In the EU/COLIPA validation programme on "Photoirritation in vitro", two core tests and a number of mechanistically based tests were carried out to examine their suitability as regulatory tests for phototoxicity testing. In the meantime, one core test, the 3T3 neutral red uptake phototoxicity test (NRU PT) has been validated and has been accepted by ECVAM and the European Commission. The second core test, the red blood cell phototoxicity test (Photo-RBC test), has passed through a prevalidation process during this programme. This test protocol combines two endpoints, photohaemolysis and met-haemoglobin (met-Hb) formation. These endpoints are determined by measuring changes in the optical density of the haemoglobin spectrum at 525 nm and 630 nm, respectively. In addition, a prediction model was inserted into the Standard Operating Procedure (SOP) with two cut-off values: a photohaemolysis factor (PHF) > or = 3.0 for photohaemolysis, and a deltaOD(max) > or = 0.05 for met-Hb formation. Three laboratories agreed to implement the SOP and to perform the study by testing 30 selected test chemicals (25 phototoxicants and 5 non- phototoxic chemicals). The outcome of the study presents a good overall fit, including acceptable accuracy, sensitivity, and positive predictivity. The specificity and the negative predictivity are comparably low, due to the low number of non-phototoxic substances among the test chemicals. Further analysis of the data showed that the transfer of the SOP from between laboratories could have been more efficient. The results, especially of the lead laboratory, clearly indicate that an experienced laboratory can handle the SOP with high predictivity for phototoxicants and non-phototoxic substances. Finally, it was concluded that the combined Photo-RBC test can be considered as a second in vitro test, which can be used advantageously to obtain some mechanistic information, in particular on photodynamic effects on cellular proteins and biomembranes.

To date, no standardized international guideline for the testing of chemicals for phototoxic potential has been accepted for regulatory purposes. In 1991, the European Commission (EC), represented initially by the Directorate General XI and later by ECVAM (the European Centre for the Validation of Alternative Methods) and COLIPA (the European Cosmetic, Toiletry and Perfumery Association), agreed to establish a joint EU/COLIPA programme on the development and validation of in vitro phototoxicity tests. The first phase (phase I, 1992–93) was designed as a prevalidation study, to identify in vitro test procedures and test protocols for a formal validation trial under blind conditions. In the second phase (phase II, 1994–95), the formal validation study, the most promising in vitro phototoxicity tests were validated with 30 carefully selected test chemicals in 11 laboratories in a blind trial. The 3T3 mouse fibroblast neutral red uptake phototoxicity test (3T3 NRU PT) was performed as a core test in nine laboratories, since it provided the best results in phase I of the study. The purpose of phase II was to confirm the reliability and relevance of the in vitro tests for predicting phototoxic effects and for identifying phototoxic chemicals. In phase II the phototoxic potential of test chemicals in the 3T3 NRU PT test was either assessed by determining the phototoxicity factor (PIF) by using a cut-off value of 5 as in phase I of the study, or by determining the mean photo effect (MPE) by using a cut-off value of 0.1, as recently proposed by Holzhütter (1997). Results obtained with both approaches in the 3T3 NRU PT test in phase II were reproducible in the nine laboratories, and the correlation between in vitro and in vivo data was very high. Therefore, ECVAM and COLIPA conclude from this formal validation trial under blind conditions that the 3T3 NRU PT test is a scientifically validated in vitro test which is ready to be considered for regulatory purposes for assessing the phototoxic potential of chemicals. A draft OECD Guideline for “In Vitro Phototoxicity Testing”, incorporating the standard protocol of the 3T3 NRU PT test, will be submitted to the OECD test guidelines programme in due course.

In a joint validation project eight laboratories from the European Cosmetic Industry Association (COLIPA) as well as FRAME (England) and ZEBET (Germany) are trying to develop validated in vitro methods to be incorporated into new international guidelines for acute phototoxicity testing. The first stage of the study involved selection of the most promising in vitro phototoxicity tests for further validation. 20 chemicals with known phototoxic properties (12 phototoxins, four UV-absorbing non-phototoxins and four non-UV absorbing non-phototoxins) were tested under identical conditions of UV exposure conditions (sun simulator, UVA 5 J/cm(2)) in a standardized cytotoxicity assay with Balb/c 3T3 fibroblasts (endpoint: neutral red uptake, NRU). 19 of the 20 chemicals were correctly classified by the 3T3 NRU phototoxicity test, and therefore, this simple assay for phototoxicity seems very promising and should be validated further.