
Secondary evaporative mineral precipitates (EMPs) form on shotcrete in the Leeville underground (LUG) mine where the nexus between sulfides in country rock, oxygen, and moisture from fracture seepage facilitate their precipitation. Although their dissolution rates are rapid, laboratory experiments showed that the reactions among EMPs, shotcrete, and groundwater resulted in a circumneutral pH. The model integrated contributions to the post-closure underground from groundwater, cemented rock fill (CRF), cemented paste backfill (CPB), shotcrete, EMPs, backfilled waste rock, and floor rock across four different elevation stages in the LUG, where the EMP density increases from the base of the mine to the upper elevations. The predicted post-closure LUG aqueous chemistry will have a pH of ≈ 8 with an alkalinity of 111 mg/L CaCO3. Most solutes are predicted to remain below Nevada Division of Environmental Protection Profile I reference values, except for Sb, Cd, SO4, Tl, and U. However, prior tests have shown that the carbonate bedrock will efficiently attenuate Sb, Cd, Tl, and U, preventing any detrimental effects on adjacent groundwater, while marginally elevated SO4 (≈ 670 mg/L) will be rapidly diluted under throughflow conditions as the LUG tunnel groundwater mixes with the adjacent aquifer system. In summary, the test data, confirmed by the model results and active sump chemistry, demonstrate that as the workings are inundated, there will be no adverse environmental consequences to adjacent groundwater when throughflow conditions are re-established.
To address the limited coverage of Chinese-language literature of coal seam floor water inrush in English-language databases, a cross-database framework was constructed, combining international database-based analysis with CNKI-based supplementary validation. The aim was to reveal the knowledge structure and evolutionary process of coal seam floor water inrush research. After retrieval, screening, and deduplication, 676 WoS/Scopus publications from 2002 to 2025 were obtained, and 745 CNKI Chinese bibliographic records from 1992 to 2025 were introduced. Bibliometrix, VOSviewer, CiteSpace, Excel and manual content analysis were used to analyze publication trends, research contributors, journal distribution, keyword co-occurrence, keyword bursts, co-citation networks, and cross-database comparisons. The WoS/Scopus and CNKI data show that this field, as represented in international databases, is strongly shaped by Chinese engineering practice. The field has evolved through three stages: basic understanding and empirical assessment, multi-factor risk assessment and mechanism interpretation, and dynamic monitoring, early warning and intelligent prediction. This is unsurprising since it is not much of a problem outside of China. Consequently, research has centered on risk assessment, water inrush mechanisms, and monitoring and early warning. Risk assessment methods have expanded from the water inrush coefficient method and physics-based criteria to multi-factor comprehensive assessment; mechanistic understanding has deepened from structural control to mining-induced fracture propagation and multi-field coupling; and warning approaches have shifted from manually defined threshold-based judgement to intelligent early warning based on monitoring time-series data. Future research should further strengthen studies on inrush mechanisms under deep mining and high confined-water pressure, physics-constrained intelligent early warning, and closed-loop prevention-control systems supported by multi-source monitoring.
Environmentally sustainable mine-water disposal and carbon sequestration are two major challenges in modern resource and environmental management. This study explores the strategy of combining mine water reinjection with geological CO₂ storage in a low-permeability saline aquifer of the Liujiagou Formation, Ordos Basin. This study identifies a mechanistic connection whereby early CO₂ injection will produce an acidification effect that will enhance mine-water injectivity. TOUGHREACT/ECO2N simulations based on Liujiagou Formation data show that within 30 days, dissolution of calcite, siderite, K-feldspar, oligoclase, and chlorite will occur, while minor amounts of kaolinite and illite will precipitate, with dissolution overwhelmingly dominant. Calcite dissolution of 1.8
Thermal plumes developed during two heat injection experiments in different flooded mine working levels at the UK Geoenergy Observatory in Glasgow recorded thermal breakthrough times (for 0.1 °C change) of 4.8 and 2.3 days under similar test conditions. Synthesis of the mine abandonment plan, borehole, and outcrop data was used to characterise differences in the mine geometry and working type. New insights on how backfilled, collapsed, and open voids affected groundwater flow and heat transport were obtained from the hydrogeological, wellhead, and downhole direct temperature sensor data measured during and after pumping of the open loop borehole doublets. Over 17 days, heat injection into the Glasgow Upper mine workings resulted in the gradual development of a thermal plume, within an area interpreted to have a greater percentage of backfill and more tortuous flow paths. After 3.9 days, temperatures at the abstraction borehole started to increase at ≈ 0.03 °C/day, with a ≈ 2.3 °C differential maintained 10 days after heat injection and pumping stopped. In the five-day Glasgow Main heat injection experiment, temperature increases after 1.4 days were ≈ 0.14 °C/d, which was interpreted to result from preferential flow and heat transport pathways with less surface area for heat transport through conduction to the rock mass, and quicker transit time to the abstraction borehole. This provides real-world, at-scale quantification for geothermal exploitation and mine thermal energy storage, and demonstrates how mine working type, which influences flow and heat transport, can affect system performance.
Waste concrete (WC) has attracted attention for the passive treatment of acid mine drainage (AMD); however, its neutralization performance is often limited by the formation of a surface coating. Field-scale demonstration has shown that co-installation of rice husks (RH) can mitigate this deterioration, although the underlying mechanism remains unclear. In this study, AMD neutralization using WC and RH was investigated through dissolution and neutralization experiments. Dissolution experiments with blank AMD showed that WC was the primary source of alkalinity through portlandite dissolution, whereas RH was the main source of dissolved silicon via the alkaline dissolution of phytogenic amorphous silica. In the WC-only column, the effluent pH began to decrease after ≈ 12 h, accompanied by Zn and Cu breakthrough, whereas the WC+RH system maintained an alkaline pH of ≈ 11.5 for 24 h. SEM–EDS observations indicated that surface precipitates formed a continuous coating on WC in the WC-only system, whereas precipitation was spatially distributed between WC and RH in the mixed system. A one-dimensional reactive transport model incorporating coating-dependent reaction attenuation yielded RMSE values of 0.257–0.517 for pH across the four column systems and captured the observed differences in temporal neutralization behavior. These results indicate that surface coating formation, rather than depletion of the bulk alkalinity source, was responsible for the observed deterioration in WC neutralization performance, and that RH delayed this deterioration by redistributing precipitation between WC and RH.