An advanced multiwavelength polarization Raman lidar was operated aboard the icebreaker Polarstern during the MOSAiC (Multidisciplinary drifting Observatory for the Study of Arctic Climate) expedition to continuously monitor aerosol and cloud layers in the central Arctic up to 30 km height. The expedition lasted from September 2019 to October 2020 and measurements were mostly taken between 85 and 88.5∘ N. The lidar was integrated into a complex remote-sensing infrastructure aboard the Polarstern. In this article, novel lidar techniques, innovative concepts to study aerosol–cloud interaction in the Arctic, and unique MOSAiC findings will be presented. The highlight of the lidar measurements was the detection of a 10 km deep wildfire smoke layer over the North Pole region between 7–8 km and 17–18 km height with an aerosol optical thickness (AOT) at 532 nm of around 0.1 (in October–November 2019) and 0.05 from December to March. The dual-wavelength Raman lidar technique allowed us to unambiguously identify smoke as the dominating aerosol type in the aerosol layer in the upper troposphere and lower stratosphere (UTLS). An additional contribution to the 532 nm AOT by volcanic sulfate aerosol (Raikoke eruption) was estimated to always be lower than 15 %. The optical and microphysical properties of the UTLS smoke layer are presented in an accompanying paper (Ohneiser et al., 2021). This smoke event offered the unique opportunity to study the influence of organic aerosol particles (serving as ice-nucleating particles, INPs) on cirrus formation in the upper troposphere. An example of a closure study is presented to explain our concept of investigating aerosol–cloud interaction in this field. The smoke particles were obviously able to control the evolution of the cirrus system and caused low ice crystal number concentration. After the discussion of two typical Arctic haze events, we present a case study of the evolution of a long-lasting mixed-phase cloud layer embedded in Arctic haze in the free troposphere. The recently introduced dual-field-of-view polarization lidar technique was applied, for the first time, to mixed-phase cloud observations in order to determine the microphysical properties of the water droplets. The mixed-phase cloud closure experiment (based on combined lidar and radar observations) indicated that the observed aerosol levels controlled the number concentrations of nucleated droplets and ice crystals.

In this work we evaluate the possibilities to assess aerosol-cloud interactions in short time scales (2 min.) on an observational base. Retrievals of the cloud effective radius and number concentration in a liquid-water cloud by using the multiple scattering technique Dual-FOV Polarization lidar, together with the aerosol extinction coefficient in the boundary layer has shown a correspondence between the aerosol and cloud properties in the 6 hours case presented, obtaining a value of ACI N = 0.76 ± 0.29, which corroborates the potential of lidar observations to study the relation between aerosols and clouds on small scales.

In a companion article (Jimenez et al., 2020), we introduced a new lidar method to derive microphysical properties of liquid-water clouds (cloud extinction coefficient, droplet effective radius, liquid-water content, cloud droplet number concentration Nd) at a height of 50–100 m above the cloud base together with aerosol information (aerosol extinction coefficients, cloud condensation nuclei concentration NCCN) below the cloud layer so that detailed studies of the influence of given aerosol conditions on the evolution of liquid-water cloud layers with high temporal resolution solely based on lidar observations have become possible now. The novel cloud retrieval technique makes use of lidar observations of the volume linear depolarization ratio at two different receiver field of views (FOVs). In this article, Part 2, the new dual-FOV polarization lidar technique is applied to cloud measurements in pristine marine conditions at Punta Arenas in southern Chile. A multiwavelength polarization Raman lidar, upgraded by integrating a second polarization-sensitive channel to permit depolarization ratio observations at two FOVs, was used for these measurements at the southernmost tip of South America. Two case studies are presented to demonstrate the potential of the new lidar technique. Successful aerosol–cloud-interaction (ACI) studies based on measurements with the upgraded aerosol–cloud lidar in combination with a Doppler lidar of the vertical wind component could be carried out with 1 min temporal resolution at these pristine conditions. In a stratocumulus layer at the top of the convective boundary layer, we found values of Nd and NCCN (for 0.2 % water supersaturation) ranging from 15–100 and 75–200 cm−3, respectively, during updraft periods. The studies of the aerosol impact on cloud properties yielded ACI values close to 1. The impact of aerosol water uptake on the ACI studies was analyzed with the result that the highest ACI values were obtained when considering aerosol proxies (light-extinction coefficient αpar or NCCN) measured at heights about 500 m below the cloud base (and thus for dry aerosol conditions).

Abstract. An advanced multiwavelength polarization Raman lidar was operated aboard the icebreaker Polarstern during the MOSAiC (Multidisciplinary drifting Observatory for the Study of Arctic Climate) expedition, lasting from September 2019 to October 2020, to contiuously monitor aerosol and cloud layers in the Central Arctic up to 30 km height at latitudes mostly between 85° N and 88.5° N. The lidar was integrated in a complex remote sensing infrastructure aboard Polarstern. Modern aerosol lidar methods and new lidar techniques and concepts to explore aerosol-cloud interaction were applied for the first time in the Central Arctic. Aim of the introductory article is to provide an overview of the observational spectrum of the lidar products for representative measurement cases. Highlight of the lidar measurements was the detection of a 10 km deep wildfire smoke layer over the North Pole area from, on average, 7 km to 17 km height with an aerosol optical thickness (AOT) at 532 nm around 0.1 (in October–November 2019) and 0.05 from December to mid of March 2020. The wildfire smoke was trapped within the extraordinarily strong polar vortex and remained detectable until the beginning of May 2020. Arctic haze was also monitored and characterized in terms of backscatter, extinction, and extinction-to-backscatter ratio at 355 and 532 nm. High lidar ratios from 60–100 sr in lofted mixed haze and smoke plumes are indicative for the presence of strongly light-absorbing fine-mode particles. The AOT at 532 nm was of the order of 0.025 for the tropospheric haze layers. In addition, so-called cloud closure experiments were applied to Arctic mixed-phase cloud and cirrus observations. The good match between cloud condensation nucleus concentration (CCNC) and cloud droplet number concentration (CDNC) and, on the other hand, between ice-nucleating particle concentration (INPC) and ice crystal number concentration (ICNC) indicated a clear influence of aerosol particles on the evolution of the cloud systems. CDNC was mostly between 20 and 100 cm−3 in the liquid-water dominated cloud top layer. ICNC was of the order of 0.1–1 L−1. The study of the impact of wildfire smoke particles on cirrus formation revealed that heterogeneous ice formation with smoke particles (organic aerosol particles) as INPs may have prevailed. ICNC values of 10–40 L−1 were clearly below ICNC levels that would indicate homogeneous freezing.