Portable quantum technologies require robust lightweight apparatus with superior performance. For techniques dependent upon high-vacuum environments, such as atom interferometers and atomic clocks, three-dimensional (3D) printing enables additional avenues to tailor in-vacuum gas propagation dynamics. We demonstrate intricate fine-scale surface patterning of 3D-printed vacuum components to increase the rate at which gas particles collide with the surface. By applying a nonevaporable getter coating for use as a surface pump, we show that the patterned surface pumps gas particles 3.8 times faster than equivalent flat areas. These patterns can be directly integrated into additively manufactured components, enabling application in close proximity to key experimental regions and contributing to overall mass reduction. We develop numerical simulations that show good agreement with this result and predict up to a tenfold increase in the pumping rate, for realistic surface structures. Our work has direct applications in enabling passively pumped portable quantum technologies but also establishes 3D printing as a powerful technique for the creation of optimized surface patterning to provide enhanced control over high-vacuum gas dynamics for a broad range of applications.

High precision measurements are essential to solve major scientific and technological challenges, from gravitational wave detection to healthcare diagnostics. Quantum sensing delivers greater precision, but an in-depth optimization of measurement procedures has been overlooked. Here, we present a systematic strategy for parameter estimation in the low-data limit that integrates experimental control parameters and natural symmetries. The method is guided by a Bayesian quantifier of precision gain, enabling adaptive optimization tailored to the experiment. We provide general expressions for optimal estimators for any parameter. The strategy's power is demonstrated in a quantum technology experiment, in which ultracold caesium atoms are confined in a micromachined hole in an optical fiber. We find a fivefold reduction in the fractional variance of the estimated parameter, compared to the standard measurement procedure. Equivalently, our strategy achieves a target precision with a third of the data points previously required. Such enhanced device performance and accelerated data collection will be essential for applications in quantum computing, communication, metrology, and the wider quantum technology sector.

This summary of the second Terrestrial Very-Long-Baseline Atom Interferometry (TVLBAI) Workshop provides a comprehensive overview of our meeting held in London in April 2024 (Second Terrestrial Very-Long-Baseline Atom Interferometry Workshop, Imperial College, April 2024), building on the initial discussions during the inaugural workshop held at CERN in March 2023 (First Terrestrial Very-Long-Baseline Atom Interferometry Workshop, CERN, March 2023). Like the summary of the first workshop (Abend et al. in AVS Quantum Sci. 6:024701, 2024), this document records a critical milestone for the international atom interferometry community. It documents our concerted efforts to evaluate progress, address emerging challenges, and refine strategic directions for future large-scale atom interferometry projects. Our commitment to collaboration is manifested by the integration of diverse expertise and the coordination of international resources, all aimed at advancing the frontiers of atom interferometry physics and technology, as set out in a Memorandum of Understanding signed by over 50 institutions (Memorandum of Understanding for the Terrestrial Very Long Baseline Atom Interferometer Study).

Light scalar fields, with double well potentials and direct matter couplings, undergo density driven phase transitions, leading to the formation of domain walls. Such theories could explain dark energy or dark matter or source the nanohertz gravitational-wave background. We describe an experiment that could be used to detect such domain walls in a laboratory environment, solving for the scalar field profile and showing how the domain wall affects the motion of a test particle. We find that, in currently unconstrained regions of parameter space, the domain walls leave detectable signatures. Published by the American Physical Society 2024

A promising route to testing quantum gravity in the laboratory is to look for gravitationally-induced entanglement (GIE) between two or more quantum matter systems. Proposals for such tests have principally used microsolid systems, with highly non-classical states, such as N00N states or highly-squeezed states. Here, we consider, for the first time, GIE between two atomic gas interferometers as a test of quantum gravity. We propose placing the two interferometers next to each other in parallel and looking for correlations in the number of atoms at the output ports as evidence of GIE and quantum gravity. GIE is possible without challenging macroscopic superposition states, such as N00N or Schr\"odinger cat states, and instead there can be just classical-like 'coherent' states of atoms. This requires the total mass of the atom interferometers to be on the Planck mass scale, and long integration times. However, with current state-of-the-art quantum squeezing in cold atoms, we argue that the mass scale can be reduced to approachable levels and detail how such a mass scale can be achieved in the near future.

Light scalar fields, with double well potentials and direct matter couplings, undergo density driven phase transitions, leading to the formation of domain walls. Such theories could explain dark energy, dark matter or source the nanoHz gravitational-wave background. We describe an experiment that could be used to detect such domain walls in a laboratory experiment, solving for the scalar field profile, and showing how the domain wall affects the motion of a test particle. We find that, in currently unconstrained regions of parameter space, the domain walls leave detectable signatures.

