Objective: To analyze the diagnostic efficacy of urinary lipoarabinomannan (LAM) antigen detection method in tuberculosis patients, and to provide an experimental basis for the clinical application of urinary LAM kit in China. Methods: From March to May 2023, 228 patients with lung diseases [134 male, 94 female, age 20-82 (44.8±16.7) years] were prospectively collected in Beijing Chest Hospital, Capital Medical University, including 143 pulmonary tuberculosis patients and 85 non-tuberculosis patients. Urine and sputum samples from patients were collected for traditional etiological detection and urinary LAM antigen detection. The screening results of each positive detection combination were analyzed, and the difference analysis and regression analysis were performed. Results: The detection sensitivity and specificity of the urinary LAM kit were 46.2% (95%CI: 37.9%-54.7%) and 96.5% (95%CI: 89.3%-99.1%), respectively, with an overall coincidence rate of 64.9%. The detection rate of LAM antigen detection and GeneXpert MTB/RIF (Xpert) combined (60.8%, 87/143) was significantly higher than that of Xpert alone (49.7%, 71/143), and the difference was statistically significant (P<0.05). The results of risk factor analysis showed that the risk of negative urinary LAM antigen test results increased significantly as the bacterial load decreased. Conclusions: Urine LAM antigen detection method has a high specificity and can be combined with traditional methods to effectively improve the detection rate. Urinary LAM antigen detection method still has limitations, such as the influence of bacterial load and the inability to distinguish nontuberculosis mycobacteria samples, which needs further experimental verification.
Costimulatory and co-inhibitory receptors on T lymphocytes play an essential role in the immune response. There is increasing evidence that the expression of co-signal molecules on T cells is altered in infection, tumor, autoimmunity, and other diseases, and that intervention of co-signal molecules can be used in the immunotherapy. This paper reviewed the costimulatory and coinhibitory receptors on Mtb-specific T lymphocytes and further explained the mechanism of co-signal molecules in the progression of tuberculosis, to provide a reference for future research and clinical application.
Summary Background Interferon-γ release assays (IGRAs), which are widely used to diagnose tuberculosis (TB), cannot effectively discriminate latent TB infection (LTBI) from active TB (ATB). This study aimed to identify potential antigen-specific biomarkers for differentiating LTBI cases from ATB cases. Methods Ongoing recruitment was conducted of individuals meeting study inclusion criteria at Beijing Chest Hospital from May 2020 to April 2022; 208 participants were enrolled and assigned to three groups: HC (60 healthy controls), LTBI (52 subjects with LTBI) and ATB (96 ATB patients). After participants were assigned to the discovery cohort (20 or 21 subjects/group), all others were assigned to the verification cohort. Discovery cohort blood levels of 40 chemokines were measured using Luminex assays to identify chemokines that could be used to discriminate LTBI cases from ATB cases; candidate biomarkers were verified using enzyme-linked immunosorbent assay-based testing of validation cohort samples. Results Luminex results revealed highest ATB group levels of numerous cytokines, growth factors and chemokines. Receiving operating characteristic curve-based analysis of 40 biomarkers revealed CCL8 (AUC = 0.890) and CXCL9 (AUC = 0.883) effectively discriminated between LTBI and TB cases; greatest diagnostic efficiency was obtained using both markers together (AUC = 0.929). Interpretation of CCL8 and CXCL9 levels for validation cohort IGRA-positive subjects (based on a 0.658-ng/ml cutoff) revealed ATB group CCL8-based sensitivity and specificity rates approaching 90.79% and 100.00%, respectively. Conclusion TB-specific chemokines hold promise as ATB diagnostic biomarkers. Additional laboratory confirmation is needed to establish whether CCL8-based assays can differentiate between ATB and LTBI cases, especially for bacteriologically unconfirmed TB cases.
