be validated. This will be followed by a detailed evaluation of the incident radiation fields on ISS and culminate with the geometry modeling and full-scale flux and dose simulations for Columbus. Geant4 validation studies and comparisons to other tools are presented. These concern the angle and energy distributions of particles leaving irradiated targets and of energy depositions in the targets. Comparisons are made between simulations using different Geant4 physics models, experimental data, and other particle transport programs. Geant4 using the "Binary Cascade" model for inelastic nucleon reactions performs very well in these comparisons, but some issues with other models remain to be resolved if they are to be used for space radiation shielding applications. Results of Geant4 simulations of the transport of some relevant radiation field components through the hull of a simplified model of Columbus are also presented.