Hybrid quantum devices, incorporating both atoms and photons, are able to exploit the benefits of both systems. Compact, robust atom-photon interfaces will enable scalable architectures for quantum computing and quantum communication, as well as chip-scale sensors and single-photon sources. We demonstrate a new type of interface and show the interaction of cold cesium atoms with resonant photons. For this atoms are cooled in a magneto-optical trap, transferred to an optical dipole trap and positioned inside a transverse, 30 µm diameter through-hole in an optical fibre, created via laser micromachining. The intersection is orthogonal to the propagation direction of the light mode. We trap about 300 atoms at a temperature of 120µK. When the guided light is on resonance with the caesium D2 line, up to 87% of it is absorbed by the atoms. Our technique can be applied in 2-dimensional systems, i.e. in optical waveguide chips and other existing photonic systems. We also discuss the influence of hole shapes on transmission and prospects of adding a micro-cavity.

The association process of Feshbach molecules is well described by a Landau–Zener (LZ) transition above the Fermi temperature, such that two-body physics dominates the dynamics. However, using 6Li atoms and the associated Feshbach resonance at B r = 834.1 G, we observe an enhancement of the atom–molecule coupling as the fermionic atoms reach degeneracy, demonstrating the importance of many-body coherence not captured by the conventional LZ model. In the experiment, we apply a linear association ramp ranging from adiabatic to non-equilibrium molecule association for various temperatures. We develop a theoretical model that explains the temperature dependence of the atom–molecule coupling. Furthermore, we characterize this dependence experimentally and extract the atom–molecule coupling coefficient as a function of temperature, finding qualitative agreement between our model and experimental results. In addition, we simulate the dynamics of molecular association during a nonlinear field ramp. We find that, in the non-equilibrium regime, molecular association efficiency can be enhanced by sweeping the magnetic field cubically with time. Accurate measurement of the atom–molecule coupling coefficient is important for both theoretical and experimental studies of molecular association and many-body collective dynamics.

We demonstrate a miniaturised and highly robust system for performing Doppler-free spectroscopy on thermal atomic vapour for three frequencies as required for cold atom-based quantum technologies. The application of additive manufacturing techniques, together with efficient use of optical components, produce a compact, stable optical system, with a volume of 0.089 L and a weight of 120 g. The device occupies less than a tenth of the volume of, and is considerably lower cost than, conventional spectroscopic systems, but also offers excellent stability against environmental disturbances. We characterise the response of the system to changes in environmental temperature between 7 and 35 ∘C and exposure to vibrations between 0 - 2000 Hz, finding that the system can reliably perform spectroscopic measurements despite substantial vibrational noise and temperature changes. Our results show that 3D-printed optical systems are an excellent solution for portable quantum technologies.

We study magnetic Feshbach resonance of ultracold $^6$Li atoms in a dipole trap close to quantum degeneracy. The experiment is carried out by linearly ramping down the magnetic field from the BCS to the BEC side around the broad resonance at $B_r=834.1$G. The Feshbach molecule formation efficiency depends strongly on the temperature of the atomic gas and the rate at which the magnetic field is ramped across the Feshbach resonance. The molecular association process is well described by the Landau-Zener transition while above the Fermi temperature, such that two-body physics dominates the dynamics. However, we observe an enhancement of the atom-molecule coupling as the Fermionic atoms reach degeneracy, demonstrating the importance of many-body coherence not captured by the conventional Landau-Zener model. We develop a theoretical model that explains the temperature dependence of the atom-molecule coupling. Furthermore, we characterize this dependence experimentally and extract the atom-molecule coupling coefficient as a function of temperature, finding qualitative agreement between our model and experimental results. Accurate measurement of this coupling coefficient is important for both theoretical and experimental studies of atom-molecule association dynamics.

Hybrid quantum devices, incorporating both atoms and photons, can exploit the benefits of both to enable scalable architectures for quantum computing and quantum communication, as well as chip-scale sensors and single-photon sources. Production of such devices depends on the development of an interface between their atomic and photonic components. This should be compact, robust and compatible with existing technologies from both fields. Here we demonstrate such an interface. Cold cesium atoms are trapped inside a transverse, 30 $\mu$m diameter through-hole in an optical fiber, created via laser micromachining. When the guided light is on resonance with the cesium $D_2$ line, up to 87% of it is absorbed by the atoms. The corresponding optical depth per unit length is 700 cm$^{-1}$, higher than any reported for a comparable system. This is important for miniaturisation and scalability. The technique can be equally effective in optical waveguide chips and other existing photonic systems, providing a new platform for fundamental research.

