This conference abstract is for a paper which discusses polymeric surface-enhanced resonance Raman scattering beads for ultra-sensitive analysis. It was presented at the 229th National Meeting of the American Chemical Society in 2005.
Polymers imprinted with clenbuterol were used to study the influence of various post-polymerization treatments [e.g., thermal annealing, microwave assisted extraction (MAE), Soxhlet extraction and supercritical fluid template desorption] on the bleeding of residual template. The aim of the study was to reduce the bleeding to levels that would allow the use of the materials as affinity phases for extraction of clenbuterol from bovine urine at concentrations below 1 ng ml-1. After treatment, the clenbuterol imprinted polymers were packed into solid-phase extraction columns and the bleeding was estimated by quantifying the amount of template released in 10 ml of methanol-acetic acid (9 + 1 v/v). This was followed by an assessment of selectivity and recovery in comparison with non-treated material. The lowest bleeding level was found after MAE using 100% trifluoroacetic acid for 3 x 20 min at 100 degrees C. The collected eluate contained in this case 3 ng ml-1 of clenbuterol. The same material was subsequently used for the extraction of clenbuterol from spiked bovine urine. The resulting selectivity and recovery were lower compared with those obtained using the untreated material. A milder but still efficient method to reduce the bleeding level was found to be MAE with formic acid. In this case a bleeding level of 14 ng ml-1 was found after only a 1 h extraction time. In a second model system, using a polymer imprinted with L-phenylalanine anilide, the bleeding was reduced to a similar level by extensive on-line washing in good swelling solvents containing acid or base additives and after thermal annealing of the polymers in the dry state.
Molecularly imprinted polymers (MIPs), for the templates free base racemic propranolol and the L-enantiomer of phenylalanine anilide (L-PA), were investigated as stationary phases in supercritical fluid chromatography (SFC). Large retention differences were observed on the propranolol MIP for both the template molecule and the structural analogue metoprolol compared to that observed on the corresponding blank polymer. Mobile phase composition and solute concentration were found to affect this retention behaviour. The phenylalanine anilide MIP (L-PA MIP) was found to be enantioselective in SFC with stronger retention observed for the template enantiomer. Throughout the study, characteristic imprinting peak shapes for the stronger retained template molecule were observed for both MIPs examined. After a number of days under supercritical fluid conditions, the performance of the photochemically initiated L-PA MIP was found to significantly deteriorate whereas the thermally initiated propranolol MIP revealed only small changes in its separation performance after a long term of operation. The separation behaviour of these two MIPs in SFC was compared with results obtained on the same columns in high-performance liquid chromatography (HPLC) both before and after their application in SFC.