The German Historical Institute in Rome, short DHI Rome, is the oldest of the German historical institutes abroad. Its purpose is to conduct research in the history of both Italy and Germany, and investigate particularly the German-Italian relations in a wider international context from medieval times to the present day.
Differences in the composition and spatial distribution of Fluorescent Dissolved Organic Matter (FDOM) between western and eastern Greenland shelf waters reflect the interplay of distinct regional environmental drivers-such as glacial meltwater inputs and stratification effects – which shape local DOM processing and biogeochemical cycles. These contrasts provide unique opportunity to understand how Arctic coastal system responds to climatic changes. To investigate these dynamics, we assessed FDOM by an application of multivariate statistical method - Parallel Factor Analysis (PARAFAC) on samples collected in July 2021 and August 2022. The PARAFAC enabled the distinction of five components representing both humic-like (C1 (λEx/λEm 318/392), C2 (λEx/λEm 363(261)/445), C5 (λEx/λEm 399/513)) and protein-like (C3 (tyrosine) − λEx/λEm 267/305, (C4 (tryptophan) − λEx/λEm 285/345)) substances, showing variations between western and eastern shelves and across different water layers (surface, deep chlorophyll a maximum depth – DCM, and below it (i.e., in the West Slope Greenland Core water – WSGC, and in the core Polar Water - PW). The analysis showed that western DOM is almost equally composed of humic-like (51%) and protein-like (49%) substances, while the eastern shelf is dominated by protein-like FDOM (56%), indicating a stronger influence of autochthonous production in the east. The highest fluorescence intensity was measured of the protein-like component C3 in both eastern (PW layer) and western (DCM layer) shelves. In the surface waters of the western Greenland shelf we found a statistically significant (p<0.001), although relatively weak (R = 0.27) correlation between Ip and the total chlorophyll a concentration, Tchla. Derived values of spectral indices (HIX, BIX, and FI), and a ratio of fluorescence intensities of protein-like components to fluorescence intensities of humic-like components, Ip/Ih, indicated that the FDOM in analyzed water was predominantly autochthonous, characterized with low molecular weight and low-saturation aromatic rings. This findings provide new insights into FDOM composition in the Arctic under changing climatic conditions.
The Surface Water and Ocean Topography (SWOT) satellite can simultaneously observe river elevation, width, and slope with high spatio‐temporal coverage and resolution (Fu et al., 2024, https://doi.org/10.1029/2023gl107652 ). The River Single‐Pass (RiverSP) product from SWOT provides geolocated river surface water dynamics with global coverage, but it utilizes simplified river centerlines that do not properly represent braided rivers. We present a method for integrating high‐resolution pixel cloud SWOT data with Sentinel‐2 multispectral imagery for multi‐channel river analysis, with a case study over the Brahmaputra River. We generate dynamic river centerlines from multispectral river masks and apply SWOT observations to the generated centerlines. We find that refined centerline knowledge allows for improved estimates of river surface water dynamics in braided channels when compared to RiverSP. For the Brahmaputra, we find that water surface elevation can vary by 0.5 m and slope can vary by 2 cm/km between parallel channels of the braided river.
We develop a coupling system between the Weather Research and Forecasting model in a large eddy simulation (WRF-LES) configuration and the MIKE 3 Wave Flexible Mesh (M3W FM) model. So far, the coupling system is one-way and offline. We investigate coupled model performance for the simulation of the atmospheric flow within the marine atmosphere over an irregular long-crested wavy surface generated by the M3W FM model. The M3W FM model generates irregular sea surface elevations for given wave spectrum parameters, including significant wave height and peak wave period. This wavy surface elevation realization is then used as a static lower boundary condition in the WRF-LES simulations. For validation, we simulate an event with the largest observed significant wave height from a two-month measurement campaign (equal to a one-year return period storm) in a location in the North Sea near Denmark. To explore the impact of using the wavy surface on the marine atmosphere, a non-coupled WRF-LES simulation over a flat surface is conducted for comparison. Three types of wind and potential temperature profiles were used to initialize the atmosphere in WRF-LES: the first uses constant velocity profiles, the second ERA5 data, and the third mesoscale WRF model output. There is a very good agreement between the sea state measurements and the output of M3W FM model. Vertical profiles of mean wind speed and direction from both coupled and non-coupled simulations also show good agreement with measurements from a buoy lidar. When compared with results from the non-coupled simulations, the coupled model reveals a much higher impact of waves on the turbulence characteristics, which include enhanced velocity covariances and spectra throughout the atmosphere.
Climate change intensifies the occurrence of severe flood events, increasing the demand for flood modeling studies. Hydrodynamic models can effectively represent flood events, but they are limited by the quality of available observations. Accurate topographic elevation is essential to replicate channel-floodplain interaction. Elevation is normally retrieved using satellite-based DEMs. However, freely available DEMs have a low spatial resolution, which is a limitation in identifying small-scale channel features in complex floodplain topography. In addition, these products can present issues such as vertical offset, random noise, or vegetation biases. These issues can lead to large errors when used in hydraulic modeling to simulate water levels and inundation extent. FABDEM is a 1 arcsec DEM, that removes forest and building artifacts from Copernicus DEM, but to map complex floodplain topography, finer resolution is needed. ICESat-2 mission offers a large spatial coverage with an along-track resolution down to 70 cm in the ATL03 product. This data product has shown great potential when mapping river topography and identifying small-scale channel features. ATL03 can be used as a control point dataset, to correct biases and refine DEMs To improve the accuracy of 2D hydraulic models, FABDEM was corrected on selected floodplain areas using supplementary data and machine learning methods. Artificial Neural Network (ANN) was used in the correction of FABDEM. This regression algorithm can predict differences between FABDEM floodplain elevation and ATL03 reference elevation, inputting data from Sentinel-2 and water occurrence maps produced from spectral and SAR imagery. The output floodplain elevation has a reduced vertical offset and a spatial resolution of 10 m, which can detect small-scale channel features. Flood inundation was simulated using the updated DEM. The high computational cost of 2D hydraulic models is a limitation when using discharge time series. To deal with computational cost, discharge classes were defined to represent different inundation scenarios that provide a good indicator for flood risk management, and steady-state inundation patterns were simulated for each discharge class. The method is demonstrated in a section of the Upstream Yellow River characterized by large floodplains with complex topography, and small-scale channels. Discharge observations from the Jimai in-situ station are used to define discharge classes. The discharge classes are defined by calculating the exceedance probability of a discharge value. The inundation scenarios are simulated for high flow discharge values for an exceedance probability of 25% (Q25) and 10% (Q10), and medium flow discharge values with 50% (Q50), and are compared with the corresponding water occurrence map produced from spectral and SAR imagery for the given discharge class. The critical success index (CSI) of the inundation map improves by about 5% using FABDEM corrected version for Q10 and Q25, and about 4% for Q50. In addition, we observe a consistent Bias reduction of about 20% for Q10 and Q25.
Il saggio discute sotto alcuni aspetti il volume Carlo IV nell’Italia del Trecento curato da Daniela Rando ed Eva Schlotheuber. In primo luogo, si propone il volume come superamento maturo della storiografia sulla crisi dell’Impero, in secondo luogo, ci si sofferma sui risultati degli studi, sottolineando l’aspetto emergente degli attori politici e culturali coinvolti nella politica di Carlo IV nelle sue interazioni con le realtà subalpine.