Objective: To compare the diagnostic performance of next-generation sequencing (NGS) detection methods in sputum samples and Mycobacterium tuberculosis strains, in order to explore the feasibility of the NGS method to detect drug resistance in sputum specimens. Methods: In this retrospective study, the sputum specimens and corresponding clinical isolates of 50 pulmonary tuberculosis patients admitted to Beijing Chest Hospital from January 2017 to December 2017 were collected. The gene mutations of katG, inhA, rpoB, embA, embB, rpsL, rrs, gyrA, gyrB and tlyA in sputum specimens and corresponding clinical isolates were detected by NGS method. The phenotypic drug susceptibility test (DST) of the strains was carried out by the proportion method. Using DST results as a reference, the sensitivity, specificity, positive predictive value and negative predictive value of the NGS method for clinical strains and sputum specimens, as well as the consistency statistic (Kappa) with phenotype DST were calculated respectively. The Chi-square test was used to compare the accuracy of the NGS testing in sputum samples and strain samples. Results: The results showed that rpoB(63.83%, 30/47) and rrs(57.45%, 27/47) were the most common mutated genes, followed by katG(46.81%, 22/47), rpsL(29.79%, 14/47), gyrA(27.66%, 13/47), embB(21.28%, 10/47), tlyA(12.77%, 6/47), gyrB(8.51%, 4/47), and inhA promoter(19.15%, 9/47), embA promoter region (12.77%, 6/47) mutation. when the NGS method was compared with the resistance phenotype of isoniazid, rifampicin, ethambutol, second-line injectable drugs (streptomycin, capreomycin, kanamycin, amikacin), levofloxacin, the sensitivity were 85.71%, 91.67%, 77.78%, 81.82%, 100.00%, 87.50%, 100.00%, 69.23%, and the specificity were 100.00%, 94.12, 87.50%, 89.47%, 97.06%, 96.97%, 94.29%, 89.29% in sputum samples, while in strain samples, the sensitivity were 92.86%, 100.00%, 81.82%, 86.96%, 88.89%, 80.00%, 100.00%, 85.71%. The specificity were 100.00%, 92.86%, 87.10%, 94.74%, 100.00%, 100.00%, 97.14%, 92.86%. Compared with the phenotypic drug susceptibility results, the NGS method has better detection performance for isoniazid, rifampicin, capreomycin, kanamycin, and amikacin in sputum specimens (Kappa≥0.75); while among the strains, the NGS method had a good detection performance for isoniazid, rifampicin, streptomycin, capreomycin, kanamycin, amikacin and levofloxacin (Kappa≥0.75). With the accuracy of the NGS method for detecting strains as a reference, there was no statistically significant difference in the accuracy of all drug resistance detected between strains and sputum specimens. Conclusions: This study showed that the NGS technology was effective in predicting the resistance of isoniazid, rifampicin, and second-line injectable drugs (capreomycin, kanamycin and amikacin) by detecting sputum samples and strain genotypes, suggesting the feasibility and potential of direct detection of sputum samples by the NGS method as an early detection method for drug resistance.
A nano-structured alloying layer was fabricated by the addition of 304 stainless steel powder to the surface of a low carbon steel (LCS) plate by surface mechanical attrition treatment (SMAT). The coverage of the stainless steel layer was 93 % after SMAT for 60 min. The thickness of the surface layer was approximately 35 μm. The average grain size in the top layer was in the range of 55–65 nm with random crystallographic orientation, and the grain size increased with increasing depth from the treated surface. Both the surface hardness and wear resistance of the sample that underwent a surface nano-alloying treatment (SNAT) increased compared with those of the LCS sample. Additionally, the wear resistance increased for the nanocrystalline (nc) surface layer. Nanoindentation measurements indicated that micro-hardness in the nc surface layer was approximately 645 HV, which was three times as high as that of the LCS matrix. K e y w o r d s: surface nano-alloying treatment (SNAT), surface mechanical attrition treatment (SMAT), microstructure, 304 stainless steel layer, micro-hardness
Objectives: Bedaquiline treatment significantly improves multidrug-resistant tuberculosis (MDR-TB) patient treatment outcomes. However, safety and efficacy data are lacking for bedaquiline used with background regimens to treat Chinese TB patients. Here, we describe our initial clinical experience for bedaquiline treatment of a large multicentre cohort of MDR-TB and extensively drug-resistant tuberculosis (XDR-TB) patients in China. Methods: Patients (177) received 24-week bedaquiline treatment combined with personalized anti-TB drug background regimens. As primary efficacy endpoints, times to initial sputum culture conversion were measured. Results: Of 177 MDR-TB patients completing the 24-week treatment course, sputum culture conversion occurred for 151/177 (85.3%), while 26 had unfavourable outcomes, including 3/177 (1.7%) deaths and 23/ 177 (13.0%) non-responders at treatment completion. The median time to sputum culture conversion was 4 (interquartile range 2-8) weeks. Conversion rates were 33/39 (84.6%, 95% confidence interval (CI) 73.3-95.9) for MDR-TB patients, 47/56 (83.9%, 95% CI 74.3-93.6) for pre-XDR-TB patients and 71/82 (86.6%, 95% CI 79.2-94.0) for XDR-TB patients. Multivariate analysis demonstrated that patients with low body mass index (odds ratio 7.356; 95% CI 2.652-20.401) were at significantly high risk of unfavourable outcomes, with serious adverse events noted in 15 (8.5%) patients, including six with corrected QT interval (QTc) prolongation times (>500 ms). Conclusion: Bedaquiline, when included in background regimens for treatment of MDR-TB and XDR-TB patients in China, was safe and associated with a high rate of culture conversion. M. Gao, Clin Micro-biol Infect 2021;27:597 (c) 2020 European Society of Clinical Microbiology and Infectious Diseases. Published by Elsevier Ltd. All rights reserved.
