Assembling and maintaining large arrays of individually addressable atoms is a key requirement for continued scaling of neutral-atom-based quantum computers and simulators. In this work, we demonstrate a new paradigm for assembly of atomic arrays, based on a synergistic combination of optical tweezers and cavity-enhanced optical lattices, and the incremental filling of a target array from a repetitively filled reservoir. In this protocol, the tweezers provide microscopic rearrangement of atoms, while the cavity-enhanced lattices enable the creation of large numbers of optical traps with sufficient depth for rapid low-loss imaging of atoms. We apply this protocol to demonstrate near-deterministic filling (99% per-site occupancy) of 1225-site arrays of optical traps. Because the reservoir is repeatedly filled with fresh atoms, the array can be maintained in a filled state indefinitely. We anticipate that this protocol will be compatible with mid-circuit reloading of atoms into a quantum processor, which will be a key capability for running large-scale error-corrected quantum computations whose durations exceed the lifetime of a single atom in the system.

Measurement-based quantum error correction relies on the ability to determine the state of a subset of qubits (ancillae) within a processor without revealing or disturbing the state of the remaining qubits. Among neutral-atom based platforms, a scalable, high-fidelity approach to mid-circuit measurement that retains the ancilla qubits in a state suitable for future operations has not yet been demonstrated. In this work, we perform imaging using a narrow-linewidth transition in an array of tweezer-confined $^{171}$Yb atoms to demonstrate nondestructive state-selective and site-selective detection. By applying site-specific light shifts, selected atoms within the array can be hidden from imaging light, which allows a subset of qubits to be measured while causing only percent-level errors on the remaining qubits. As a proof-of-principle demonstration of conditional operations based on the results of the mid-circuit measurements, and of our ability to reuse ancilla qubits, we perform conditional refilling of ancilla sites to correct for occasional atom loss, while maintaining the coherence of data qubits. Looking towards true continuous operation, we demonstrate loading of a magneto-optical trap with a minimal degree of qubit decoherence.

To date, the highest fidelity quantum logic gates between two qubits have been achieved with variations on the geometric-phase gate in trapped ions, with the two leading variants being the Molmer-Sorensen gate and the light-shift (LS) gate. Both of these approaches have their respective advantages and challenges. For example, the latter is technically simpler and is natively insensitive to optical phases, but it has not been made to work directly on a clock-state qubit. We present a new technique for implementing the LS gate that combines the best features of these two approaches: By using a small ($\sim {\rm MHz}$) detuning from a narrow (dipole-forbidden) optical transition, we are able to operate an LS gate directly on hyperfine clock states, achieving gate fidelities of $99.74(4)\%$ using modest laser power at visible wavelengths. Current gate infidelities appear to be dominated by technical noise, and theoretical modeling suggests a path towards gate fidelity above $99.99\%$.

We present a new and simplified two-qubit randomized benchmarking procedure that operates only in the symmetric subspace of a pair of qubits and is well suited for benchmarking trapped-ion systems. By performing benchmarking only in the symmetric subspace, we drastically reduce the experimental complexity, number of gates required, and run time. The protocol is demonstrated on trapped ions using collective single-qubit rotations and the Molmer-Sorenson (MS) interaction to estimate an entangling gate error of $2(1) \times 10^{-3}$. We analyze the expected errors in the MS gate and find that population remains mostly in the symmetric subspace. The errors that mix symmetric and anti-symmetric subspaces appear as leakage and we characterize them by combining our protocol with recently proposed leakage benchmarking. Generalizations and limitations of the protocol are also discussed.

Population leakage outside the qubit subspace presents a particularly harmful source of error that cannot be handled by standard error correction methods. Using a trapped $^{171}$Yb$+$ ion, we demonstrate an optical pumping scheme to suppress leakage errors in atomic hyperfine qubits. The selection rules and narrow linewidth of a quadrupole transition are used to selectively pump population out of leakage states and back into the qubit subspace. Each pumping cycle reduces the leakage population by a factor of $\sim3$, allowing for an exponential suppression in the number of cycles. We use interleaved randomized benchmarking on the qubit subspace to show that this pumping procedure has negligible side-effects on un-leaked qubits, bounding the induced qubit memory error by $\leq2.0(8)\times10^{-5}$ per cycle, and qubit population decay to $\leq1.4(3)\times10^{-7}$ per cycle. These results clear a major obstacle for implementations of quantum error correction and error mitigation protocols.

