Tandem organic solar cells (TOSCs) offer a promising route to surpassing the efficiency limits of single-junction devices, yet their performance remains constrained by interfacial losses at the charge recombination layer (CRL). Here, we report a chemically passivated polymeric CRL based on spontaneous in situ protonation-induced ionic self-assembly of amine-rich polyelectrolytes on PEDOT:PSS. This process forms a robust dipole layer that significantly reduces the work function of PEDOT:PSS, creating a favorable energetic alignment for charge recombination. Notably, temperature-dependent current-voltage analysis provides quantitative insight into interfacial energetics, revealing a near-zero or even negative effective barrier height (Phi B approximate to -28 meV) at the polymeric CRL interface. This result, which signifies a nearly ideal ohmic contact, stands in contrast to the substantial energy barrier (Phi B approximate to 33 meV) that impedes charge transport in conventional ZnO-based CRLs. As a result of the barrier-free recombination, homojunction TOSCs incorporating polymeric CRL yield a power conversion efficiency of over 18%, outperforming their ZnO-based counterparts. This work presents a versatile and scalable interfacial engineering strategy that harnesses in-situ chemical reactions to concurrently stabilize interfaces and tailor electronic properties, providing an effective pathway toward high-performance, reliable TOSCs.
Porous materials are widely used for sound absorption, yet accurately modeling their acoustic properties remains challenging. The widely adopted phenomenological models calculate equivalent density and bulk modulus based on macro material parameters (porosity, tortuosity, resistivity, etc.), usually obtained from estimated physical measurements or computer tomography (CT) images of samples. However, a fully computational simulation approach (i.e., no experiment is needed to estimate parameters) is desired, where the phenomenological macro parameters can be obtained and validated via micro-scale fluid dynamics models. In this work, we present an efficient procedure to construct detailed 3D geometry of porous materials based on CT images of a material sample. The microstructure information is extracted mainly using a watershed-based image segmentation technique. These high-fidelity geometries enable micro-scale fluid dynamics simulations, providing a virtual testbed. By comparing these micro-scale simulation results against predictions from equivalent continuum models, we can rigorously validate the phenomenological parameters. This multi-scale framework facilitates the fundamental understanding of material microstructures, enabling more accurate design and optimization of acoustic treatments for noise control applications in transportation and building systems.
In the automotive industry, it is essential to consider not only how well specialty materials perform and are formulated, but also how efficiently and economically they can be applied during manufacturing. This becomes especially important during the early stages of development to prevent issues when these materials are used in new designs by automotive suppliers or manufacturers. With the rapid growth of electric vehicles (EVs), new materials are being used more frequently, and these materials may not have been as thoroughly tested as those used in traditional internal combustion engine (ICE) vehicles. Therefore, it is crucial to ensure that these materials can be applied correctly and efficiently from the start. One way to speed up the development process is through Computational Fluid Dynamics (CFD) modeling. CFD helps predict how materials will behave when dispensed, which is essential for developing the right equipment and conditions for applying these materials. Working with Graco, a leading manufacturer of fluid management and dispense solutions, Dow and Graco have used these models to design better equipment solutions and improve the software used. This ensures high-quality and efficient application at start up. This paper will present two case studies how material models were developed, tested, and validated with real-world data to ensure they work as intended. The goal is to demonstrate how optimizing dispensing equipment based on material characteristics is critical for maintaining process windows and product quality. By doing so, manufacturers can achieve better results, reduce waste, and ensure the reliability of new materials in automotive applications.
With Ethernet-APL, IT/OT convergence is brought to a next level. High-speed communcation to field devices, elimination of complex infrastructure to extract data from the field, and simplified engineering and maintenance are key advantages. Yet, due to experiences with fieldbus technology, Ethernet-APL is considered as process industry’s last chance for digital field communication. This article presents key success factors. Furthermore, it summarizes the joint community effort by end users and vendors to prevent the repition of flaws experienced during the past fieldbus introduction.