
Hydrodynamic journal bearings are generally designed to ensure the separation of sliding surfaces. However, there are many situations in which contact between solid bodies is unavoidable. This article presents a simplified theoretical model for calculating the contact pressure, dissipated energy, and wear resulting from solid body contact, aiming to reduce computational time and the number of required input parameters. The experimental results show good correspondence between calculated and measured values. The remaining deviation in the results is mainly due to the randomness of mixed friction and the simplified contact model used; nevertheless, the theoretical model offers a quick and practical first approximation.
Wind turbines play an expanding role in Germany’s energy supply. One aspect of this expansion is the development of larger turbine generations to maximize the harvestable energy from each individual site. With the increase in size, new challenges arise, and turbines experience failures before their designated end of service. WTs require testing and certification on large-scale component and system test benches for the design verification. While turbines increase in scale, large-scale test capacities are not available or highly limited in their availability. Other branches of engineering, such as automotive, railway, or aero-/hydrodynamics, employ scaled testing methods to reduce costs and expedite testing procedures. This study explores the effects of downscaling on testing of a plain bearing main bearing design developed at the CWD – the FlexPad. The FlexPad was built and tested as a main bearing in the 1 MW range and as a downscaled replica of roughly half its original size, providing validated models. The FlexPad’s behaviour is simulated in further scales, determined using the principle of similitude. The aim of the scaling is a similar bearing behaviour as in the real-scale bearing. The simulation results are evaluated regarding the maximum hydrodynamic pressure to ensure the surface material strength is not exceeded. Results show that standard scaling methods based on the state of the art are not suitable, as uniform scaling distorts the pressures achieved in comparison to the original size, due to interactions between the bearings stiffness and the available bearing surface. However, the desired pressures can be achieved through targeted design adjustments that go beyond uniform scaling.
Rolling element bearings in drivetrains of modern wind turbines (WT) are susceptible to ring creep, as greater structural deformation is assumed due to the decreased wall thicknesses as a result of increased torque density. The deformation of bearing seats is associated with shear stresses. If local shear stresses exceed the shear stress limit, micro slip occurs. The accumulation of micro slip in the bearing seat leads to a macroscopic ring movement relative to the adjacent structure (housing or shaft), referred to as ring creep. One component in WT drivetrains that is prone to ring creep is the planet carrier bearing (PCB). Typically, the finite element method is used to predict ring creep within the analyzed subsystem. Recent research introduced a sub-modelling approach for simulative ring creep investigations of an exemplary WT main bearing reducing the calculation effort. In this work, the sub-modelling method is applied to PCB ring creep investigations. The method encompasses a global and a sub-model. First, the global model is used to calculate the rolling element forces and the deformation in the vicinity of the bearing seat considering the loads on and the stiffness of the investigated system. Second, the sub-model is reduced to the components bearing ring, axial supports and a section of the adjacent structure to minimize the computational effort by focusing on solving the frictional contact equations in the bearing seat. The sub-model enables sensitivity analysis of the contact parameters in the bearing seat with reduced computational effort. Using the sub-model of a WT PCB the significant influence of the coefficient of friction and the elastic slip tolerance on ring creep is observed and the opposing behavior of both ring creep mechanisms (structure and rolling element induced ring creep) can be demonstrated. Although structure-induced ring creep dominates, rolling element-induced ring creep is more strongly influenced by variations in the coefficient of friction. In addition, a significant increase in elastic slip tolerance can amplify rolling element-induced ring creep, leading to a reversal of the dominant mechanism.
A simplified mathematical model was developed to estimate wear in polymer bearings for industrial boom systems under sliding conditions. Based on the Archard wear equation, the approach considers load and sliding distance as the primary input parameters. The results indicate that the model is suitable for describing the steady-state wear behaviour of the investigated tribosystem, while further refinements are required to accurately capture the running-in phase.