We investigate the effect of band-limited white Gaussian noise (BLWGN) on electromagnetically induced transparency (EIT) and Autler-Townes (AT) splitting, when performing atom-based continuous-wave (CW) radio-frequency (RF) electric (E) field strength measurements with Rydberg atoms in an atomic vapor. This EIT/AT-based E-field measurement approach is currently being investigated by several groups around the world as a means to develop a new International System of Units traceable RF E-field measurement technique. For this to be a useful technique, it is important to understand the influence of BLWGN. We perform EIT/AT based E-field experiments with BLWGN centered on the RF transition frequency and for the BLWGN blue-shifted and red-shifted relative to the RF transition frequency. The EIT signal can be severely distorted for certain noise conditions (bandwidth, center frequency, and noise power), hence altering the ability to accurately measure a CW RF E-field strength. We present a model to predict the line shifts and broadenings in the EIT signal in the presence of noise. This model includes AC Stark shifts and on resonance transitions associated with the noise source. The results of this model are compared to the experimental data, and we find very good agreement between the two.

Atoms form the basis of precise measurement for many quantities (time, acceleration, rotation, magnetic field, etc.). Measurements of microwave frequency electric fields by traditional methods (i.e. engineered antennas) have limited sensitivity and can be difficult to calibrate properly. Highly-excited (Rydberg) neutral atoms have very large electric-dipole moments and many dipole allowed transitions in the range of 1 - 500 GHz. It is possible to sensitively probe the electric field in this range using the combination of two quantum interference phenomena: electromagnetically induced transparency and the Autler-Townes effect. This technique allows for very sensitive field amplitude, polarization, and sub-wavelength imaging measurements. These quantities can be extracted by measuring properties of a probe laser beam as it passes through a warm rubidium vapor cell. Thus far, Rydberg microwave electrometry has relied upon the absorption of the probe laser. We report on our use of polarization rotation, which corresponds to the real part of the susceptibility, for measuring the properties of microwave frequency electric fields. Our simulations show that when a magnetic field is present and directed along the optical propagation direction a polarization rotation signal exists and can be used for microwave electrometry. One central advantage in using the polarization rotation signal rather than the absorption signal is that common mode laser noise is naturally eliminated leading to a potentially dramatic increase in signal-to-noise ratio.

Filtering unwanted light signals is critical to the operation of neutral atom quantum memories. The addition of a novel frequency filter increases the non-classical correlations and readout efficiency of our quantum memory by ≈ 35% [1].

Quantum networks provide conduits capable of transmitting quantum information that connect to nodes at remote locations where the quantum information can be stored or processed. Fiber-based transmission of quantum information over long distances may be achieved using quantum memory elements and quantum repeater protocols. However, atom-based quantum memories typically involve interactions with light fields outside the telecom window needed to minimize absorption in transmission by optical fibers. We report on progress towards a quantum memory based on the generation of 795 nm spontaneously emitted single photons by a write-laser beam interacting with a cold Rb-87 ensemble. The single photons are then frequency-converted into (out of) the telecomm band via difference (sum) frequency generation in a PPLN crystal. Finally, the atomic state is read out via the interaction of a read-pulse with the quantum memory. With such a system, it will be possible to realize a long-lived quantum memory that will allow transmission of quantum information over many kilometers with high fidelity, essential for a scalable, long-distance quantum network.

Enabling secure communication, unparalleled computing capabilities, and fundamental nonlocality physics exploration, the development of quantum repeaters is the key quantum information processing technology advance needed for implementing real world quantum networks beyond the laboratory environment. Currently, components exist for intra-laboratory quantum networks but no system exists for connecting distant ( 1 km ) quantum memories in the real world. We present a physics analysis of quantum repeater network designs for intracity optical fiber connections between nodes based on atomic memories and linear optics. Long distances will necessitate the use of (1) two-photon Hong-Ou-Mandel style interference between atomic ensembles for entanglement swapping, and (2) photonic qubit wavelength conversion between atomic emissions and photons at telecommunication wavelengths in fiber. We report on our experimental progress towards implementing A Quantum Network with Atoms and Photons (QNET-AP), a quantum repeater network test-bed, between the US Army Research Laboratory (ARL) and the Joint Quantum Institute (JQI) of the National Institute of Standards and Technology (NIST) and the University of Maryland (UMD).