In order to meet current and emerging needs for remote passive standoff detection of chemical agent threats, MIT Lincoln Laboratory has developed a Wide Area Chemical Sensor (WACS) testbed. A design study helped define the initial concept, guided by current standoff sensor mission requirements. Several variants of this initial design have since been proposed to target other applications within the defense community. The design relies on several enabling technologies required for successful implementation. The primary spectral component is a Wedged Interferometric Spectrometer (WIS) capable of imaging in the LWIR with spectral resolutions as narrow as 4 cm-1. A novel scanning optic will enhance the ability of this sensor to scan over large areas of concern with a compact, rugged design. In this paper, we shall discuss our design, development, and calibration process for this system as well as recent testbed measurements that validate the sensor concept.

The process of formulating a remote sensing instrument design from a set of observational requirements involves a series of trade studies during which judgments are made between available design options. The outcome of this process is a system architecture which drives the size, weight, power consumption, cost, and technological risk of the instrument. In this paper, a set of trade studies are described which guided the development of a baseline sensor design to provide vertical profiles (soundings) of atmospheric temperature and humidity from future Geostationary Operational Environmental Satellite (GOES) platforms. Detailed trade studies presented include the choice between an interferometric versus a dispersive spectrometer, the optical design of the IR interferometer and visible imaging channel, the optimization of the instrument spatial response, the selection of detector array materials, operating temperatures, and array size, the thermal design for detector and optics cooling, and the electronics required to process detected interferograms into spectral radiance. The trade study process was validated through simulations of the radiometric performance of the instrument, and through simulated retrievals of vertical profiles of atmospheric temperature and humidity. The flexibility of these system trades is emphasized, highlighting the differing outcomes that occur from this process as system requirements evolve. Observations are made with respect to the reliability and readiness of key technologies. The results of this study were disseminated to industry to assist their interpretation of, and responses to, system requirements provided by the U.S. Government.

Feasibility of a 3.5 m diameter, segmented, solid, exit window for a high-power laser beam director was investigated. Effects of laser heating, gravity, and differential pressure loads were analyzed. A design was found for which structural deflections and stresses were within allowable limits. The time-varying optical aberrations introduced by the window were less than 0.01 1.tm rms after removal of bias, tilt, and focus aberrations for two window materials. Static aberrations caused by differences in optical thickness of the finished window panels were found to be relatively large and potentially uncorrectable if common optical finishing tolerances were assumed. Three potential solutions for accommodating the optical thickness variations are discussed.