
ABSTRACT This review, dedicated to Professor Thomas Turek on his 65th birthday, summarizes a decade of systematic multi‐scale research of Turek's group on n ‐butane oxidation to maleic anhydride over vanadium‐phosphorus oxide (VPO) catalysts. Millistructured reactors delivered process intensification and safe operation above the explosion limit, enabling transport‐free intrinsic kinetics and revealing neglected by‐products essential for reactor modeling. Reversible phosphorus site‐blocking was mechanistically understood, controlled via moderator dosing, and validated across scales. Particle‐resolved computational fluid dynamics (CFD) exposed intraparticle gradients and thermowell errors, elucidating industrial observations. Critical void fraction thresholds for thermal runaway were identified. These advances form a multi‐scale framework for rational reactor and catalyst design.
ABSTRACT Intermediate‐temperature alkaline water electrolysis (100–200°C), which improves electrolysis efficiency by reducing cell voltage and enhancing reaction kinetics, has the potential compared to conventional low‐temperature (60–90°C) operation but requires separators that remain stable above the ∼110°C limit of the benchmark Zirfon UTP‐500. Building on our previous demonstration that microporous polytetrafluoroethylene (PTFE) membranes can be rendered hydrophilic by atomic layer deposition (ALD) of ZrO 2 , this work reports the electrochemical behaviour of these separators under industrially relevant conditions. In this work, two ALD‐modified PTFE membranes with different aspect ratios (membrane thickness to pore diameter) were characterized and compared with a benchmark polyphenylene sulphide (PPS) non‐woven diaphragm. The characterizations included potentiostatic electrochemical impedance spectroscopy (PEIS) in 45 wt% KOH at 30 bar, covering heating and cooling cycles up to 175°C, as well as gas‐crossover assessments in a zero‐gap flow cell at 80°C. Area‐specific resistance for all separators consistently decreased with increasing temperature, with PTFE membranes showing fully reversible resistance recovery after exposure to 175°C. Importantly, hydrogen‐in‐oxygen concentrations remained below the 2 vol% safety threshold throughout the operational range down to 50 mA cm −2 . Post‐mortem analyses via scanning electron microscopy with energy‐dispersive x‐ray spectroscopy (SEM/EDS), FTIR and x‐ray diffraction (XRD) revealed significant dissolution of the amorphous ALD ZrO 2 coating in hot concentrated KOH, whereas the underlying PTFE matrix maintained its chemical integrity. Despite this substantial coating loss, separator conductivity remained unaffected, supporting that the ALD coating primarily functions as a wetting facilitator, with ionic transport sustained by the electrolyte‐filled network.
ABSTRAKT Das chemische Recycling von Kunststoffabfällen soll in einer Circular Economy kontaminierte Abfallströme stofflich verwerten. Allerdings bereiten Störkomponenten Probleme, der Energieaufwand ist hoch und die Ausbeute an hochwertigen Chemikalien ist relativ gering. Ursache hierfür sind die zusätzlichen und aufwändigen Hydrier‐ und Spaltschritte, bei denen viel Energie benötigt wird und unerwünschte Nebenprodukte entstehen. Das Projekt pool‐in‐loop zeigt, dass eine direkte katalytische Spaltung von Polyolefinen zu Monomeren wirtschaftlich und ökologisch vorteilhaft ist. Dazu wurden spezielle Katalysatoren formuliert und in einem kontinuierlichen Prozess mit realen Abfallströmen getestet und die Ergebnisse über eine Prozessmodellierung mit dem klassischen Pyrolyseweg verglichen.
ABSTRACT The decarbonization of hard‐to‐abate sectors, including aviation and maritime transport, is essential to reducing greenhouse gas emissions. Power‐to‐fuels (PtF) pathways offer a technically feasible solution, particularly with the growing deployment of renewable energy. However, their large‐scale implementation faces significant economic and technical challenges. Meeting future demand for sustainable fuels will require substantial investment in Fischer–Tropsch synthesis capacities, estimated at €6.5–10.2 billion. In parallel, large‐scale electrolysis capacities are needed to provide hydrogen, with investment costs estimated at three times those of synthesis plants. This publication reviews current developments in electrolysis technologies and component manufacturing, assessing their potential to reduce costs, enhance economic competitiveness, and accelerate the large‐scale deployment of PtF pathways.
ABSTRACT The analysis presented in this article focuses on provisions of the European Union (EU) emissions trading system (ETS) for carbon dioxide that is captured in stationary installations for chemical utilization (CCU). The evolution in EU ETS legislation over more than two decades has led to challenges for CCU pathways with regard to monitoring, reporting, and allowance surrender obligations. This article attempts to trace the development from an engineering perspective. A look ahead suggests that CCU strategies could benefit from the formal expansion of the scope of the EU ETS, which has recently begun to take shape.