We describe the design, construction and characterisation of a collimated, dual-species oven source for generating intense beams of lithium and caesium in UHV environments. Our design produces full beam overlap for the two species. Using an aligned microtube array the FWHM of the output beam is restricted to similar to 75 milliradians, with an estimated axial brightness of 3.6 x 10(14) atoms s(-1) sr(-1) for Li and 7.4 x 10(15) atoms s(-1) sr(-1) for Cs. We measure the properties of the output beam using a spatially-resolved fluorescence technique, which allows for the extraction of additional information not accessible without spatial resolution.

We apply modern techniques from quantum optics and quantum information science to Bose-Einstein condensates (BECs) in order to study, for the first time, the quantum decoherence of phonons of isolated BECs. In the last few years, major advances in the manipulation and control of phonons have highlighted their potential as carriers of quantum information in quantum technologies, particularly in quantum processing and quantum communication. Although most of these studies have focused on trapped ion and crystalline systems, another promising system that has remained relatively unexplored is BECs. The potential benefits in using this system have been emphasized recently with proposals of relativistic quantum devices that exploit quantum states of phonons in BECs to achieve, in principle, superior performance over standard non-relativistic devices. Quantum decoherence is often the limiting factor in the practical realization of quantum technologies, but here we show that quantum decoherence of phonons is not expected to heavily constrain the performance of these proposed relativistic quantum devices.

At the beginning of the previous century, Newtonian mechanics was advanced by two new revolutionary theories, Quantum Mechanics (QM) and General Relativity (GR). Both theories have transformed our view of physical phenomena, with QM accurately predicting the results of experiments taking place at small length scales, and GR correctly describing observations at larger length scales. However, despite the impressive predictive power of each theory in their respective regimes, their unification still remains unresolved. Theories and proposals for their unification exist but we are lacking experimental guidance towards the true unifying theory. Probing GR at small length scales where quantum effects become relevant is particularly problematic but recently there has been a growing interest in probing the opposite regime, QM at large scales where relativistic effects are important. This is principally because experimental techniques in quantum physics have developed rapidly in recent years with the promise of quantum technologies. Here we review recent advances in experimental and theoretical work on quantum experiments that will be able to probe relativistic effects of gravity on quantum properties. In particular, we emphasise the importance of using the framework of Quantum Field Theory in Curved Spacetime (QFTCS) in describing these experiments. For example, recent theoretical work using QFTCS has illustrated that these quantum experiments could also be used to enhance measurements of gravitational effects, such as Gravitational Waves (GWs). Verification of such enhancements, as well as other QFTCS predictions in quantum experiments, would provide the first direct validation of this limiting case of quantum gravity.

The UK National Quantum Technology Hub in Sensors and Metrology is one of four flagship initiatives in the UK National of Quantum Technology Program. As part of a 20-year vision it translates laboratory demonstrations to deployable practical devices, with game-changing miniaturized components and prototypes that transform the state-ofthe-art for quantum sensors and metrology. It brings together experts from the Universities of Birmingham, Glasgow, Nottingham, Southampton, Strathclyde and Sussex, NPL and currently links to over 15 leading international academic institutions and over 70 companies to build the supply chains and routes to market needed to bring 10–1000x improvements in sensing applications. It seeks, and is open to, additional partners for new application development and creates a point of easy open access to the facilities and supply chains that it stimulates or nurtures.

We investigate the flow of a one-dimensional nonlinear Schrodinger model with periodic boundary conditions past an obstacle, motivated by recent experiments with Bose--Einstein condensates in ring traps. Above certain rotation velocities, localized solutions with a nontrivial phase profile appear. In striking difference from the infinite domain, in this case there are many critical velocities. At each critical velocity, the steady flow solutions disappear in a saddle-center bifurcation. These interconnected branches of the bifurcation diagram lead to additions of circulation quanta to the phase of the associated solution. This, in turn, relates to the manifestation of persistent current in numerous recent experimental and theoretical works, the connections to which we touch upon. The complex dynamics of the identified waveforms and the instability of unstable solution branches are demonstrated.

We introduce a primary thermometer which measures the temperature of a Bose-Einstein Condensate in the sub-nK regime. We show, using quantum Fisher information, that the precision of our technique improves the state-of-the-art in thermometry in the sub-nK regime. The temperature of the condensate is mapped onto the quantum phase of an atomic dot that interacts with the system for short times. We show that the highest precision is achieved when the phase is dynamical rather than geometric and when it is detected through Ramsey interferometry. Standard techniques to determine the temperature of a condensate involve an indirect estimation through mean particle velocities made after releasing the condensate. In contrast to these destructive measurements, our method involves a negligible disturbance of the system.