We present forward 2D mechanical simulations that demonstrate that the elastic deformation that is likely to have affected the Chalk Group in the antiform Kraka Structure, Danish Central Graben is associated with relatively high elastic stresses. The stresses are similar in magnitude to the normal stresses associated with burial, and, as a result, at the top of the antiform, where (deviatoric) bending stresses tend to be extensional, compaction is impeded, and porosities exceed those that would develop in a simple burial scenario by 10–20 percentage points. Similarly, where flexure is associated with excess compression, porosity is reduced. This result appears, to a first order, to be consistent with the observed porosity distribution in the Chalk Group of the antiformal Kraka structure and may provide additional constraints on the distribution of high-porosity zones constituting zones of high reservoir quality. Furthermore, the model may be applied to other chalk reservoirs in the North Sea Basin and improved by accounting for 3D effects and by incorporating better laboratory measurements of the mechanical properties of the relevant chalk formations. The prediction of high porosity preserved due to the elastic bending of the Chalk Group reservoirs can be utilized in future exploration and Enhanced Oil Recovery in mature fields.

The mapping of faults provides essential information on many aspects of seismic exploration, characterisation of reservoirs for compartmentalisation and cap-rock integrity. However, manual interpretation of faults from seismic data is time-consuming and challenging due to limited resolution and seismic noise. In this study, we apply a convolutional neural network trained on synthetic seismic data with planar fault shapes to improve fault mapping in the Lower and Upper Cretaceous sections of the Valdemar Field in the Danish North Sea. Our objective is to evaluate the performance of the neural network model on post-stack seismic data from the Valdemar Field. Comparison with variance and ant-tracking attributes and a manual fault interpretation shows that the neural network predicts faults with more details that may improve the overall geological and tectonic understanding of the study area and add information on potential compartmentalisation that was previously overlooked. However, the neural network is sensitive to seismic noise, which can distort the fault predictions. Therefore, the proposed model should be treated as an additional fault interpretation tool. Nonetheless, the method represents a state-of-the-art fault mapping tool that can be useful for hydrocarbon exploration and CO2 storage site evaluations.

In contractional basin settings, the development of families of relatively small (throws = 10’s of meters) normal faults in the crests of growing anticlines is a common phenomenon. Various publications describe such faults from both outcrops, seismic data, analogue and computational models. The authors generally attribute their formation to local extensional stress fields arising from outer-arc extension in the bending sedimentary units or gravitational collapse. In spite of abundant reporting, crestal faults are rarely the focus of the given studies. An understanding of the phenomenon is relevant as these faults occur in many reservoirs in anticlines where they can affect compartmentalisation and fluid flow. We present examples of crestal normal faults in the Danish sector of the North Sea that formed during folding associated with regional tectonic shortening and basin inversion. These faults display variations in structural style, which we link to differences in mechanical stratigraphy and geometries of the associated anticlines. Additionally, we present discrete-element models of crestal deformation during early anticline growth with various magnitudes of crestal-unit strengths and imposed lateral shortening. By analysing the results, we aim to identify the relative control of these parameters on the resulting structural style and strain distribution in the anticline crest.

Using borehole-constrained 3D reflection seismic data, we analyse the importance of sub-salt, salt, and supra-salt deformation in controlling the geometries and the kinematics of inverted structures in the Danish Central Graben. The Danish Central Graben is part of the failed Late Jurassic North Sea rift. Later tectonic shortening caused mild basin inversion during the Late Cretaceous and Paleogene. Where mobile Zechstein evaporites are present, they have played a significant role in the structural evolution of the Danish Central Graben since the Triassic. Within the study area, Jurassic rifting generated two major W- to SW-dipping basement faults (the Coffee Soil Fault and the Gorm–Tyra Fault) with several kilometres of normal offset and associated block rotation. The Coffee Soil Fault system delineates the eastern boundary of the rift basins, and within its hanging wall a broad zone is characterized by late Mesozoic to early Paleogene shortening and relative uplift. Buttressed growth folds in the immediate hanging wall of the Coffee Soil Fault indicate thick-skinned inversion, i.e. coupled deformation between the basement and cover units. The western boundary of the inverted zone follows the westward pinch-out of the Zechstein salt. Here, thin-skinned folds and faults sole out into Zechstein units dipping into the half-graben. The most pronounced inversion structures occur directly above and in prolongation of salt anticlines and rollers that localized shortening in the cover above. With no physical links to underlying basement faults (if present), we balance thin-skinned shortening to the sub-salt basement via a triangle zone concept. This implies that thin Zechstein units on the dipping half-graben floor formed thrust detachments during inversion while basement shortening was mainly accommodated by reactivation of the major rift faults further east. Disseminated deformation (i.e. “ductile” at seismic scales) accounts for thin-skinned shortening of the cover units where such a detachment did not develop. The observed structural styles are discussed in relation to those found in other inverted basins in the North Sea Basin and to those produced from physical model experiments. Our results indicate that Zechstein units imposed a strong control on structural styles and kinematics not only during rift-related extension but also during basin inversion in large parts of the Danish Central Graben. Reactivated thin-skinned faults soling out into thin Triassic evaporite units within the carapace above Zechstein salt structures illustrate that even thin evaporite units may contribute to defining structures during tectonic extension and shortening. We thus provide an updated and dedicated case study of post-rift basin inversion, which takes into account the mechanical heterogeneity of sub-salt basement, salt, and supra-salt cover, including multiple evaporite units of which the Zechstein is the most important.

During Cretaceous and Paleogene times, tectonic shortening caused mild basin inversion of earlier rifting depocentres in the Danish Central Graben. This exerted an important control on the thickness variations and geometries of e.g. the Late-Cretaceous and Danian Chalk Group. Structural highs formed by inversion and especially Permian-salt movements, host important hydrocarbon reservoirs in the sector. Earlier researchers have linked basin inversion in the North-Sea area to Alpine deformational phases and the onset of seafloor spreading in the North Atlantic. The objective of this 3D seismic-data study is an analysis of the relationships between basement (sub-salt) faults, salt movements, and salt-cover deformation, as well as fluid migration near and within inversion structures. We find that the northeastern margin of the larger inverted area generally has a thick-skinned style. Here, reverse reactivation of the rift-bounding master fault is coupled between the strata above and below the salt. Oppositely, the southwestern margin has a thin-skinned style. Here, buttressed hangingwall folds sit above reverse faults detaching into even thin evaporite sequences. The strike of this cover-fault trend mimics that of the underlying basement faults, although they dip in opposite directions. A triangle-zone model explains how sub-salt shortening (reactivation of major basement faults) can be balanced to the shortening observed in the sedimentary cover. As the current thickness of Permian salt increases and mobile-salt structures become predominant towards the south, the effects of basin inversion grow difficult to distinguish from those of halokinesis. Interestingly, the shallow crests of inversion folds, especially along the southwestern margin, host groups of smaller normal faults. These formed to some degree during inversion, indicating that local extensional tectonism (crestal collapse) took place during the overall shortening. We conclude that the shallow parts of the folds experienced forced bending rather than buckling during folding. A significant number of hydrocarbon reservoirs sit within basin-inversion structures. Potentially, this work can increase our understanding of deformation within these and similar structures. Acknowledgements: We thank the Centre for Oil and Gas – DTU (DHRTC) for funding and supporting this project and for providing data. We also thank Schlumberger and Eliis for providing seismic-interpretation software.