Objectives: TB-EASM (Howsome, Shanghai, China), an automated system combining smear preparation, staining and microscopy in a single platform, was evaluated for tuberculosis (TB) diagnosis in a high disease-burden setting. Methods: Sputum samples from individuals with pulmonary TB were processed in parallel using conventional manual smear microscopy (MS), TB-EASM, liquid culture and GeneXpert. Method sensitivity and specificity were compared with Mycobacterium tuberculosis detection by mycobacteria growth indicator tube (MGIT) and/or GeneXpert MTB/RIF. Results: Of 524 samples, 496 met evaluation criteria for study inclusion. The proportion of M. tuberculosis detected by TB-EASM was 28.2% (150/496), significantly higher than for MS (111/496, 21.2%, p 0.01) and comparable to the rate for MGIT (163/496, 32.9%, p > 0.05). For 190 M. tuberculosis-positive cases identified using MGIT and/or GeneXpert MTB/RIF, the reference standard detection methods, TB-EASM detected 140 positive cases, for an overall sensitivity rate of 73.7% (140/190, 95% CI 67.4-79.9), which was significantly higher than for MS (105/190, 55.3%, 95% CI 48.2-62.3, p < 0.01). Specificities were 96.7% (296/306, 95% CI 94.7e98.7) for TB-EASM and 98.0% (300/306, 95% CI 96.5-99.6) for MS. Conclusion: TB-EASM outperformed conventional MS for M. tuberculosis detection in sputum specimens. (C) 2019 European Society of Clinical Microbiology and Infectious Diseases. Published by Elsevier Ltd. All rights reserved.
Objectives: We carried out a randomized multicentre study in China to investigate whether the clofazimine would improve the efficacy of the standardized regimen in patients with multidrug-resistant tuberculosis (MDR-TB). Methods: Patients with MDR-TB managed in 17 TB specialist hospitals in China between September 2009 and September 2011 were randomly assigned to the treatment groups at enrolment. In the intervention group, 100 mg clofazimine per day was added to the standardized regimen. The primary outcome was the proportion of patients with successful outcomes. Results: From the 156 patients that were screened, 74 were assigned to the control group and 66 to the clofazimine group. Of the 66 cases analysed for clinical outcome in the clofazimine group, 36 patients were cured, and seven completed treatment, yielding a favourable outcome rate of 65.1%. The proportion of patients with favourable outcomes receiving the control regimen was 47.3% (35/74), which was significantly lower than that in the clofazimine group (p 0.034, relative risk 0.661, 95% CI 0.243-0.949). Conclusions: The addition of clofazimine to the standard regimen improved the treatment of MDR-TB. (C) 2018 Published by Elsevier Ltd on behalf of European Society of Clinical Microbiology and Infectious Diseases.
The role of metformin (MET) on treatment effect of diabetic tuberculosis (TB) patients has not been studied in China. Thus, we conducted a retrospective study to investigate whether MET exhibited more efficacy in combination with anti-TB regimens for diabetic TB patients. All patients recruited came from five tuberculosis control and prevention institutes from July 2009 to July 2016 and completed 3 years of follow-up. We used chi-square test or Fisher’s exact test to evaluate the demographic characteristics and the frequency of clinical outcome between MET and non-MET group. A total of 58 TB patients with diabetes mellitus (DM), of these 27.6% (16/58) patients in the MET group and 72.4% (42/58) patients in the non-MET group, there was no significant difference in blood glucose level between MET and non-MET group (P = 0.494), in addition, there was a higher proportion of treatment success (93.8 vs. 71.4%) and culture conversions by the end of 2 months (87.5 vs. 71.4%) among MET group; the relapse rates of patients in MET and non-MET group were 6.3% (1/16) and 35.7% (15/42) through a 3-year follow-up (P = 0.045). Our data revealed that the use of MET as a combination drug with existing regimen improved the success rate of anti-TB treatment and reduced the relapse rate in TB patients with DM.